Refrigerating systems and heat pumps - Safety and environmental requirements - Part 3: Installation site and personal protection

This European Standard specifies the requirements for the safety of persons and property, provides guidance for the protection of the environment and establishes procedures for the operation, maintenance and repair of refrigerating systems and the recovery of refrigerants.
The term "refrigerating system" used in this European Standard includes heat pumps.
This Part 3 of the European Standard is applicable to the installation site (plant space and services). It specifies requirements on the site for safety, which may be needed because of, but not directly connected with, the refrigerating system and its ancillary components.
This standard applies:
a)   to refrigerating systems, stationary or mobile, of all sizes except to vehicle air conditioning systems covered by a specific product standard e.g. ISO 13043;
b)   to secondary cooling or heating systems;
c)   to the location of the refrigerating systems;
d)   to replaced parts and added components after adoption of this standard if they are not identical in function and in the capacity.
Systems using refrigerants other than those listed in of FprEN 378-1:2016, Annex E are not covered by this standard.
This standard does not apply to goods in storage.
This standard is not applicable to refrigerating systems which were manufactured before the date of its publication as a European Standard except for extensions and modifications to the system which were implemented after publication.
This standard is applicable to new refrigerating systems, extensions or modifications of already existing systems, and for existing stationary systems, being transferred to and operated on another site.
This standard also applies in the case of the conversion of a system for another refrigerant type, in which case conformity with the relevant clauses of parts 1 to 4 of the standard shall be assessed.

Kälteanlagen und Wärmepumpen - Sicherheitstechnische und umweltrelevante Anforderungen - Teil 3: Aufstellungsort und Schutz von Personen

No scope available

Systèmes frigorifiques et pompes à chaleur - Exigences de sécurité et d'environnement - Partie 3: Installation in situ et protection des personnes

[Not available]

Hladilni sistemi in toplotne črpalke - Varnostnotehnične in okoljevarstvene zahteve - 3. del: Mesto postavitve in zaščita oseb - Dopolnilo A1

General Information

Status
Not Published
Public Enquiry End Date
30-Nov-2019
Technical Committee
Current Stage
98 - Abandoned project (Adopted Project)
Start Date
05-Nov-2020
Due Date
10-Nov-2020
Completion Date
05-Nov-2020

RELATIONS

Buy Standard

Amendment
SIST EN 378-3:2017/oprA1:2019
English language
5 pages
sale 10% off
Preview
sale 10% off
Preview

e-Library read for
1 day

Standards Content (sample)

SLOVENSKI STANDARD
SIST EN 378-3:2017/oprA1:2019
01-november-2019
Hladilni sistemi in toplotne črpalke - Varnostnotehnične in okoljevarstvene
zahteve - 3. del: Mesto postavitve in zaščita oseb - Dopolnilo A1

Refrigerating systems and heat pumps - Safety and environmental requirements - Part 3:

Installation site and personal protection
Kälteanlagen und Wärmepumpen - Sicherheitstechnische und umweltrelevante
Anforderungen - Teil 3: Aufstellungsort und Schutz von Personen

Systèmes frigorifiques et pompes à chaleur - Exigences de sécurité et d'environnement -

Partie 3: Installation in situ et protection des personnes
Ta slovenski standard je istoveten z: EN 378-3:2016/prA1
ICS:
27.080 Toplotne črpalke Heat pumps
27.200 Hladilna tehnologija Refrigerating technology
SIST EN 378-3:2017/oprA1:2019 en,fr,de

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 378-3:2017/oprA1:2019
---------------------- Page: 2 ----------------------
SIST EN 378-3:2017/oprA1:2019
DRAFT
EUROPEAN STANDARD
EN 378-3:2016
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2019
ICS 27.080; 27.200
English Version
Refrigerating systems and heat pumps - Safety and
environmental requirements - Part 3: Installation site and
personal protection

Systèmes frigorifiques et pompes à chaleur - Exigences Kälteanlagen und Wärmepumpen -

de sécurité et d'environnement - Partie 3: Installation Sicherheitstechnische und umweltrelevante

in situ et protection des personnes Anforderungen - Teil 3: Aufstellungsort und Schutz von

Personen

This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 182.

This draft amendment A1, if approved, will modify the European Standard EN 378-3:2016. If this draft becomes an amendment,

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of

this amendment into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other

language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC

Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,

Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,

Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and

United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are

aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without

notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels

© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 378-3:2016/prA1:2019 E

worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 378-3:2017/oprA1:2019
EN 378-3:2016/prA1:2019 (E)
Contents Page

European foreword ....................................................................................................................................................... 3

1 Modification to Subclause 4.1 ..................................................................................................................... 4

2 Modification to Subclause 4.4 ..................................................................................................................... 4

3 Modification to Subclause 5.14 .................................................................................................................. 4

4 Modification to Subclause 9.3.1 ................................................................................................................. 5

---------------------- Page: 4 ----------------------
SIST EN 378-3:2017/oprA1:2019
EN 378-3:2016/prA1:2019 (E)
European foreword

This document (EN 378-3:2016/prA1:2019) has been prepared by Technical Committee CEN/TC 182

“Refrigerating systems, safety and environmental requirements”, the secretariat of which is held by DIN.

This document is currently submitted to the CEN Enquiry.
---------------------- Page: 5 ----------------------
SIST EN 378-3:2017/oprA1:2019
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.