IEC 60065:2001/COR1:2002
(Corrigendum)Corrigendum 1 - Audio, video and similar electronic apparatus - Safety requirements
Corrigendum 1 - Audio, video and similar electronic apparatus - Safety requirements
Corrigendum 1 - Appareils audio, vidéo et appareils électroniques analogues - Exigences de sécurité
General Information
Relations
Standards Content (Sample)
CEI 60065 IEC 60065
(Septième édition – 2001) (Seventh edition – 2001)
Appareils audio, vidéo et appareils Audio, video and similar electronic apparatus –
électroniques analogues – Safety requirements
Exigences de sécurité
CORRIGENDUM 1
Page 78 Page 79
Tableau 3, point a) Parties ACCESSIBLES Table 3, item a) ACCESSIBLE parts
Dans le premier tiret, sous « Enveloppes si » In the first dash under “Enclosures if”, instead
au lieu de: of:
a a
– métalliques – metallic
lire: read:
b b
– métalliques – metallic
La correction ne concerne que le texte an
...
This May Also Interest You
Applies to receiving apparatus for sound or vision, amplifiers, load and source transducers, motor-driven apparatus (radio-gramophones, tape recorders and sound-film projectors, etc.) which are to be connected to the mains, directly or indirectly, and which are intended for domestic and similar indoor use. Gives a safety and classification terminology based on IEC 60536. Specifies requirements for marking, insulation, components, electrical connections and fixings, protection against ionizing radiation, resistance to heating, mechanical strength and stability, etc., as well as a requirement for splash-proof mains operated electronic equipment. Does not apply to apparatus designed for rated supply voltage exceeding 433 V (r.m.s.) between phases in the case of three-phase supply and 250 V (r.m.s.) in all other cases. Has the status of a group safety publication in accordance with IEC Guide 104. Please refer to Guide 112 for using the current editions of IEC 60065 and IEC 60950 in evaluating the safety of multimedia equipment
- Standard317 pagesEnglish and French languagesale 15% off
- Standard339 pagesEnglish and French languagesale 15% off
- Standard326 pagesEnglish and French languagesale 15% off
IEC/TS 62441:2011 Introduces safeguards to reduce the likelihood of room flash-over as a result of accidental ignition of exterior housings of audio/video and information communication technology products likely to be used in the home, caused by a candle flame. This second edition of IEC 62441 cancels and replaces the first edition published in 2006 and constitutes a technical revision. This edition includes the following technical changes with respect to the previous edition:
- acceptance of wood with a minimum thickness as equivalent to V-1;
- interpretation information regarding vertical surfaces.
- Technical specification22 pagesEnglish and French languagesale 15% off
- Standard30 pagesEnglish and French languagesale 15% off
- Standard33 pagesEnglish and French languagesale 15% off
Applies to receiving apparatus for sound or vision, amplifiers, load and source transducers, motor-driven apparatus (radio-gramophones, tape recorders and sound-film projectors, etc.) which are to be connected to the mains, directly or indirectly, and which are intended for domestic and similar indoor use. Gives a safety and classification terminology based on IEC 60536. Specifies requirements for marking, insulation, components, electrical connections and fixings, protection against ionizing radiation, resistance to heating, mechanical strength and stability, etc., as well as a requirement for splash-proof mains operated electronic equipment. Does not apply to apparatus designed for rated supply voltage exceeding 433 V (r.m.s.) between phases in the case of three-phase supply and 250 V (r.m.s.) in all other cases. Has the status of a group safety publication in accordance with IEC Guide 104. Please refer to Guide 112 for using the current editions of IEC 60065 and IEC 60950 in evaluating the safety of multimedia equipment
- Standard251 pagesEnglish and French languagesale 15% off
- Standard8 pagesEnglish and French languagesale 15% off
IEC 60335-2-55:2021 is available as IEC 60335-2-55:2021 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.
IEC 60335-2-55:2021 deals with the safety of electric appliances for use with aquariums and garden ponds for household and similar purposes, their rated voltage being not more than 250 V, including direct current (DC) supplied appliances and battery-operated appliances.
Examples of appliances that this standard is applicable to are
- aerators;
- aquarium heaters;
- automatic food dispensers;
- sludge-suction appliances.
Appliances not intended for normal household use but that nevertheless can be a source of danger to the public, such as appliances intended to be used by laymen in shops and in light industry and farms, are within the scope of this standard.
As far as is practicable, this standard deals with the common hazards presented by appliances that are encountered by all persons in and around the home. However, in general, it does not take into account
- persons (including children) whose physical, sensory or mental capabilities; or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction;
- children playing with the appliance.
Attention is drawn to the fact that
- for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements can be necessary;
- in many countries additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour and similar authorities.
This standard does not apply to
- pumps (IEC 60335-2-41);
- other portable immersion heaters (IEC 60335-2-74);
- luminaires for aquariums and garden ponds (IEC 60598-2-18);
- appliances intended for outdoor use having a rated power input exceeding 100 W;
- appliances intended exclusively for professional use;
- appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas).
This fourth edition cancels and replaces the third edition published in 2002 and Amendment 1:2008. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:
a) the text has been aligned with IEC 60335-1:2020;
b) some notes have been converted to normative text or deleted (Clause 1, 5.2, 19.101, 21.1, 21.102, 22.101);
c) updated the depth of immersion symbol (7.1, 7.6, 7.12);
d) limits on the temperature rise of external accessible surfaces have been introduced (Clause 11).
This Part 2 is to be used in conjunction with the latest edition of IEC 60335-1 and its amendments unless that edition precludes it; in that case, the latest edition that does not preclude it is used. It was established on the basis of the sixth edition (2020) of that standard.
