EN ISO 15181-1:2004

Paints and varnishes - Determination of release rate of biocides from antifouling paints - Part 1: General method for extraction of biocides (ISO 15181-1:2000)

Specification of a general method for extracting biocides from paint films of antifouling paints into a specified artificial seawater under specified conditions.

Beschichtungsstoffe - Bestimmung der Auswaschrate von Bioziden aus Antifouling-Beschichtungen - Teil 1: Allgemeines Verfahren zur Extraktion von Bioziden (ISO 15181-1:2000)

Peintures et vernis - Détermination du taux de lixiviation des biocides contenus dans la peinture antisalissure - Partie 1: Méthode générale d'extraction des biocides (ISO 15181-1:2000)

Barve in laki - Določanje razmerja sproščanja biocidov iz barv proti obraščanju - 1. del: Splošna metoda za ekstrakcijo biocidov (ISO 15181-1:2000)

General Information

• Status: Withdrawn
• Publication Date: 25-May-2004
• Withdrawal Date: 31-May-2007
• ICS: 87.040 - Paints and varnishes
• Technical Committee: CEN/TC 139 - Paints and varnishes
• Drafting Committee: CEN/TC 139 - Paints and varnishes
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 01-Jun-2007
• Completion Date: 01-Jun-2007
• Ref Project: SIST EN ISO 15181-1:2004 - Paints and varnishes - Determination of release rate of biocides from antifouling paints - Part 1: General method for extraction of biocides (ISO 15181-1:2000)

Relations

• Replaced By: EN ISO 15181-1:2007 - Paints and varnishes - Determination of release rate of biocides from antifouling paints - Part 1: General method for extraction of biocides (ISO 15181-1:2007)
• Effective Date: 22-Dec-2008

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 15181-1:2004
01-julij-2004
%DUYHLQODNL'RORþDQMHUD]PHUMDVSURãþDQMDELRFLGRYL]EDUYSURWLREUDãþDQMX
GHO6SORãQDPHWRGD]DHNVWUDNFLMRELRFLGRY,62
Paints and varnishes - Determination of release rate of biocides from antifouling paints -
Part 1: General method for extraction of biocides (ISO 15181-1:2000)
Beschichtungsstoffe - Bestimmung der Auswaschrate von Bioziden aus Antifouling-
Beschichtungen - Teil 1: Allgemeines Verfahren zur Extraktion von Bioziden (ISO 15181-
1:2000)
Peintures et vernis - Détermination du taux de lixiviation des biocides contenus dans la
peinture antisalissure - Partie 1: Méthode générale d'extraction des biocides (ISO 15181-
1:2000)
Ta slovenski standard je istoveten z: EN ISO 15181-1:2004
ICS:
87.040 Barve in laki Paints and varnishes
SIST EN ISO 15181-1:2004 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

INTERNATIONAL ISO
STANDARD 15181-1
First edition
2000-11-15
Paints and varnishes — Determination of
release rate of biocides from antifouling
paints —
Part 1:
General method for extraction of biocides
Peintures et vernis — Détermination du taux de lixiviation des biocides
contenus dans la peinture antisalissure —
Partie 1: Méthode générale d'extraction des biocides
Reference number
ISO 15181-1:2000(E)
© ISO 2000

---------------------- Page: 2 ----------------------

ISO 15181-1:2000(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be
edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file,
parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2000
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, elec-
tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem-
ber body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.ch
Printed in Switzerland
©
ii ISO 2000 – All rights reserved

---------------------- Page: 3 ----------------------

ISO 15181-1:2000(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical com-
mittees. Each member body interested in a subject for which a technical committee has been established has the
right to be represented on that committee. International organizations, governmental and non-governmental, in liai-
son with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission
(IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this part of ISO 15181 may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 15181-1 was prepared by Technical Committee ISO/TC 35, Paints and varnishes,Sub-
committee SC 9, General test methods for paints and varnishes.
ISO 15181 consists of the following parts, under the general title Paints and varnishes — Determination of release
rate of biocides from antifouling paints:
— Part 1: General method for extraction of biocides
— Part 2: Determination of copper-ion concentration in the extract and calculation of the release rate
Annex A forms a normative part of this part of ISO 15181.
©
ISO 2000 – All rights reserved iii

---------------------- Page: 4 ----------------------

ISO 15181-1:2000(E)
Introduction
By using standard conditions of temperature, salinity and pH at low biocide concentrations in the surround
...