SIST EN 16728:2016/oprA1:2017
(Amendment)LPG equipment and accessories - Transportable refillable LPG cylinders other than traditional welded and brazed steel cylinders - Periodic inspection
LPG equipment and accessories - Transportable refillable LPG cylinders other than traditional welded and brazed steel cylinders - Periodic inspection
This European Standard specifies procedures for periodic inspection and testing, for transportable refillable LPG cylinders with a water capacity from 0,5 l up to and including 150 l.
This European Standard is applicable to the following:
- welded steel LPG cylinders manufactured to an alternative design and construction, see EN 14140 or equivalent standard;
- welded aluminium LPG cylinders, see EN 13110 or equivalent standard;
- composite LPG cylinders, see EN 14427 or equivalent standard;
- over-moulded cylinders designed and manufactured according to EN 1442 or EN 14140, see Annex F.
NOTE The requirements of RID/ADR take precedence over those of this Standard in the case of cylinders complying with that regulation, including pi marked cylinders.
This European Standard does not apply to cylinders permanently installed in vehicles.
Flüssiggas-Geräte und Ausrüstungsteile - Ortsbewegliche, wiederbefüllbare Flaschen für Flüssiggas (LPG), ausgenommen geschweißte und hartgelötete Stahlflaschen - Wiederkehrende Inspektion
Équipements pour GPL et leurs accessoires - Bouteilles transportables et rechargeables pour GPL autres que celles en acier soudé et brasé - Contrôle périodique
Oprema in pribor za utekočinjeni naftni plin (UNP) - Premične, ponovno polnljive plinske jeklenke za UNP, ki niso varjene ali trdo spajkane - Periodična kontrola - Dopolnilo A1
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 16728:2016/oprA1:2017
01-november-2017
2SUHPDLQSULERU]DXWHNRþLQMHQLQDIWQLSOLQ 813 3UHPLþQHSRQRYQRSROQOMLYH
SOLQVNHMHNOHQNH]D813NLQLVRYDUMHQHLQWUGRVSDMNDQH3HULRGLþQDNRQWUROD
'RSROQLOR$
LPG equipment and accessories - Transportable refillable LPG cylinders other than
traditional welded and brazed steel cylinders - Periodic inspection
Flüssiggas-Geräte und Ausrüstungsteile - Ortsbewegliche, wiederbefüllbare Flaschen für
Flüssiggas (LPG), ausgenommen geschweißte und hartgelötete Stahlflaschen -
Wiederkehrende Inspektion
Équipements pour GPL et leurs accessoires - Bouteilles transportables et rechargeables
pour GPL autres que celles en acier soudé et brasé - Contrôle périodique
Ta slovenski standard je istoveten z: EN 16728:2016/prA1
ICS:
23.020.35 Plinske jeklenke Gas cylinders
SIST EN 16728:2016/oprA1:2017 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 16728:2016/oprA1:2017
---------------------- Page: 2 ----------------------
SIST EN 16728:2016/oprA1:2017
DRAFT
EUROPEAN STANDARD
EN 16728:2016
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2017
ICS 23.020.35
English Version
LPG equipment and accessories - Transportable refillable
LPG cylinders other than traditional welded and brazed
steel cylinders - Periodic inspection
Équipements pour GPL et leurs accessoires - Bouteilles Flüssiggas-Geräte und Ausrüstungsteile -
transportables et rechargeables pour GPL autres que Ortsbewegliche, wiederbefüllbare Flaschen für
celles en acier soudé et brasé - Contrôle périodique Flüssiggas (LPG), ausgenommen geschweißte und
hartgelötete Stahlflaschen - Wiederkehrende
Inspektion
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 286.
This draft amendment A1, if approved, will modify the European Standard EN 16728:2016. If this draft becomes an amendment,
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 16728:2016/prA1:2017 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 16728:2016/oprA1:2017
EN 16728:2016/prA1:2017 (E)
Contents Page
European foreword . 3
1 Modification to Clause 3. 4
2 Modification to 4.1 . 4
3 Modification to 5.3.1 . 4
4 Modification to 5.3.2.4 . 4
5 Modification to 5.3.3.2.1 . 4
6 Modification to 5.3.3.2.2 . 5
7 Modification to 6.2 . 5
8 Modification to Clause 7. 5
9 Modification to A.1 .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.