- Standard54 pagesEnglish languagesale 15% off
- Standard36 pagesEnglish and French languagesale 15% off
IEC 60335-2-68:2021 is available as IEC 60335-2-68:2021 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.
IEC 60335-2-68:2021 deals with the safety of electrical portable, non-self-propelled motor-operated spray extraction machines with or without attachments and with or without electrical heating elements, intended for commercial indoor use. This standard applies to machines for commercial use. The following list, although not comprehensive, gives an indication of locations that are included in the scope:
- public use areas such as hotels, schools, hospitals;
- industrial locations, for example factories and manufacturing shops;
- retail outlets, for example shops and supermarkets;
- business premises, for example offices and banks;
- rental services for those machines;
- all uses other than normal housekeeping purposes.
These machines are not equipped with a traction drive. Machines for the same intended function but equipped with a traction drive are covered by IEC 60335-2-72.
The following power systems are covered:
- mains powered motors up to a rated voltage of 250 V for single-phase appliances and 480 V for other appliances,
- battery-operated machines.
This standard applies to machines in which the pressure of the employed cleaning agent does not exceed 2,5 MPa, and in which the product of the pressure (in MPa) and the flow of cleaning agent (in litres per minute) does not exceed 100, and in which the temperature of the cleaning agent at the spray nozzle outlet does not exceed 85 °C.
This standard does not apply to
- vacuum cleaners and water-suction cleaning appliances for household use (IEC 60335-2-2);
- floor treatment machines for commercial use (IEC 60335-2-67, IEC 60335-2-72);
- wet and dry vacuum cleaners, including power brush, for commercial use (IEC 60335-2-69);
- hand-held and transportable motor-operated electric tools (IEC 60745 series, IEC 61029 series, IEC 62841 series).
- machines designed for use in corrosive or explosive environments (dust, vapour or gas);
- machines designed for picking up hazardous dusts (as defined in IEC 60335-2-69), inflammable substances, or glowing particles;
- machines designed to handle hazardous solvents, such as flammable or explosive liquids;
This fifth edition cancels and replaces the fourth edition published in 2012 and its Amendment 1: 2016. It constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition (minor changes are not listed):
- editorial and technical alignment with IEC 60335-1:2020.
This part 2 is to be used in conjunction with the latest edition of IEC 60335-1 and its amendments. It was established on the basis of the sixth edition (2020) of that standard.
- Standard122 pagesEnglish languagesale 15% off
- Standard80 pagesEnglish and French languagesale 15% off
IEC 60335-2-68:2012 deals with the safety of electrical portable, non-self-propelled motor-operated spray extraction machines with or without attachments and with or without electrical heating elements, intended for commercial indoor use. This standard applies to machines for commercial use. The following list, although not comprehensive, gives an indication of locations that are included in the scope:
- public use areas such as hotels, schools, hospitals;
- industrial locations, for example factories and manufacturing shops;
- retail outlets, for example shops and supermarkets;
- business premises, for example offices and banks;
- rental services for those machines and all uses other than normal housekeeping purposes.
They are not equipped with a traction drive. The following power systems are covered: mains powered motors up to a rated voltage of 250 V for single-phase appliances and 480 V for other appliances and battery powered motors. This standard applies to machines in which the pressure of the employed cleaning agent does not exceed 2,5 MPa, and in which the product of the pressure (in MPa) and the flow of cleaning agent (in litres per minute) does not exceed 100, and in which the temperature of the cleaning agent at the spray nozzle outlet does not exceed 85 °C. This fourth edition cancels and replaces the third edition published in 2002 and its Amendments 1 (2005) and 2 (2007). It constitutes a technical revision. The principal changes in this edition as compared with the third edition of IEC 60335-2-68 are as follows (minor changes are not listed):
- the title has been changed for better distinction with regard to IEC 60335-2-72;
- the scope has been revised editorially to avoid misunderstandings;
- terms and definitions has been revised with regard to the requirements revised;
- the standard has been revised in general and updated regarding state-of-the-art, as far as necessary, in particular some changes has been made to Clauses 15, 22 and 25;
- the markings and instructions (Clause 7) have been revised basically;
- a new Annex AA 'Emission of acoustical noise' was added;
- and a new Annex BB 'Emission of vibration' was added. Keywords: Spray extraction machines; cleaning agent.
This publication is to be read in conjunction with IEC 60335-1:2010.
- Standard72 pagesEnglish and French languagesale 15% off
- Standard154 pagesEnglish and French languagesale 15% off
Applies to receiving apparatus for sound or vision, amplifiers, load and source transducers, motor-driven apparatus (radio-gramophones, tape recorders and sound-film projectors, etc.) which are to be connected to the mains, directly or indirectly, and which are intended for domestic and similar indoor use. Gives a safety and classification terminology based on IEC 60536. Specifies requirements for marking, insulation, components, electrical connections and fixings, protection against ionizing radiation, resistance to heating, mechanical strength and stability, etc., as well as a requirement for splash-proof mains operated electronic equipment. Does not apply to apparatus designed for rated supply voltage exceeding 433 V (r.m.s.) between phases in the case of three-phase supply and 250 V (r.m.s.) in all other cases. Has the status of a group safety publication in accordance with IEC Guide 104. Please refer to Guide 112 for using the current editions of IEC 60065 and IEC 60950 in evaluating the safety of multimedia equipment
- Standard317 pagesEnglish and French languagesale 15% off
- Standard339 pagesEnglish and French languagesale 15% off
- Standard326 pagesEnglish and French languagesale 15% off
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.