EN 16105:2023

Paints and varnishes - Laboratory method for determination of release of regulated dangerous substances from coatings in intermittent contact with water

This document specifies a laboratory method to determine the leaching behaviour of substances from coatings into water over defined time intervals.
The release of substances from coatings under natural conditions cannot be determined with this method.
This method can be applied to renders, when condition (4) of the Scope of CEN/TS 16637-1 is fulfilled.
(4) It is assumed that intermittent contact with water (e.g. exposure to rainwater) is tested — by convention — as permanent contact. For some coatings, (e.g. some renders with organic binders according to EN 15824) in intermittent contact to water, physical and chemical properties might be altered in permanent contact with water. These products are not covered by the Technical Specification CEN/TS 16637-1 since the test method in CEN/TS 16637-2 is not appropriate for these construction products.

Beschichtungsstoffe - Laborverfahren zur Bestimmung der Freisetzung von Substanzen aus Beschichtungen in intermittierendem Kontakt mit Wasser

Dieses Dokument legt ein Laborverfahren fest, mit dem das Auswaschverhalten von Substanzen aus Beschichtungen ins Wasser innerhalb definierter Zeitintervalle bestimmt werden kann.
Das Verfahren ist für die Bestimmung des Auswaschens von Substanzen aus Beschichtungen unter natürlichen Bedingungen nicht anwendbar.
Dieses Verfahren kann für Putze angewendet werden, wenn die Bedingung (4) im Anwendungsbereich von CEN/TS 16637 1 erfüllt ist.
(4) Es wird angenommen, dass der zeitweilige Kontakt mit Wasser (zum Beispiel Beanspruchung durch Regenwasser) nach Vereinbarung als dauerhafter Kontakt geprüft wird. Bei einigen Beschichtungen (zum Beispiel einige Putze mit organischen Bindemitteln nach EN 15824), die zeitweilig mit Wasser in Berührung kommen, könnten sich bei dauerhaftem Kontakt mit Wasser physikalische und chemische Eigenschaften verändern. Diese Produkte werden nicht durch die Technische Spezifikation CEN/TS 16637 1 abgedeckt, da das Prüfverfahren in CEN/TS 16637 2 für diese Bauprodukte nicht geeignet ist.

Peintures et vernis - Méthode de laboratoire pour la détermination de la libération de substances dangereuses réglementées provenant de revêtements en contact avec l’eau par intermittence

Le présent document spécifie une méthode de laboratoire visant à déterminer le comportement à la lixiviation par l’eau des substances contenues dans les revêtements sur des intervalles de temps spécifiés.
La libération de substances depuis les revêtements dans des conditions naturelles ne peut pas être déterminée à l’aide de la présente méthode.
Cette méthode peut être appliquée aux enduits, lorsque la condition (4) du domaine d’application de la spécification technique CEN/TS 16637-1 est remplie.
(4) Il est supposé qu’un contact avec l’eau par intermittence (par exemple une exposition à l’eau de pluie) est soumis à essai — par convention — comme un contact permanent. Pour certains revêtements (par exemple certains enduits à base de liants organiques conformément à l’EN 15824) en contact avec l’eau par intermittence, les propriétés physiques et chimiques pourraient être altérées par un contact permanent avec l’eau. Ces produits ne sont pas couverts par la spécification technique CEN/TS 16637-1 car la méthode d’essai décrite dans la CEN/TS 16637-2 n’est pas appropriée pour ces produits de construction.

Barve in laki - Laboratorijska metoda za ugotavljanje sproščanja reguliranih nevarnih snovi iz premazov ob občasnem stiku z vodo

Ta evropski standard določa laboratorijsko metodo za določanje izluževanja snovi s prevlek v vodi v določenih časovnih intervalih.
S to metodo ni mogoče določiti sproščanja snovi s prevlek pod naravnimi pogoji.

