ISO 5260:2023
(Main)Epoxidized natural rubber — Determination of epoxidation and ring opening level by NMR spectrometry
Epoxidized natural rubber — Determination of epoxidation and ring opening level by NMR spectrometry
This document specifies a quantitative method, using proton (1H) nuclear magnetic resonance (NMR) spectrometry, for the determination of epoxidation and ring opening level of raw epoxidized natural rubber (ENR). This method applies to ENR of all grades available commercially.
Caoutchouc naturel époxydé — Détermination de l'époxydation et du niveau d'ouverture des anneaux par spectrométrie RMN
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 5260
First edition
2023-06
Epoxidized natural rubber —
Determination of epoxidation and ring
opening level by NMR spectrometry
Caoutchouc naturel époxydé — Détermination de l'époxydation et du
niveau d'ouverture des anneaux par spectrométrie RMN
Reference number
ISO 5260:2023(E)
© ISO 2023
---------------------- Page: 1 ----------------------
ISO 5260:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
© ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 5260:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Reagents . 2
6 Apparatus . 2
7 Procedure .2
7.1 Sample preparation . 2
7.2 NMR measurement . 3
8 Calculation . 3
9 Precision . 3
10 Test report . 3
1
Annex A (informative) H NMR spectra of ENR 25 and ENR 50 . 5
Annex B (informative) Precision . 6
Bibliography . 9
iii
© ISO 2023 – All rights reserved
---------------------- Page: 3 ----------------------
ISO 5260:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use
of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed
patent rights in respect thereof. As of the date of publication of this document, ISO had not received
notice of (a) patent(s) which may be required to implement this document. However, implementers are
cautioned that this may not represent the latest information, which may be obtained from the patent
database available at www.iso.org/patents. ISO shall not be held responsible for identifying any or all
such patent rights.
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 45, Rubber and rubber products,
Subcommittee SC 3, Raw materials (including latex) for use in the rubber industry.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
© ISO 2023 – All rights reserved
---------------------- Page: 4 ----------------------
ISO 5260:2023(E)
Introduction
Epoxidized natural rubber (ENR) is one of the modified rubbers derived from natural rubber (NR).
The modification process is done by introducing oxygen atom to the unsaturated molecule of NR. This
chemical reaction produces an oxirane or epoxide compound that consists of a three-membered ether
in a cyclic form. A few grades of ENR are currently available depending on the extent of modification
such as ENR 25 (25 mole% epoxide) and ENR 50 (50 mole% epoxide).
ENR is used in many applications which include tyres, bearings and adhesives. Epoxidation and ring
opening level are very important parameters to check ENR quality. Various techniques are available
for quantification of the epoxidation level, such as elemental analysis (carbon, hydrogen and oxygen),
1 13
infrared spectroscopy (IR), proton ( H) and carbon ( C) nuclear magnetic resonance spectroscopy
(NMR), as well as the chemical titrimetric technique.
1
This document specifies a quantitative method, using proton ( H) nuclear magnetic resonance
spectrometry, for the determination of epoxidation and ring opening level of raw ENR. This test method
is an important document to support ISO 24483, as these parameters are included as specifications for
ENR. This work will benefit the market to specify a measurement method for the epoxidation and ring-
opening level of ENR.
v
© ISO 2023 – All rights reserved
---------------------- Page: 5 ----------------------
INTERNATIONAL STANDARD ISO 5260:2023(E)
Epoxidized natural rubber — Determination of
epoxidation and ring opening level by NMR spectrometry
1 Scope
1
This document specifies a quantitative method, using proton ( H) nuclear magnetic resonance (NMR)
spectrometry, for the determination of epoxidation and ring opening level of raw epoxidized natural
rubber (ENR). This method applies to ENR of all grades available commercially.
2 Normative references
There are no normative references in this document.
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminology databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https:// www .iso .org/ obp
— IEC Electropedia: available at https:// www .electropedia .org/
3.1
epoxidized natural rubber
ENR
natural rubber which has been chemically treated and modified through the addition of oxygen atom
onto the double bond structure of the cis-1,4-polyisoprene to form three-membered ether (C-O-C) in a
cyclic form by a process known as epoxidation reaction
[SOURCE: ISO 24483:2023, 3.1]
3.2
epoxidation level
level and/or degree of the epoxy groups (C-O-C) in the NR structure
[SOURCE: ISO 24483:2023, 3.4]
3.3
ring opening level
level and/or degree of ring opening due to the formation of secondary by product from uncontrolled
condition of epoxidation reaction in the
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.