ISO/TS 16281:2008/Cor 1:2009
(Corrigendum)Rolling bearings — Methods for calculating the modified reference rating life for universally loaded bearings — Technical Corrigendum 1
Rolling bearings — Methods for calculating the modified reference rating life for universally loaded bearings — Technical Corrigendum 1
This Technical Specification contains recommendations for the calculation of the modified reference rating life taking into consideration lubrication, contamination and fatigue load limit of the bearing material, as well as tilting or misalignment, operating clearance of the bearing and internal load distribution on rolling elements. The calculation method provided in this Technical Specification covers influencing parameters additional to those described in ISO 281. The directions and limitations given in ISO 281 apply to this Technical Specification. The calculation methods pertain to the fatigue life of the bearings. Other mechanisms of failure, like wear or microspalling (gray staining), lie outside the scope of this Technical Specification. This Technical Specification applies to tilted single-row radial ball bearings, subjected to radial and axial load and with radial clearance and tilt taken into account. It also applies to tilted single-row roller bearings, subjected to pure radial load and with radial clearance, edge stress and tilt taken into account. References to methods for the analysis of the internal load distribution under general load are given. The analysis of internal load distribution and modified reference rating life for multi-row bearings or bearings of a more complex geometry can be derived from the equations given in this Technical Specification. For these bearings, the load distribution for each individual row has to be considered. This Technical Specification is primarily intended to be used for computer programs and together with ISO 281 covers the information needed for life calculations. For accurate life calculations under the operating conditions specified above, it is recommended that either this Technical Specification or advanced computer calculations provided by bearing manufacturers, for determining the dynamic equivalent reference load under different loading conditions, be used.
Wälzlager - Dynamische Tragzahlen und nominelle Lebensdauer - Berechnung der modifizierten nominellen Referenz-Lebensdauer für Wälzlager; Korrektur 1
Roulements — Méthodes de calcul de la durée nominale de référence corrigée pour les roulements chargés universellement — Rectificatif technique 1
Kotalni ležaji - Metode za izračun modificirane imenske dobe trajanja - Tehnični popravek 1
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Wälzlager - Dynamische Tragzahlen und nominelle Lebensdauer -
Berechnung der modifizierten nominellen Referenz-Lebensdauer für
Wälzlager; Korrektur 1Roulements - Méthodes de calcul de la durée nominale de référence
corrigée pour les roulements chargés universellement; Rectificatif
Technique 1Rolling bearings - Methods for calculating the modified reference rating life for universally loaded bearings; Technical Corrigendum 121.100.20Kotalni ležajiRolling bearingsICS:Ta slovenski standard je istoveten z:ISO/TS 16281:2008/Cor 1:2009SIST-TS ISO/TS 16281:2008/Cor 1:2009en,fr01-december-2009SIST-TS ISO/TS 16281:2008/Cor 1:2009SLOVENSKI
STANDARD
SIST-TS ISO/TS 16281:2008/Cor 1:2009
ICS
21.100.20 Ref. No. ISO/TS 16281:2008/Cor.1:2009(E)©
ISO 2009 – All rights reserved Published in Switzerland
TECHNICAL SPECIFICATION ISO/TS 16281:2008 TECHNICAL CORRIGENDUM 1 Publis
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.