Road traffic noise reducing devices - Test method for determining the acoustic performance - Part 6: Intrinsic characteristics - In situ values of airborne sound insulation under direct sound field conditions

This document describes a test method for measuring a quantity representative of the intrinsic characteristics of airborne sound insulation for traffic noise reducing devices: the sound insulation index.
The test method is intended for the following applications:
-   determination of the intrinsic characteristics of airborne sound insulation of noise reducing devices to be installed along roads, to be measured either in situ or in laboratory conditions;
-   determination of the in situ intrinsic characteristics of airborne sound insulation of noise reducing devices in actual use;
-   comparison of design specifications with actual performance data after the completion of the construction work;
-   verification of the long term performance of noise reducing devices (with a repeated application of the method);
-   interactive design process of new products, including the formulation of installation manuals.
The test method is not intended for the determination of the intrinsic characteristics of airborne sound insulation of noise reducing devices to be installed in reverberant conditions, e.g. inside tunnels or deep trenches or under covers.
Results are expressed as a function of frequency in one-third octave bands, where possible, between 100 Hz and 5 kHz. If it is not possible to get valid measurement results over the whole frequency range indicated, the results will be given in a restricted frequency range and the reasons for the restriction(s) will be clearly reported.

Lärmschutzvorrichtungen an Straßen - Prüfverfahren zur Bestimmung der akustischen Eigenschaften - Teil 6: Produktspezifische Merkmale - In-situ-Werte der Luftschalldämmung in gerichteten Schallfeldern

Dispositifs de réduction du bruit du trafic routier - Méthode d'essai pour la détermination de la performance acoustique - Partie 6 : Caractéristiques intrinsèques - Valeurs in situ d'isolation aux bruits aériens dans des conditions de champ acoustique direct

Protihrupne ovire za cestni promet - Preskusna metoda za ugotavljanje akustičnih lastnosti - 6. del: Bistvene karakteristike - Terenske vrednosti izolirnosti pred zvokom v zraku pri usmerjenem zvočnem polju

General Information

Status
Not Published
Public Enquiry End Date
19-Dec-2019
Technical Committee
Current Stage
98 - Abandoned project (Adopted Project)
Start Date
19-Apr-2021
Due Date
24-Apr-2021
Completion Date
19-Apr-2021

Relations

Buy Standard

Draft
EN 1793-6:2018/oprA1:2019
English language
7 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 1793-6:2018/oprA1:2019
01-december-2019
Protihrupne ovire za cestni promet - Preskusna metoda za ugotavljanje akustičnih
lastnosti - 6. del: Bistvene karakteristike - Terenske vrednosti izolirnosti pred
zvokom v zraku pri usmerjenem zvočnem polju
Road traffic noise reducing devices - Test method for determining the acoustic
performance - Part 6: Intrinsic characteristics - In situ values of airborne sound insulation
under direct sound field conditions
Lärmschutzvorrichtungen an Straßen - Prüfverfahren zur Bestimmung der akustischen
Eigenschaften - Teil 6: Produktspezifische Merkmale - In-situ-Werte der
Luftschalldämmung in gerichteten Schallfeldern
Dispositifs de réduction du bruit du trafic routier - Méthode d'essai pour la détermination
de la performance acoustique - Partie 6 : Caractéristiques intrinsèques - Valeurs in situ
d'isolation aux bruits aériens dans des conditions de champ acoustique direct
Ta slovenski standard je istoveten z: EN 1793-6:2018/prA1
ICS:
17.140.30 Emisija hrupa transportnih Noise emitted by means of
sredstev transport
93.080.30 Cestna oprema in pomožne Road equipment and
naprave installations
SIST EN 1793-6:2018/oprA1:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 1793-6:2018/oprA1:2019

---------------------- Page: 2 ----------------------
SIST EN 1793-6:2018/oprA1:2019


DRAFT
EUROPEAN STANDARD
EN 1793-6:2018
NORME EUROPÉENNE

EUROPÄISCHE NORM
prA1
October 2019
ICS 17.140.30; 93.080.30
English Version

Road traffic noise reducing devices - Test method for
determining the acoustic performance - Part 6: Intrinsic
characteristics - In situ values of airborne sound insulation
under direct sound field conditions
Dispositifs de réduction du bruit du trafic routier - Lärmschutzvorrichtungen an Straßen - Prüfverfahren
Méthode d'essai pour la détermination de la zur Bestimmung der akustischen Eigenschaften - Teil
performance acoustique - Partie 6 : Caractéristiques 6: Produktspezifische Merkmale - In-situ-Werte der
intrinsèques - Valeurs in situ d'isolation aux bruits Luftschalldämmung in gerichteten Schallfeldern
aériens dans des conditions de champ acoustique
direct
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 226.

This draft amendment A1, if approved, will modify the European Standard EN 1793-6:2018. If this draft becomes an amendment,
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1793-6:2018/prA1:2019 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN 1793-6:2018/oprA1:2019
EN 1793-6:2018/prA1:2019 (E)
Contents Page
European foreword . 3
1 Modification to C.3, Standard deviation of repeatability and reproducibility of the
sound insulation index . 4
2 Modification to D.5, Uncertainty (example) . 5

2

---------------------- Page: 4 ----------------------
SIST EN 1793-6:2018/oprA1:2019
EN 1793-6:2018/prA1:2019 (E)
European foreword
This document (EN 1793-6:2018/prA1:2019) has been prepared by Technical Committee CEN/TC 226
“Road equipment”, the secretariat of which is held by AFNOR.
This document is currently submitted to the CEN Enquiry.
3

---------------------- Page: 5 ----------------------
SIST EN 1793-6:2018/oprA1:2019
EN 1793-6:2018/prA1:2019 (E)
1 Modification to C.3, Standard deviation of repeatability and reproducibility of
the sound insulation index
Replace the whole Clause C.3 with the following one:
"
C.3 Standard deviation of
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.