General Information

• Status: Published
• Publication Date: 24-Jan-2023
• ICS: 87.040 - Paints and varnishes
• Technical Committee: CEN/TC 139 - Paints and varnishes
• Drafting Committee: CEN/TC 139/WG 10 - Laboratory methods for testing the efficacy of film preservatives according tothe requirements of the biocide product directive (BPD)
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 25-Jan-2023
• Due Date: 16-Dec-2022
• Completion Date: 25-Jan-2023
• Ref Project: SIST EN 16105:2023 - Paints and varnishes - Laboratory method for determination of release of regulated dangerous substances from coatings in intermittent contact with water

Relations

• Replaces: EN 16105:2011 - Paints and varnishes - Laboratory method for determination of release of substances from coatings in intermittent contact with water
• Effective Date: 04-Nov-2020

Standards Content (Sample)

SLOVENSKI STANDARD
oSIST prEN 16105:2021
01-april-2021
Barve in laki - Laboratorijska metoda za ugotavljanje sproščanja snovi iz
premazov ob občasnem stiku z vodo
Paints and varnishes - Laboratory method for determination of release of substances
from coatings in intermittent contact with water
Beschichtungsstoffe - Laborverfahren zur Bestimmung der Freisetzung von Substanzen
aus Beschichtungen in intermittierendem Kontakt mit Wasser
Peintures et vernis - Méthode de laboratoire pour la détermination de la libération de
substances provenant de revêtements en contact avec l'eau par intermittence
Ta slovenski standard je istoveten z: prEN 16105
ICS:
87.040 Barve in laki Paints and varnishes
oSIST prEN 16105:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 16105:2021

---------------------- Page: 2 ----------------------
oSIST prEN 16105:2021


DRAFT
EUROPEAN STANDARD
prEN 16105
NORME EUROPÉENNE

EUROPÄISCHE NORM

April 2021
ICS 87.040 Will supersede EN 16105:2011
English Version

Paints and varnishes - Laboratory method for
determination of release of regulated dangerous
substances from coatings in intermittent contact with
water
Peintures et vernis - Méthode de laboratoire pour la Beschichtungsstoffe - Laborverfahren zur Bestimmung
détermination de la libération de substances der Freisetzung von Substanzen aus Beschichtungen in
provenant de revêtements en contact avec l'eau par intermittierendem Kontakt mit Wasser
intermittence
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 139.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16105:2021 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 16105:2021
prEN 16105:2021 (E)
Contents Page
Foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Reagents . 7
5 Apparatus . 7
5.1 General . 7
5.2 Equipment .
...

SLOVENSKI STANDARD
SIST EN 16105:2023
01-maj-2023
Nadomešča:
SIST EN 16105:2011
Barve in laki - Laboratorijska metoda za ugotavljanje sproščanja reguliranih
nevarnih snovi iz premazov ob občasnem stiku z vodo
Paints and varnishes - Laboratory method for determination of release of regulated
dangerous substances from coatings in intermittent contact with water
Beschichtungsstoffe - Laborverfahren zur Bestimmung der Freisetzung von Substanzen
aus Beschichtungen in intermittierendem Kontakt mit Wasser
Peintures et vernis - Méthode de laboratoire pour la détermination de la libération de
substances dangereuses réglementées provenant de revêtements en contact avec l’eau
par intermittence
Ta slovenski standard je istoveten z: EN 16105:2023
ICS:
87.040 Barve in laki Paints and varnishes
SIST EN 16105:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 16105:2023

---------------------- Page: 2 ----------------------
SIST EN 16105:2023


EN 16105
EUROPEAN STANDARD

NORME EUROPÉENNE

January 2023
EUROPÄISCHE NORM
ICS 87.040 Supersedes EN 16105:2011
English Version

Paints and varnishes - Laboratory method for
determination of release of regulated dangerous
substances from coatings in intermittent contact with
water
Peintures et vernis - Méthode de laboratoire pour la Beschichtungsstoffe - Laborverfahren zur Bestimmung
détermination de la libération de substances der Freisetzung von Substanzen aus Beschichtungen in
dangereuses réglementées provenant de revêtements intermittierendem Kontakt mit Wasser
en contact avec l'eau par intermittence
This European Standard was approved by CEN on 25 December 2022.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 16105:2023 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN 16105:2023
EN 16105:2023 (E)
Contents Page
European Foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Reagents . 7
5 Apparatus . 7
5.1 General . 7
5.2 Equipment . 7
6 Test procedure . 8
6.1 General considerations .
...