SIST EN 12697-33:2019/oprA1:2022
(Amendment)Bituminous mixtures - Test method - Part 33: Specimen prepared by roller compactor
Bituminous mixtures - Test method - Part 33: Specimen prepared by roller compactor
This document specifies the methods for compacting parallelepipedal specimens (slabs) of bituminous mixtures, to be used directly for subsequent testing, or from which test specimens are cut.
For a given mass of bituminous mixture, the specimens are prepared either under controlled compaction energy, or until a specified volume and therefore air voids content is obtained.
This document describes the following methods of compaction:
- method using a wheel or two wheels fitted with pneumatic tyres;
- methods using a steel roller, which includes 3 different procedures:
- steel roller;
- steel roller used on wheel fitted with pneumatic tyres;
- steel roller running on vertical sliding steel plates;
- method using a steel roller sector.
This document is applicable to bituminous mixtures manufactured in the laboratory or in a mixing plant.
Asphalt - Prüfverfahren - Teil 33: Probestückvorbereitung mittels Walzverdichtungsgerät
Mélanges bitumineux - Méthodes d'essai - Partie 33 : Préparation de corps d'épreuve au compacteur de plaque
Bitumenske zmesi - Preskusne metode - 33. del: Preskušanci, pripravljeni z valjastim zgoščevalnikom - Dopolnilo A1
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 12697-33:2019/oprA1:2022
01-april-2022
Bitumenske zmesi - Preskusne metode - 33. del: Preskušanci, pripravljeni z
valjastim zgoščevalnikom - Dopolnilo A1
Bituminous mixtures - Test method - Part 33: Specimen prepared by roller compactor
Asphalt - Prüfverfahren - Teil 33: Probestückvorbereitung mittels Walzverdichtungsgerät
Mélanges bitumineux - Méthodes d'essai - Partie 33 : Préparation de corps d'épreuve au
compacteur de plaque
Ta slovenski standard je istoveten z: EN 12697-33:2019/prA1
ICS:
93.080.20 Materiali za gradnjo cest Road construction materials
SIST EN 12697-33:2019/oprA1:2022 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 12697-33:2019/oprA1:2022
---------------------- Page: 2 ----------------------
SIST EN 12697-33:2019/oprA1:2022
DRAFT
EUROPEAN STANDARD
EN 12697-33:2019
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
February 2022
ICS 93.080.20
English Version
Bituminous mixtures - Test method - Part 33: Specimen
prepared by roller compactor
Mélanges bitumineux - Méthodes d'essai - Partie 33 : Asphalt - Prüfverfahren - Teil 33:
Préparation de corps d'épreuve au compacteur de Probestückvorbereitung mittels
plaque Walzverdichtungsgerät
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 227.
This draft amendment A1, if approved, will modify the European Standard EN 12697-33:2019. If this draft becomes an
amendment, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for
inclusion of this amendment into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.