Electronic fee collection — Localisation augmentation communication for autonomous systems

ISO 13141:2015 establishes requirements for short-range communication for the purposes of augmenting the localization in autonomous electronic fee collection (EFC) systems. Localization augmentation serves to inform on-board equipment (OBE) about geographical location and the identification of a charge object. This International Standard specifies the provision of location and heading information and security means to protect from the manipulation of the OBE with false roadside equipment (RSE). The localization augmentation communication takes place between an OBE in a vehicle and fixed roadside equipment. This International Standard is applicable to OBE in an autonomous mode of operation. ISO 13141:2015 defines attributes and functions for the purpose of localization augmentation, by making use of the dedicated short-range communications (DSRC) communication services provided by DSRC Layer 7, and makes these LAC attributes and functions available to the LAC applications at the RSE and the OBE. Attributes and functions are defined on the level of Application Data Units (ADUs, see Figure 1).

Perception de télépéage — Communications d'augmentation de localisations pour systèmes autonomes

ISO 13141:2015 définit les exigences pour une communication à courte portée en vue de mettre en place l'augmentation de localisations dans les systèmes de perception du télépéage (EFC) autonomes. L'augmentation de localisations sert à informer les équipements embarqués (OBE) de leur position géographique et à l'identification d'un objet de facturation. La présente Norme internationale spécifie la mise à disposition des informations de localisation et de direction, et constitue une protection contre la manipulation des équipements embarqués par des équipements routiers (RSE) frauduleux. Les communications d'augmentation de localisations s'effectuent entre l'équipement embarqué sur un véhicule et un équipement routier fixe. La présente Norme internationale s'applique aux équipements embarqués autonomes. Elle définit des attributs et des fonctions pour l'augmentation de localisations au moyen des services de communication DSRC fournis par la couche DSRC 7; elle met ces attributs et ces fonctions LAC à la disposition des applications LAC au niveau des équipements routiers et des équipements embarqués. Les attributs et les fonctions sont définis au niveau des unités de données d'application (ADU, Application Data Unit; voir Figure 1).

General Information

Status
Withdrawn
Publication Date
17-Nov-2015
Current Stage
9599 - Withdrawal of International Standard
Completion Date
23-Feb-2024
Ref Project

Relations

Buy Standard

Standard
ISO 13141:2015 - Electronic fee collection -- Localisation augmentation communication for autonomous systems
English language
31 pages
sale 15% off
Preview
sale 15% off
Preview
Standard
ISO 13141:2015 - Perception de télépéage -- Communications d'augmentation de localisations pour systèmes autonomes
French language
33 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13141
First edition
2015-12-01
Electronic fee collection — Localisation
augmentation communication for
autonomous systems
Perception de télépéage — Communications d’augmentation de
localisations pour systèmes autonomes
Reference number
ISO 13141:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 13141:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 13141:2015(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 2
3 Terms and definitions . 3
4 Abbreviated terms . 4
5 Application interface architecture . 5
5.1 General . 5
5.2 Services provided . 5
5.3 Attributes . 5
5.4 Contract and toll context . 5
5.5 Use of lower layers . 6
5.5.1 Supported DSRC communication stacks . 6
5.5.2 The use of the CEN DSRC stack . 6
6 Conformance requirements . 6
6.1 General . 6
6.2 Functional requirements . 7
6.2.1 Minimum supported transaction details . 7
6.2.2 Initialising communication . 7
6.2.3 Writing of data .
...

NORME ISO
INTERNATIONALE 13141
Première édition
2015-12-01
Perception de télépéage —
Communications d’augmentation de
localisations pour systèmes autonomes
Electronic fee collection — Localisation augmentation
communication for autonomous systems
Numéro de référence
ISO 13141:2015(F)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 13141:2015(F)

DOCUMENT PROTÉGÉ PAR COPYRIGHT
© ISO 2015, Publié en Suisse
Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni utilisée
sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie, l’affichage sur
l’internet ou sur un Intranet, sans autorisation écrite préalable. Les demandes d’autorisation peuvent être adressées à l’ISO à
l’adresse ci-après ou au comité membre de l’ISO dans le pays du demandeur.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – Tous droits réservés

---------------------- Page: 2 ----------------------
ISO 13141:2015(F)

Sommaire Page
Avant-propos .v
Introduction .vi
1 Domaine d’application . 1
2 Références normatives . 2
3 Termes et définitions . 3
4 Abréviations . 4
5 Architecture de l’interface d’application . 5
5.1 Généralités . 5
5.2 Services fournis . 5
5.3 Attributs . 5
5.4 Contrat et contexte de péage. 6
5.5 Utilisation des couches basses . 6
5.5.1 Piles de communication DSRC prises en charge . 6
5.5.2 Utilisation de la pile de communication CEN-DSRC . 6
6 Exigences de conformité. 7
6.1 Généralités . 7
6.2 Exigences de fonction . 7
6.2.1 Détail du minimum des transactions supportées. 7
6.2.2 Initialisation de la communication . 7
6.2.3 Écriture des données . .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.