Furniture - Bunk beds and high beds for domestic use - Part 2: Test methods

This part of EN 747 specifies test methods for assessing the safety, strength and durability of bunk beds and high beds for domestic use. The loads and forces in the strength and durability tests apply for beds with a maximum bed base width of 120 cm. It is particularly intended to minimise the risk of accidents happening to children. Only the sleeping function is considered.
The tests are designed to be applied to a free-standing bed that is fully assembled and ready for use.
The test results are only valid for the article tested. When the test results are to be applied to other similar articles, the test sample shall be representative of the production model.

Möbel - Etagenbetten und Hochbetten für den Wohnbereich - Teil 2: Prüfverfahren

Dieser Teil der EN 747 legt Prüfverfahren zur Beurteilung der Sicherheit, Festigkeit und Dauerhaltbarkeit von Etagenbetten und Hochbetten im Wohnbereich fest. Die für die Festigkeits  und Dauerhaltbarkeitsprüfungen festgelegten Belastungen und Kräfte gelten für Betten mit einer maximalen Breite des Bettbodens von 120 cm.
Es ist insbesondere beabsichtigt, die Unfallgefahr für Kinder auf ein Mindestmaß zu reduzieren. Nur die Funktion des Schlafens wird berücksichtigt.
Die Prüfungen sind an einem freistehenden, vollständig zusammengebauten und gebrauchsfertigen Etagenbett oder Hochbett durchzuführen.
Die Prüfergebnisse gelten nur für den geprüften Gegenstand. Falls die Prüfergebnisse auf andere, gleichartige Gegenstände angewendet werden sollen, muss das Prüfmuster repräsentativ für das Produktionsmodell sein.

Meubles - Lits superposés et lits surélevés à usage domestique - Partie 2 : Méthodes d'essai

La présente partie de l’EN 747 spécifie des méthodes d’essai pour évaluer la sécurité, la résistance et la durabilité des lits superposés et des lits surélevés à usage domestique. Les charges et forces spécifiées dans les essais de résistance et de durabilité s’appliquent aux lits ayant un sommier d’une largeur maximum de 120 cm. Elle est en particulier destinée à réduire les risques d’accidents d’enfants. Seule la fonction couchage est considérée.
Les essais sont conçus pour être appliqués à un lit posé au sol entièrement assemblé et prêt à l’emploi.
Les résultats d’essai ne sont valables que pour l’article soumis à l’essai. Lorsque les résultats d’essais sont destinés à être appliqués à d’autres articles similaires, l’échantillon doit être représentatif du modèle de production.

Pohištvo - Pogradi in visoke postelje za domačo uporabo - 2. del: Preskusne metode

General Information

Status
Withdrawn
Publication Date
17-Apr-2007
Withdrawal Date
17-Apr-2012
Technical Committee
Current Stage
9960 - Withdrawal effective - Withdrawal
Start Date
18-Apr-2012
Completion Date
18-Apr-2012

Relations

Buy Standard

Standard
EN 747-2:2007
English language
16 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
O prEN 747-2:2004
English language
16 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 747-2:2007
01-september-2007
1DGRPHãþD
SIST EN 747-2:1996
3RKLãWYR3RJUDGLLQYLVRNHSRVWHOMH]DGRPDþRXSRUDERGHO3UHVNXVQH
PHWRGH
Furniture - Bunk beds and high beds for domestic use - Part 2: Test methods
Möbel - Etagenbetten und Hochbetten für den Wohnbereich - Teil 2: Prüfverfahren
Ameublement - Lits superposés et lits surélevés a usage domestique - Partie 2 :
Méthodes d'essai
Ta slovenski standard je istoveten z: EN 747-2:2007
ICS:
97.140 Pohištvo Furniture
SIST EN 747-2:2007 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

EUROPEAN STANDARD
EN 747-2
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2007
ICS 97.140 Supersedes EN 747-2:1993
English Version
Furniture - Bunk beds and high beds for domestic use - Part 2:
Test methods
Ameublement - Lits superposés et lits surélevés à usage Möbel - Etagenbetten und Hochbetten für den Wohnbereich
domestique - Partie 2 : Méthodes d'essai - Teil 2: Prüfverfahren
This European Standard was approved by CEN on 18 September 2006.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2007 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 747-2:2007: E
worldwide for CEN national Members.

---------------------- Page: 2 ----------------------

EN 747-2:2007 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope.5
2 Normative references.5
3 General test conditions.5
3.1 Preliminary preparation.5
3.2 Application of forces .5
3.3 Tolerances.6
4 Test equipment.6
4.1 General.6
4.2 Measuring cones.6
4.3 Bed base impactor.7
4.3.1 Bed base impactor (see Figure 2) .7
4.3.2 Springs.7
4.3.3 Striking surface.
...

SLOVENSKI OSIST prEN 747-2:2004

PREDSTANDARD
junij 2004
Pohištvo - Pogradi za domačo uporabo - 2. del: Preskusne metode
Furniture - Bunk beds and high beds for domestic use - Part 2: Test methods
ICS 97.140 Referenčna številka
OSIST prEN 747-2:2004(en;fr;de)
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
prEN 747-2 rev
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2004
ICS Will supersede EN 747-2:1993
English version
Furniture - Bunk beds and high beds for domestic use - Part 2:
Test methods
Ameublement - Lits superposés et lits hauts à usage Möbel - Etagenbetten für den Wohnbereich - Teil 2:
domestique - Partie 2 : Méthodes d'essai Prüfverfahren
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 207.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 747-2 rev:2004: E
worldwide for CEN national Members.

---------------------- Page: 2 ----------------------
prEN 747-2:2004 (E)
Contents Page
Foreword.3
1 Scope .5
2 Normative references .5
3 General test conditions .5
3.1 Preliminary preparation.5
3.2 Application of forces .6
3.3 Tolerances .6
4 Test equipment .6
4.1 General.6
4.2 Measuring cones.6
4.3 Bed base impacter .7
4.3.1 Circular body.7
4.3.2 Springs.7
4.3.3 Striking surface.8
4.4 Loading pad.8
4.5 Test mattress.
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.