Insulators - Tests on indoor post insulators of organic material for systems with nominal voltages greater than 1 kV up to but not including 300 kV

Applicable to post insulators of organic material for indoor service in electrical installations or equipment operating in air at atmospheric pressure on alternating current with a nominal voltage greater than 1 000 V up, but not including, 300 kV, as defined by range I of EN 60071-1, and a frequency not greater than 100 Hz. Composite insulators are not covered by this standard. The object of this standard is - to define the terms used, - define electrical and mechanical characteristics of post insulators of organic material and to prescribe the conditions under which the specified values of these characteristics are verified, - to prescribe methods of testing, - to prescribe acceptance criteria. This standard does not give numerical values for insulator characteristics, nor does it deal with a choice of insulators for specific operating conditions. HD 578 S1 specifies numerical values for electrical and mechanical characteristics and gives the dimensions necessary for interchangeability of post insulators.

Isolatoren - Prüfungen an Innenraum-Stützern aus organischem Werkstoff für Netze mit Nennspannungen über 1 kV bis kleiner 300 kV

Isolateurs - Essais des supports isolants d'intérieur en matière organique destinés à des installations de tension nominale supérieure à 1 kV jusqu'à 300 kV non compris

Est applicable aux supports isolants d'intérieur en matière organique destinés à l'équipement d'installations ou d'appareils électriques fonctionnant dans l'air, à la pression atmosphérique, en courant alternatif, à une tension nominale supérieure à 1000 V jusqu'à 300 kV non compris et à une fréquence au plus égale à 100 Hz comme défini dans la gamme I de la EN 60071-1. Les isolateurs composites ne sont pas couverts par la présente norme. La présente norme a pour objet de: définir les termes employés; définir les caractéristiques électriques et mécaniques des supports isolants en matière organique et de fixer les conditions dans lesquelles les valeurs spécifiées de ce caractéristiques doivent être vérifiées; prescrire les méthodes d'essai; fixer les conditions d'acceptation. Cette norme ne donne pas de valeur numérique pour les caractéristiques des isolateurs et ne contient pas de prescriptions relatives au choix d'un isolateur en fonction du service qu'il doit assurer. La HD 578 S1 spécifie les valeurs numériques pour les caractéristiques électriques et mécaniques, et donne les dimensions nécessaires à l'interchangeabilité des supports isolants.

Insulators - Tests on indor post insulators of organic material for systems with nominal voltages greater than 1 kV up to but not including 300 kV (IEC 60660:1999)

General Information

Status
Published
Publication Date
08-Dec-1999
Withdrawal Date
30-Nov-2002
Drafting Committee
Parallel Committee
Current Stage
6060 - Document made available - Publishing
Start Date
09-Dec-1999
Completion Date
09-Dec-1999

Buy Standard

Standard
EN 60660:2001
English language
30 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60660:2001
01-februar-2001
Insulators - Tests on indor post insulators of organic material for systems with
nominal voltages greater than 1 kV up to but not including 300 kV (IEC 60660:1999)
Insulators - Tests on indoor post insulators of organic material for systems with nominal
voltages greater than 1 kV up to but not including 300 kV
Isolatoren - Prüfungen an Innenraum-Stützern aus organischem Werkstoff für Netze mit
Nennspannungen über 1 kV bis kleiner 300 kV
Isolateurs - Essais des supports isolants d'intérieur en matière organique destinés à des
installations de tension nominale supérieure à 1 kV jusqu'à 300 kV non compris
Ta slovenski standard je istoveten z: EN 60660:1999
ICS:
29.080.10 Izolatorji Insulators
SIST EN 60660:2001 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

NORME CEI
INTERNATIONALE IEC
60660
INTERNATIONAL
Deuxième édition
STANDARD
Second edition
1999-10
Isolateurs –
Essais des supports isolants d'intérieur en matière
organique destinés à des installations de tension
nominale supérieure à 1 000 V jusqu'à 300 kV
non compris
Insulators –
Tests on indoor post insulators of organic material
for systems with nominal voltages greater than
1 000 V up to but not including 300 kV
 IEC 1999 Droits de reproduction réservés  Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in
utilisée sous quelque forme que ce soit et par aucun procédé, any form or by any means, electronic or mechanical,
électronique ou mécanique, y compris la photo-copie et les including photocopying and microfilm, without permission in
microfilms, sans l'accord écrit de l'éditeur. writing from the publisher.
International Electrotechnical Commission 3, rue de Varembé Geneva, Switzerland
Telefax: +41 22 919 0300 e-mail: inmail@iec.ch IEC web site http://www.iec.ch
CODE PRIX
Commission Electrotechnique Internationale
U
PRICE CODE
International Electrotechnical Commission
Pour prix, voir catalogue en vigueur
For price, see current catalogue

---------------------- Page: 2 ----------------------

60660 © IEC:1999 – 3 –
CONTENTS
Page
FOREWORD . 5
Clause
1 General. 9
1.1 Scope and object . 9
1.2 Normative references. 9
1.3 Definitions. 11
1.4 Values which characterise a post insulator of organic material. 15
1.5 Documentation. 17
1.6 Normal service conditions . 17
2 General requirements for tests . 17
2.1 Classification of tests . 17
2.2 Quality assurance . 19
2.3 General requirements for electrical tests . 19
2.4 Lightning impulse voltage tests. 21
2.5 Power-frequency voltage tests. 21
2.6 Standard reference atmospheric conditions for tests. 21
2.7 Correction factors for atmospheric conditions . 21
3 Type tests . 21
3.1 General. 21
3.2 General requirements for electrical type tests . 25
3.3 Dry lightning impulse withstand voltage test. 27
3.4 Dry power-frequency withstand voltage test . 29
3.5 Partial discharge extinction voltage test. 29
3.6 Lightning impulse puncture test .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.