EN 613:2000/A1:2003
(Amendment)Independent gas-fired convection heaters
Independent gas-fired convection heaters
To include: Updated references; technical changes resulting from deferred technical comments made prior Formal Vote.
Konvektions-Raumheizer für gasförmige Brennstoffe
Folgende Verweisung wie folgt ändern:
Das Datum «1991» ist nach EN 161 zu streichen.
Folgende Verweisung hinzufügen:
"EN 50165 Elektrische Ausrüstung von nicht-elektrischen Geräten für den Hausgebrauch und ähnliche Zwecke - Sicherheitsanforderungen"
Umpositionierung und Änderung bei EN 23166:1993 folgendermaßen:
"EN ISO 3166-1:1997 Codes für die Namen von Ländern und deren Untereinheiten - Teil 1: Codes für Ländernamen (ISO 3166-1:1997)"
Appareils de chauffage indépendants à convection utilisant les combustibles gazeux
Prostostoječi plinski konvekcijski grelniki - Dopolnilo A1
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-januar-2004
3URVWRVWRMHþLSOLQVNLNRQYHNFLMVNLJUHOQLNL'RSROQLOR$
Independent gas-fired convection heaters
Konvektions-Raumheizer für gasförmige Brennstoffe
Appareils de chauffage indépendants a convection utilisant les combustibles gazeux
Ta slovenski standard je istoveten z: EN 613:2000/A1:2003
ICS:
97.100.20
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 613:2000/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2003
ICS 97.100.20
English version
Independent gas-fired convection heaters
Appareils de chauffage indépendants à convection utilisant Konvektions - Raumheizer für gasförmige Brennstoffe
les combustibles gazeux
This amendment A1 modifies the European Standard EN 613:2000; it was approved by CEN on 7 February 2003.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2003 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 613:2000/A1:2003 E
worldwide for CEN national Members.
Foreword
This document (EN 613:2000/A1:2003) has been prepared by Technical Committee CEN /TC 62 "Independent
gas-fired space heaters", the secretariat of which is held by BSI.
This Amendment to the European Standard EN 613:2000 shall be given the status of a national standard, either by
publication of an identical text or by endorsement, at the latest by October 2003, and conflicting national standards
shall be withdrawn at the latest by October 2003.
This document has been prepared under a mandate given to CEN by the European Commission and the European
Free Trade Association, and supports essential requirements of EU Directive(s).
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal,
Slovakia, Spain, Sweden, Switzerland and the United Kingdom.
1 Clause 2 Normative references
Amend the following:
Delete the date «1991» after EN 161.
Include the following references:
EN 50165 Electrical equipment of non-electric appliances for household and similar
purposes – Safety requirements.'
Reposition and amend EN 23166: 1993 to read as follows:
EN ISO 3166-1:1997 Codes for the representation of names of countries and their subdivisions -
Part 1: Country Codes (ISO 3166-1:1997).
2 Clause 5 Constructional requirements
5.1.3 Accessibility for use and maintenance
Replace the second paragraph by:
‘Removable parts shall be so designed or marked that they are easy to reassemble correctly according to the
manufacturer's instructions and any incorrect assembly shall be obvious.’
5.1.7.2 Type B appliances
Replace the third paragraph by:
‘It shall be possible to insert into the socket, or adaptor, a pipe, with an outside diameter of (D - 2) mm, for a
distance of at least equal to:
a) 30 mm for a horizontal connection,
b) 15 mm for a vertical connection,
but it shall be impossible to insert it to such a depth that the evacuation of the products of combustion is
impaired.
NOTE: Where D is the nominal internal diameter of the appliance outlet.
5.1.8 Electrical equipment
Replace the first paragraph with the following:
' The electrical equipment of the appliance shall be so designed and constructed as to obviate hazards of an
electrical origin. The appliance shall comply with the requirements of EN 50165 which covers such hazards.'
Second paragraph shall be deleted.
5.1.9 Safety in the event of fluctuation, interruption and restoration of the auxiliary energy
Replace the first paragraph by:
‘5.1.9.1 Interruption and restoration
'When interruption and subsequent restoration affects safety, then interruption and subsequent restoration of
the electricity supply at any time during the starting up or operation of the appliance shall result in either safety
shutdown, or, the appliance shall comply with 6.5.3.’
The second paragraph shall be entitled as follows:
‘5.1.9.2 Fluctuation’
5.2.2 Gas rate adjusters
The fourth paragraph shall be replaced by:
'Appliances in categories I , I , I , I I I I , II II , II II , II II II and II shall
2H, 2L 2E 2E+, 3B/P, 3P, 3+ 2H3B/P, 2H3+ 2H3P, 2L3P 2L3B/P, 2E3B/P, 2E+3+ 2E+3P
not be fitted with gas rate adjusters. However governed appliances in all of these categories except category I ,
2E+
and II may have a gas rate adjuster consisting of an adjusting screw on the gas governor.'
2E+3+
Delete the date “1991” after EN 161.
5.2.4.3 Automatic valve systems
Delete the date "1991" after EN 161
5.5 Burners
Include the following text as a new first paragraph:
‘Every removable injector and/or removable restrictor shall carry an indelible means of identification preventing any
confusion.’
5.6 Motors and fans
Delete clause.
5.7 Gas pressure test points
Replace by:
'5.6 Gas pressure test points’
3 Clause 6 Operational requirements
6.7.1 CO concentration for all appliances
Replace the text of indent b)’ by:
‘0,2 % when the appliance is supplied with the incomplete combustion limit gas under the test conditions
described in 7.7.2.2, and, under all test conditions described in 7.7.3, excluding 7.7.3.1 a), including the
arithmetic mean calculated as given in 7.7.3.3.’
6.11 Efficiency
Replace Table 4 with the following Table:
Table 4 - Efficiency
Efficiency Minimum net Minimum net
Class a a
Efficiency for appliances of Efficiency for appliances of
b
heat input greater than 5 kW heat input less than or equal to
b
5 kW
a a
182 %80 %
a a
265 % 65 %
a
The efficiency value based on gross calorific value is related to the net value for the five reference
gases as follows:
G 110 net value = 0,880 x gross value
G 120 net value = 0,882 x gross value
G 20 net value = 0,900 x gross value
G 25 net value = 0,901 x gross value
G 30 net value = 0,923 x gross value
b
The heat input based on gross calorific value is related to the net value for the five reference gases
as follows:
G 110
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.