SIST EN 1777:2005/oprA1:2008
(Amendment)Hydraulic platforms (HPs) for fire fighting and rescue services - Safety requirements and testing
Hydraulic platforms (HPs) for fire fighting and rescue services - Safety requirements and testing
Hubrettungsfahrzeuge für Feuerwehren und Rettungsdienste, Hubarbeitsbühnen (HABn) - Sicherheitstechnische Anforderungen und Prüfung
Bras Élevateur Aérien (BEA) des services d'incendie et de secours - Prescriptions de sécurité et essais
Hidravlične ploščadi (HPs) za gasilske in reševalne enote - Varnostne zahteve in preskušanje
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 1777:2005/oprA1:2008
01-september-2008
+LGUDYOLþQHSORãþDGL+3V]DJDVLOVNHLQUHãHYDOQHHQRWH9DUQRVWQH]DKWHYHLQ
SUHVNXãDQMH
Hydraulic platforms (HPs) for fire fighting and rescue services - Safety requirements and
testing
Hubrettungsfahrzeuge für Feuerwehren und Rettungsdienste, Hubarbeitsbühnen (HABn)
- Sicherheitstechnische Anforderungen und Prüfung
Bras Élevateur Aérien (BEA) des services d'incendie et de secours - Prescriptions de
sécurité et essais
Ta slovenski standard je istoveten z: EN 1777:2004/prA1
ICS:
13.220.10 Gašenje požara Fire-fighting
SIST EN 1777:2005/oprA1:2008 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 1777:2005/oprA1:2008
---------------------- Page: 2 ----------------------
SIST EN 1777:2005/oprA1:2008
EUROPEAN STANDARD
FINAL DRAFT
EN 1777:2004
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
July 2008
ICS 13.220.10
English Version
Hydraulic platforms (HPs) for fire fighting and rescue services -
Safety requirements and testing
Bras Élevateur Aérien (BEA) des services d'incendie et de Hubrettungsfahrzeuge für Feuerwehren und
secours - Prescriptions de sécurité et essais Rettungsdienste, Hubarbeitsbühnen (HABn) -
Sicherheitstechnische Anforderungen und Prüfung
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 192.
This draft amendment A1, if approved, will modify the European Standard EN 1777:2004. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1777:2004/prA1:2008: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 1777:2005/oprA1:2008
EN 1777:2004/prA1:2008 (E)
Contents Page
Foreword.3
th
1 Modification to the Foreword, 4 paragraph .4
2 Modification to 5.3, Chassis and stabilizers .4
3 Modification to 5.5.2.1.2, Wire rope drive systems .4
4 Modification to 5.5.3.1.2, Chain drive systems .5
5 Modification to 7.1.1, General.5
6 Modification to 7.1.2, Operating instructions, which shall give detailed information
necessary for safe use. e.g.5
7 Modification to 7.1.4, Information on commissioning .6
8 Modification to 7.1.7, Maintenance information for use by trained personnel (see
introduction) e.g.6
9 Modification to 7.2.2 .6
10 Modification to Figure 13 .7
11 Addition of new Annex ZB .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.