EN 13938-2:2004

Explosives for civil uses - Propellants and rocket propellants - Part 2: Determination of resistance to electrostatic energy

This document specifies a method for the determination of resistance to electrostatic energy for propellants containing a mass fraction of at least 5 % of particles which pass through a 1 mm sieve. This method does not apply to black powder.
NOTE: If the mass fraction of particles smaller than 1 mm size is less than 5 % the propellant is considered to be insensitive to electrostatic energy and this test is not performed.

Explosivstoffe für zivile Zwecke - Treibladungspulver und Raketentreibstoffe - Teil 2: Bestimmung der Widerstandsfähigkeit gegen elektrostatische Energie

Dieses Dokument legt ein Verfahren zur Bestimmung der Widerstandsfähigkeit gegen elektrostatische
Energie für Treibladungspulver fest, die einen Masseanteil an Teilchen, die durch ein 1-mm-Sieb hindurch-
gehen, von mindestens 5 % haben. Dieses Verfahren gilt nicht für Schwarzpulver.
ANMERKUNG Wenn der Masseanteil der Teilchen, die kleiner als 1 mm sind, geringer als 5 % ist, wird das Treib-
ladungspulver als unempfindlich gegenüber elektrostatischer Energie betrachtet und das Prüfverfahren braucht nicht
durchgeführt werden.

Explosifs à usage civil - Poudres propulsives et propergols pour fusées - Partie 2 : Détermination de la résistance à l'énergie électrostatique

Le présent document spécifie une méthode de détermination de la résistance à l'énergie électrostatique des poudres propulsives contenant une fraction de masse d'au moins 5 % de particules passant à travers un tamis de 1 mm. La présente méthode ne s'applique pas à la poudre noire.
NOTE   Si la fraction de masse des particules de taille inférieure à 1 mm est inférieure à 5 %, la poudre propulsive est considérée insensible à l'énergie électrostatique et il n'est pas nécessaire de réaliser une détermination avec cette méthode.

Eksplozivi za civilno uporabo - Smodniki in raketna goriva - 2. del: Določevanje odpornosti proti elektrostatični energiji

General Information

• Status: Published
• Publication Date: 26-Oct-2004
• Withdrawal Date: 29-Apr-2005
• ICS: 71.100.30 - Explosives. Pyrotechnics and fireworks
• Technical Committee: CEN/TC 321 - Explosives for civil uses
• Drafting Committee: CEN/TC 321/WG 5 - Propellants
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 30-Jul-2015
• Directive: 2014/28/EU - Directive 2014/28/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market and supervision of explosives for civil uses
• Directive: 93/15/EEC - Council Directive 93/15/EEC of 5 April 1993 on the harmonization of the provisions relating to the placing on the market and supervision of explosives for civil uses
• Mandate: M/055 - Standardization mandate to CEN for explosives for civil uses
• Ref Project: SIST EN 13938-2:2005 - Explosives for civil uses - Propellants and rocket propellants - Part 2: Determination of resistance to electrostatic energy

Relations

• Revised: FprEN 13938-2 - Explosives for civil uses - Propellants and rocket propellants - Part 2: Determination of resistance to electrostatic discharge
• Effective Date: 23-Oct-2019

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Explosives for civil uses - Propellants and rocket propellants - Part 2: Determination of resistance to electrostatic energyExplosifs a usage civil - Poudres propulsives et propergols pour fusées - Partie 2 : Détermination de la résistance a l'énergie électrostatiqueExplosivstoffe für zivile Zwecke - Treibladungspulver und Raketentreibstoffe - Teil 2: Bestimmung der Widerstandsfähigkeit gegen elektrostatische EnergieTa slovenski standard je istoveten z:EN 13938-2:2004SIST EN 13938-2:2005en71.100.30ICS:SLOVENSKI
STANDARDSIST EN 13938-2:200501-februar-2005







EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 13938-2October 2004ICS 71.100.30 English versionExplosives for civil uses - Propellants and rocket propellants -Part 2: Determination of resistance to electrostatic energyExplosif à usage civil - Poudre propulsive et propergol pourfusée - Partie 2 : Détermination de la résistance à l'énergieélectrostatiqueExplosivstoffe für zivile Zwecke - Treibladungspulver undRaketentreibstoffe - Teil 2: Bestimmung derWiderstandsfähigkeit gegen elektrostatische EnergieThis European Standard was approved by CEN on 23 August 2004.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Central Secretariat or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2004 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 13938-2:2004: E



EN 13938-2:2004 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Terms and definitions.4 4 Apparatus.4 5 Preparation of test sample.5 6 Procedure.5 7 Test report.5 Annex A (informative)
Range of applicability of the test method.8 Annex B (normative)
Sieving method.9 Annex C (normative)
Calibrating procedure for electrostatic discharge generator.10 C.1 General.10 C.2 Device to be tested.10 C.3 Apparatus.10 C.4 Procedure.11 C.4.1 Voltage and capacitor calibration.
...