EN ISO 9117-4:2012

Paints and varnishes - Drying tests - Part 4: Test using a mechanical recorder (ISO 9117-4:2012)

ISO 9117-4:2012 specifies a test for determining the times taken to reach various stages of drying of organic coatings, using a mechanical straight-line or circular drying-time recorder. The use of a mechanical recorder is valuable in comparing the drying behaviour of coatings of the same generic type, when one coating might form a gel at a faster rate than another or might resist scratching better than another. The test is intended to simulate the conditions which exist when painted articles are stacked upon each other.

Beschichtungsstoffe - Trocknungsprüfungen - Teil 4: Prüfung mit einem mechanischen Rekorder (ISO 9117-4:2012)

Dieser Teil von ISO 9117 legt ein Prüfverfahren fest, bei dem mit einem geradlinig oder kreisförmig
aufzeichnenden mechanischen Trocknungsrekorder die Zeiten aufgezeichnet werden, die eine organische
Beschichtung für unterschiedliche Trocknungsstufen benötigt. Die Anwendung eines mechanischen
Rekorders ist nützlich, um das Trocknungsverhalten von Beschichtungen des gleichen Grundtyps zu
vergleichen, wobei es sein kann, dass eine Beschichtung bei einer höheren Geschwindigkeit ein Gel bildet
oder widerstandsfähiger gegen Reißen ist als eine andere. Es ist beabsichtigt, dass das Verfahren die
Bedingungen simuliert, die beim Stapeln von beschichteten Gegenständen auftreten.

Peintures et vernis - Essais de séchage - Partie 4: Essai à l'aide d'un enregistreur mécanique (ISO 9117-4:2012)

L'ISO 9117-4:2012 spécifie un essai permettant de déterminer les temps nécessaires à des revêtements organiques pour atteindre différents stades de séchage en utilisant un enregistreur mécanique rectiligne ou circulaire des temps de séchage. L'utilisation d'un enregistreur mécanique est très utile pour comparer le comportement au séchage de revêtements du même type générique, qui fait qu'un revêtement peut former un gel plus rapidement qu'un autre ou peut mieux résister aux rayures qu'un autre. L'essai est destiné à simuler les conditions rencontrées lorsque des articles peints sont empilés les uns sur les autres.

Barve in laki - Preskusi sušenja - 4. del: Preskus z uporabo mehanskega postopka (ISO 9117-4:2012)

Ta del standarda ISO 9117 določa preskus za ugotavljanje časa, potrebnega za doseganje različnih stopenj sušenja organskih prevlek, z uporabo mehanskega premočrtnega ali krožnega postopka sušenja. Uporaba mehanskega postopka je koristna za primerjavo sušenja prevlek enakega generičnega tipa, kadar se lahko ena prevleka spremeni v gel hitreje kot druga ali je bolj odporna na praske kot druga. Preskus je namenjen simulaciji razmer, do katerih pride, kadar so prebarvani izdelki naloženi drug na drugega.

General Information

• Status: Published
• Publication Date: 14-Aug-2012
• Withdrawal Date: 27-Feb-2013
• ICS: 87.040 - Paints and varnishes
• Technical Committee: CEN/TC 139 - Paints and varnishes
• Drafting Committee: CEN/TC 139 - Paints and varnishes
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 15-Aug-2012
• Completion Date: 15-Aug-2012
• Ref Project: SIST EN ISO 9117-4:2012 - Paints and varnishes - Drying tests - Part 4: Test using a mechanical recorder (ISO 9117-4:2012)

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 9117-4:2012
01-oktober-2012
Barve in laki - Preskusi sušenja - 4. del: Preskus z uporabo mehanskega postopka
(ISO 9117-4:2012)
Paints and varnishes - Drying tests - Part 4: Test using a mechanical recorder (ISO 9117
-4:2012)
Beschichtungsstoffe - Trocknungsprüfungen - Teil 4: Verfarhen mit einem mechanischen
Rekorder (ISO 9117-4:2012)
Peintures et vernis - Essais de séchage - Partie 4: Essai à l'aide d'un enregistreur
mécanique (ISO 9117-4:2012)
Ta slovenski standard je istoveten z: EN ISO 9117-4:2012
ICS:
87.040 Barve in laki Paints and varnishes
SIST EN ISO 9117-4:2012 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 9117-4:2012

---------------------- Page: 2 ----------------------

SIST EN ISO 9117-4:2012


EUROPEAN STANDARD
EN ISO 9117-4

NORME EUROPÉENNE

EUROPÄISCHE NORM
August 2012
ICS 87.040
English Version
Paints and varnishes - Drying tests - Part 4: Test using a
mechanical recorder (ISO 9117-4:2012)
Peintures et vernis - Essais de séchage - Partie 4: Essai à Beschichtungsstoffe - Trocknungsprüfungen - Teil 4:
l'aide d'un enregistreur mécanique (ISO 9117-4:2012) Prüfung mit einem mechanischen Rekorder (ISO 9117-
4:2012)
This European Standard was approved by CEN on 14 August 2012.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 9117-4:2012: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 9117-4:2012
EN ISO 9117-4:2012 (E)
Contents Page
Foreword .3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 9117-4:2012
EN ISO 9117-4:2012 (E)
Foreword
This document (EN ISO 9117-4:2012) has been prepared by Technical Committee ISO/TC 35 "Paints and
varnishes" in collaboration with Technical Committee CEN/TC 139 “Paints and varnishes” the secretariat of
which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by February 2013, and conflicting national standards shall be withdrawn
at the latest by February 2013.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
According to the CEN/CENELEC Internal Regulations, the national standards organisations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 9117-4:2012 has been approved by CEN as a EN ISO 9117-4:2012 without any modification.

3

---------------------- Page: 5 ----------------------

SIST EN ISO 9117-4:2012

---------------------- Page: 6 ----------------------

SIST EN ISO 9117-4:2012
INTERNATIONAL ISO
STANDARD 9117-4
First edition
2012-08-15
Paints and varnishes — Drying tests —
Part 4:
Test using a mechanical recorder
Peintures et vernis — Essais de séchage —
Partie 4: Essai à l’aide d’un enregistreur mécanique
Reference number
ISO 911
...