FTIR analysis of fire effluents in cone calorimeter tests

This document specifies a method for determining the kinetics and yields of gaseous emissions from a specimen exposed to radiant heat in a cone calorimeter. Gas yields are determined by exposing small representative specimens to an external heat flux with or without spark ignition. The concentrations of specific gases in the effluent (smoke) are measured. In combination with calculated masses of gases, their yields from the specimen mass, mass loss or mass loss rate can be determined. This document uses Fourier-Transform Infrared (FTIR) spectroscopy as described in ISO 19702, with additional information on the test apparatus and gas analyser suitable for this specific application.

Analyse par FTIR des effluents du feu dans les essais au calorimètre à cône

General Information

Status
Published
Publication Date
08-Mar-2021
Current Stage
9060 - Close of review
Start Date
02-Sep-2027
Ref Project

Relations

Buy Standard

Technical specification
ISO/TS 21397:2021 - FTIR analysis of fire effluents in cone calorimeter tests
English language
12 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

TECHNICAL ISO/TS
SPECIFICATION 21397
First edition
2021-03
FTIR analysis of fire effluents in cone
calorimeter tests
Analyse par FTIR des effluents du feu dans les essais au calorimètre à
cône
Reference number
ISO/TS 21397:2021(E)
©
ISO 2021

---------------------- Page: 1 ----------------------
ISO/TS 21397:2021(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2021
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2021 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/TS 21397:2021(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 1
5 Principle . 2
6 Apparatus . 2
7 Gas measurement system . 2
7.1 General arrangement . 2
7.2 Sampling probe . 4
7.3 Primary filter . 5
7.4 Sampling line . 6
7.5 Gas cell. 6
7.6 Pump and sampling flow rate . 6
7.7 FTIR spectrometer . 6
7.8 Detector . 7
8 Suitability of a product for testing . 7
9 Specimen preparation .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.