EN 61300-3-22:2011

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-22: Examinations and measurements - Ferrule compression force

IEC 61300-3-22:2010 describes the procedure to measure the spring-loaded force applied to a ferrule when the plugs mate with each other during normal service. This measurement procedure is applicable to a connector plug which has a spring-loaded ferrule. Changes from the previous edition include reconsideration of the procedure and the details to be specified.

Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und Messverfahren - Teil 3-22: Untersuchungen und Messungen - Federkraft der Ferrulen

Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d'essais et de mesures - Partie 3-22: Examens et mesures - Force de compression des férules

La CEI 61300-3-22:2010 décrit la procédure de mesure de la force appliquée sous l'action du ressort sur une férule, lorsque les fiches sont couplées dans des conditions normales de fonctionnement. Cette procédure de mesure est applicable à la partie fiche d'une connexion équipée d'une férule maintenue par ressort. Les modifications par rapport à l'édition antérieure ont pour but de reconsidérer la procédure et les détails à spécifier.

Optični spojni elementi in pasivne komponente - Osnovni postopki za preskušanje in meritve - 3-22. del: Preiskave in meritve - Sila za stiskanje tulk (IEC 61300-3-22:2010)

Ta del IEC 61300 opisuje postopek merjenja vzmetne sile, ki deluje na tulko pri medsebojnem združevanju priključkov med običajno uporabo. Ta postopek merjenja velja za konektorski priključek z vzmeteno tulko.

General Information

• Status: Published
• Publication Date: 07-Apr-2011
• Withdrawal Date: 12-Jan-2012
• ICS: 33.180.20 - Fibre optic interconnecting devices
• Technical Committee: CLC/TC 86BXA - Fibre optic interconnect, passive and connectorised components
• Drafting Committee: IEC/SC 86B - IEC_SC_86B
• Parallel Committee: IEC/SC 86B - IEC_SC_86B
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 08-Apr-2011
• Completion Date: 08-Apr-2011
• Ref Project: SIST EN 61300-3-22:2011 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-22: Examinations and measurements - Ferrule compression force (IEC 61300-3-22:2010)

Relations

• Replaces: EN 61300-3-22:1997 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-22: Examinations and measurements - Ferrule compression force
• Effective Date: 28-Jan-2023

Standards Content (Sample)

SLOVENSKI STANDARD
01-junij-2011
1DGRPHãþD
SIST EN 61300-3-22:1997
2SWLþQLVSRMQLHOHPHQWLLQSDVLYQHNRPSRQHQWH2VQRYQLSRVWRSNL]DSUHVNXãDQMH
LQPHULWYHGHO3UHLVNDYHLQPHULWYH6LOD]DVWLVNDQMHWXON,(&

Fibre optic interconnecting devices and passive components - Basic test and
measurement procedures - Part 3-22: Examinations and measurements - Ferrule
compression force (IEC 61300-3-22:2010)
Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und
Messverfahren - Teil 3-22: Untersuchungen und Messungen - Federkraft der Stifte (IEC
61300-3-22:2010)
Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes
fondamentales d'essais et de mesures - Partie 3-22: Examens et mesures - Force de
compression des férules (CEI 61300-3-22:2010)
Ta slovenski standard je istoveten z: EN 61300-3-22:2011
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 61300-3-22
NORME EUROPÉENNE
April 2011
EUROPÄISCHE NORM
ICS 33.180.20 Supersedes EN 61300-3-22:1997

English version
Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures -
Part 3-22: Examinations and measurements -
Ferrule compression force
(IEC 61300-3-22:2010)
Dispositifs d'interconnexion et composants Lichtwellenleiter -
passifs à fibres optiques - Verbindungselemente und passive
Méthodes fondamentales d'essais et de Bauteile -
mesures - Grundlegende Prüf- und Messverfahren -
Partie 3-22: Examens et mesures - Teil 3-22: Untersuchungen und
Force de compression des férules Messungen -
(CEI 61300-3-22:2010) Federkraft der Ferrulen
(IEC 61300-3-22:2010)
This European Standard was approved by CENELEC on 2011-01-13. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels

© 2011 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-3-22:2011 E
Foreword
The text of document 86B/3093/FDIS, future edition 2 of IEC 61300-3-22, prepared by SC 86B, Fibre
optic interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to the
IEC-CENELEC parallel vote and was approved by CENELEC as EN 61300-3-22 on 2011-01-13.
This European Standard supersedes EN 61300-3-22:1997.
Changes from EN 61300-3-22:1997 include reconsideration of the procedure and the details to be
specified.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent
rights.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2011-10-13
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2012-01-13
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 61300-3-22:2010 was approved by CENELEC as a European
Standard without any modification.
__________
- 3 - EN 61300-3-22:2011
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year

IEC 61754 Series Fibre optic connector interfaces EN 61754 Series

IEC 61300-3-22 ®
Edition 2.0 2010-12
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Fibre optic interconnecting devices and passive components – Basic test and
measurement procedures –
Part 3-22: Examinations and measurements – Ferrule compression force

Dispositifs d'interconnexion et composants passifs à fibres optiques –
Méthodes fondamentales d'essais et de mesures –
Partie 3-22: Examens et mesures – Force de compression des férules

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
G
CODE PRIX
ICS 33.180.20 ISBN 978-2-88912-285-1
– 2 – 61300-3-22 Ó IEC:2010
CONTENTS
FOREW ORD . 3
1 Sc o pe . 5
2 Normative references . 5
3 Apparatus . 5
3.1 Fixed clamping device . 5
3.2 Force generator . 5
3.3 Position sensor . 5
3.4 Force gauge . 5
4 Procedure . 6
5 Details to be specified . 7

Figure 1 – Example of test apparatus . 6
Figure 2 – Example of test data . 7

61300-3-22 Ó IEC:2010 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC INTERCONNECTING DEVICES
AND PASSIVE COMPONENTS –
BASIC TEST AND MEASUREMENT PROCEDURES –

Part 3-22: Examinations and measurements –
Ferrule compression force
FOREWORD
1) The International Electrotechnical Commission (IEC) is a world
...