ISO 11972:2015
(Main)Corrosion-resistant cast steels for general applications
Corrosion-resistant cast steels for general applications
ISO 11972:2015 specifies cast steels for general corrosion-resistant applications. The grades covered by this International Standard represent types of alloy steel castings suitable for broad ranges of application which are intended for a wide variety of corrosion applications. NOTE Annex A gives information on ISO grade designation and available UNS numbers which are similar to the ISO grade designation.
Aciers moulés résistant à la corrosion pour applications courantes
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 11972
Second edition
2015-09-15
Corrosion-resistant cast steels for
general applications
Aciers moulés résistant à la corrosion pour applications courantes
Reference number
ISO 11972:2015(E)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 11972:2015(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11972:2015(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative reference . 1
3 General conditions for delivery . 1
4 Chemical composition . 1
5 Mechanical properties . 1
6 Heat treatment . 1
7 Supplementary requirements . 5
Annex A (informative) UNS cast grades similar to ISO cast grades . 6
Bibliography . 7
© ISO 2015 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 11972:2015(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity
assessment, as well as information about ISO’s adherence to the WTO prin
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.