ISO 12817:2013

Fibre-reinforced plastic composites — Determination of open-hole compression strength

ISO 12817:2013 specifies the test method to determine the open-hole compressive strength of laminated fibre-reinforced plastic composites. The laminate is intended to be a balanced and symmetrical lay-up or be otherwise homogeneous through the thickness. ISO 12817:2013 applies to all textile diameter fibre types (carbon, glass, aramids, etc.) and matrices (e.g. thermoset, thermoplastic) that meet its requirements. ISO 12817:2013 includes three methods: method 1 (short specimen with support fixture); method 2 (short specimen without support fixture); method 3 (long specimen with support fixture as in ASTM D 6484M-09, methods A and B).

Composites plastiques renforcés de fibres — Détermination de la résistance à la compression avec trou nu

General Information

• Status: Published
• Publication Date: 04-Mar-2013
• ICS: 83.120 - Reinforced plastics
• Technical Committee: ISO/TC 61/SC 13 - Composites and reinforcement fibres
• Drafting Committee: ISO/TC 61/SC 13/WG 2 - Laminates and moulding compounds
• Current Stage: 9092 - International Standard to be revised
• Completion Date: 10-Jan-2024

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 12817
First edition
2013-03-15
Fibre-reinforced plastic composites —
Determination of open-hole
compression strength
Composites plastiques renforcés de fibres — Détermination de la
résistance à la compression avec trou nu
Reference number
ISO 12817:2013(E)
©
ISO 2013

---------------------- Page: 1 ----------------------
ISO 12817:2013(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 12817:2013(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Principle . 2
5 Apparatus . 3
6 Test specimens. 9
6.1 Shape and dimensions . 9
6.2 Alternative specimen . 9
6.3 Preparation of test plates and specimens .11
6.4 Inspection of test specimens .11
6.5 Number of test specimens .11
7 Conditioning .12
8 Procedure.12
8.1 Test atmosphere .12
8.2 Measurement of dimensions of the test specimens .12
8.3 Mounting of the test specimens .12
8.4 Test speed .
...