ISO 5603:2017

Rubber, vulcanized — Determination of adhesion to wire cord

ISO 5603:2017 specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of materials and processes utilized in the manufacture of products reinforced with wire cord. NOTE The methods can also be used for single wire, for example bead wire. Method 1 reduces the dependence of the measured adhesion on the modulus and strength properties of the rubber.

Caoutchouc vulcanisé — Détermination de l'adhérence à un câble métallique

General Information

• Status: Withdrawn
• Publication Date: 30-Jul-2017
• ICS: 83.060 - Rubber
• Technical Committee: ISO/TC 45/SC 2 - Testing and analysis
• Drafting Committee: ISO/TC 45/SC 2/WG 1 - Physical properties
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 09-Apr-2024

Relations

• Revised: ISO 5603:2024 - Rubber, vulcanized — Determination of adhesion to wire cord
• Effective Date: 06-May-2023
• Revises: ISO 5603:2011 - Rubber, vulcanized — Determination of adhesion to wire cord
• Effective Date: 10-Dec-2016

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 5603
Fourth edition
2017-07
Rubber, vulcanized — Determination
of adhesion to wire cord
Caoutchouc vulcanisé — Détermination de l’adhérence à un câble
métallique
Reference number
ISO 5603:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 5603:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 5603:2017(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Materials . 2
6 Apparatus . 2
7 Calibration .11
8 Test piece .11
8.1 Form .11
8.2 Dimensions .13
8.3 Preparation .13
8.3.1 General.13
8.3.2 Method 1 .13
8.3.3 Method 2 .14
8.3.4 Both methods . .14
9 Procedure.14
10 Expression of results .16
11 Test report .
...