Miniature fuses - Part 7: Miniature fuse-links for special applications

IEC 60127-7:2013 covers requirements for miniature fuse-links for special applications. It does not apply to fuses completely covered by the subsequent parts of IEC 60269-1. It does not apply to miniature fuse-links for appliances intended to be used under special conditions, such as in corrosive or explosive atmospheres. This standard applies in addition to the requirements of IEC 60127-1. This standard is applicable to fuse-links with a rated voltage not exceeding 1000 V, a rated current not exceeding 20 A and a rated breaking capacity not exceeding 50 kA. Miniature fuse-links for special applications are not intended to be replaced by the end-user of an electrical/electronic appliance. The object of this standard is to establish uniform test methods for miniature fuse-links for special applications, so as to allow verification of the values (for example melting time and breaking capacity values) specified by the manufacturer. Keywords: requirements for miniature fuse-links

Geräteschutzsicherungen - Teil 7: G-Sicherungseinsätze für besondere Anwendungen

Coupe-circuit miniatures - Partie 7: Eléments de remplacement miniatures pour applications spéciales

La CEI 60127-7:2013 couvre des exigences pour éléments de remplacement miniatures destinés à des applications spéciales. Elle ne s'applique pas aux coupe-circuits complètement couverts par les autres parties de la CEI 60269-1. Elle n'est pas applicable aux éléments de remplacement miniatures placés dans des appareils destinés à être employés dans des conditions particulières, telles qu'atmosphères corrosives ou explosives. La présente norme s'applique en complément des exigences présentées dans la CEI 60127-1. La présente norme est applicable aux éléments de remplacement de tension assignée ne dépassant pas 1 000 V, de courant assigné ne dépassant pas 20 A et de pouvoir de coupure assigné ne dépassant pas 50 kA. Les éléments de remplacement miniatures pour applications spéciales ne sont pas destinés à être remplacés par l'utilisateur final d'un appareil électronique ou électrique. La présente norme a pour objet d'établir des méthodes d'essai uniformes pour des éléments de remplacement miniatures pour applications spéciales, pour permettre de vérifier les valeurs (par exemple la durée de fusion et le pouvoir de coupure) spécifiées par le fabricant. Mots clés: exigences pour éléments de remplacement miniatures

Miniaturne varovalke - 7. del: Miniaturne taljive varovalke za posebne aplikacije (IEC 60127-7:2013)

Ta del standarda IEC 60127 zajema zahteve za miniaturne taljive vložke za posebno uporabo. Ne uporablja se za varovalke, ki so v celoti vključene v nadaljnjih delih standarda IEC 60269-1. Ne velja za miniaturne taljive vložke za aparate, namenjene uporabi pod posebnimi pogoji, npr. v korozivni ali eksplozivni atmosferi. Ta standard se poleg tega uporablja za zahteve iz standarda IEC 60127-1. Ta standard se uporablja za taljive vložke z nazivno napetostjo, ki ne presega 1000 V, nazivnim tokom, ki ne presega 20 A, in nazivno zmogljivostjo prekinitve, ki ne presega 50 kA. Miniaturnih taljivih vložkov za posebno uporabo ne sme zamenjevati končni uporabnik
električnega/elektronskega aparata. Namen tega standarda je vzpostaviti enotne preskusne metode za miniaturne taljive vložke za posebno uporabo, tako da se omogoči preverjanje vrednosti (na primer čas taljenja in vrednosti zmogljivosti prekinitve), ki jih določi proizvajalec.

General Information

Status
Withdrawn
Publication Date
20-Jun-2013
Withdrawal Date
23-Apr-2016
Technical Committee
Drafting Committee
Current Stage
9960 - Withdrawal effective - Withdrawal
Start Date
27-Oct-2018
Completion Date
27-Oct-2018

Relations

Buy Standard

Standard
EN 60127-7:2013
English language
26 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60127-7:2013
01-september-2013
Miniaturne varovalke - 7. del: Miniaturne taljive varovalke za posebne aplikacije
(IEC 60127-7:2013)
Miniature fuses - Part 7: Miniature fuse-links for special applications (IEC 60127-7:2013)
Geräteschutzsicherungen - Teil 7: G-Sicherungseinsätze für besondere Anwendungen
(IEC 60127-7:2013)
Coupe-circuit miniatures - Partie 7: Eléments de remplacement miniatures pour
applications spéciales (CEI 60127-7:2013)
Ta slovenski standard je istoveten z: EN 60127-7:2013
ICS:
29.120.50 9DURYDONHLQGUXJD Fuses and other overcurrent
PHGWRNRYQD]DãþLWD protection devices
SIST EN 60127-7:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 60127-7:2013

---------------------- Page: 2 ----------------------

SIST EN 60127-7:2013

EUROPEAN STANDARD
EN 60127-7

NORME EUROPÉENNE
June 2013
EUROPÄISCHE NORM

ICS 29.120.50


English version


Miniature fuses -
Part 7: Miniature fuse-links for special applications
(IEC 60127-7:2013)


Coupe-circuit miniatures -  Geräteschutzsicherungen -
Partie 7: Eléments de remplacement Teil 7: G-Sicherungseinsätze für
miniatures pour applications spéciales besondere Anwendungen
(CEI 60127-7:2013) (IEC 60127-7:2013)




This European Standard was approved by CENELEC on 2013-04-24. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60127-7:2013 E

---------------------- Page: 3 ----------------------

SIST EN 60127-7:2013
EN 60127-7:2013 - 2 -
Foreword
The text of document 32C/458/CDV, future edition 1 of IEC 60127-7, prepared by SC 32C “Miniature
fuses” of IEC/TC 32 “Fuses” was submitted to the IEC-CENELEC parallel vote and approved by
CENELEC as EN 60127-7:2013.

The following dates are fixed:
(dop) 2013-01-24
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2013-04-24
standards conflicting with the
document have to be withdrawn

This standard shall be used in conjunction with EN 60127-1:2006 + A1:2011.

The clauses of this standard supplement, modify or replace the corresponding clauses in EN 60127-1.

Where there is no corresponding clause or subclause in this standard, the clause or subclause of
EN 60127-1 applies without modification as far as is reasonable. When this standard states
“addition”or “replacement”, the relevant text in EN 60127-1 is to be adapted accordingly.

Subclauses which are additional to those in Part 1 are numbered starting from 101. Additional
annexes are numbered AA, BB, etc.

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.

This standard covers the Principle Elements of the Safety Objectives for Electrical Equipment
Designed for Use within Certain Voltage Limits (LVD - 2006/95/EC).

Endorsement notice
The text of the International Standard IEC 60127-7:2013 was approved by CENELEC as a European
Standard without any modification.

---------------------- Page: 4 ----------------------

SIST EN 60127-7:2013
- 3 - EN 60127-7:2013
Annex ZA
(normative)

Normative references to international publications
with their corresponding European publications

The following documents, in whole or in p
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.