ASTM D3338-95
(Test Method)Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels
Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels
SCOPE
1.1 This test method covers the estimation of the net heat of combustion (megajoules per kilogram or Btu per pound) of aviation gasolines and aircraft turbine and jet engine fuels.
1.2 This test method is purely empirical and is applicable to liquid hydrocarbon fuels that conform to the specifications for aviation gasolines or aircraft turbine and jet engine fuels of grades Jet A, Jet A-1, Jet B, JP-4, JP-5, JP-7, and JP-8.
Note 1--The experimental data on heat of combustion from which the Test Method D3338 correlation was devised was obtained by a precision method similar to Test Method D4809.
Note 2--The estimation of the net heat of combustion of a hydrocarbon fuel is justifiable only when the fuel belongs to a well-defined class for which a relation between heat of combustion and aromatic and sulfur contents, density, and distillation range of the fuel has been derived from accurate experimental measurements on representative samples of that class. Even in this case, the possibility that the estimates may be in error by large amounts for individual fuels should be recognized. The fuels used to establish the correlation presented in this method are defined as follows:
Fuels:
Aviation gasoline-Grades 100/130 and 115/145 (1,2)
Kerosines, alkylates, and special WADC fuels (3)
Pure hydrocarbons-paraffins, naphthenes, and aromatics (4)
Fuels for which data were reported by the Coordinating Research Council (5).
1.3 Although the test method permits the calculation of net heat of combustion in either SI or inch-pound units, SI units are the preferred units.
1.4 The net heat of combustion can also be estimated in inch-pound units by Test Method D1405 or in SI units by Test Method D4529. Test Method D1405 requires calculation of one of four equations dependent on the fuel type with a precision equivalent to that of this test method. Test Method D4529 requires calculation of a single equation for all aviation fuels with a precision equivalent to that of this test method. Unlike D1405 and D4529, D3338 does not require the use of aniline point.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
General Information
Relations
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or discontinued.
Contact ASTM International (www.astm.org) for the latest information.
Designation: D 3338 – 95 An American National Standard
Standard Test Method for
1
Estimation of Net Heat of Combustion of Aviation Fuels
This standard is issued under the fixed designation D 3338; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (e) indicates an editorial change since the last revision or reapproval.
This standard has been approved for use by agencies of the Department of Defense.
1. Scope safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appro-
1.1 This test method covers the estimation of the net heat of
priate safety and health practices and determine the applica-
combustion (megajoules per kilogram or Btu per pound) of
bility of regulatory limitations prior to use.
aviation gasolines and aircraft turbine and jet engine fuels.
1.2 This test method is purely empirical and is applicable to
2. Referenced Documents
liquid hydrocarbon fuels that conform to the specifications for
2.1 ASTM Standards:
aviation gasolines or aircraft turbine and jet engine fuels of
3
D 86 Test Method for Distillation of Petroleum Products
grades Jet A, Jet A-1, Jet B, JP-4, JP-5, JP-7, and JP-8.
D 240 Test Method for Heat of Combustion of Liquid
3
NOTE 1—The experimental data on heat of combustion from which the
Hydrocarbon Fuels by Bomb Calorimeter
Test Method D 3338 correlation was devised was obtained by a precision
D 1266 Test Method for Sulfur in Petroleum Products
method similar to Test Method D 4809.
3
(Lamp Method)
NOTE 2—The estimation of the net heat of combustion of a hydrocar-
D 1298 Test Method for Density, Relative Density (Specific
bon fuel is justifiable only when the fuel belongs to a well-defined class
Gravity), or API Gravity of Crude Petroleum and Liquid
for which a relation between heat of combustion and aromatic and sulfur
3
contents, density, and distillation range of the fuel has been derived from Petroleum Products by Hydrometer Method
accurate experimental measurements on representative samples of that
D 1319 Test Method for Hydrocarbon Types in Liquid
class. Even in this case, the possibility that the estimates may be in error 3
Petroleum Products by Fluorescent Indicator Adsorption
by large amounts for individual fuels should be recognized. The fuels used
D 1405 Test Method for Estimation of Net Heat of Com-
to establish the correlation presented in this method are defined as follows:
3
bustion of Aviation Fuels
Fuels:
2
D 1552 Test Method for Sulfur in Petroleum Products
Aviation gasoline—Grades 100/130 and 115/145 (1, 2)
3
(High–Temperature Method)
Kerosines, alkylates, and special WADC fuels (3)
Pure hydrocarbons—paraffins, naphthenes, and aromatics (4)
D 2622 Test Method for Sulfur in Petroleum Products by
4
Fuels for which data were reported by the Coordinating Research
X-Ray Spectrometry Method
Council (5).
D 3120 Test Method for Trace Quantities of Sulfur in Light
1.3 Although the test method permits the calculation of net Liquid Petroleum Hydrocarbons by Oxidative Microcou-
4
heat of combustion in either SI or inch-pound units, SI units are
lometry
the preferred units. D 4052 Test Method for Density and Relative Density of
4
1.4 The net heat of combustion can also be estimated in
Liquids by Digital Density Meter
inch-pound units by Test Method D 1405 or in SI units by Test
D 4294 Test Method for Sulfur in Petroleum Products by
5
Method D 4529. Test Method D 1405 requires calculation of Non-Dispersive X-Ray Fluorescence Spectrometry
one of four equations dependent on the fuel type with a
D 4529 Test Method for Estimation of Net Heat of Com-
4
precision equivalent to that of this test method. Test Method bustion of Aviation Fuels
D 4529 requires calculation of a single equation for all aviation
D 4809 Test Method for Heat of Combustion of Liquid
fuels with a precision equivalent to that of this test method. Hydrocarbon Fuels by Bomb Calorimeter (Intermediate
5
Unlike D 1405 and D 4529, D 3338 does not require the use of
Precision Method)
aniline point.
3. Terminology
1.5 This standard does not purport to address all of the
3.1 Definitions:
3.1.1 gross heat of combustion, Qg (MJ/kg)—the quantity of
1
This test method is under the jurisdiction of ASTM Committee D-2 on
energy released when a unit mass of fuel is burned in a constant
Petroleum Products and Lubricants and is the direct responsibility of Subcommittee
D02.05.B on Calorimetry of Liquid Hydrocarbon Fuels.
Current edition approved Dec. 10, 1995. Published February 1996. Originally
3
published as D 3338 – 74. Last previous edition D 3338 – 91. Annual Book of ASTM Standards, Vol 05.01.
2 4
The boldface number in parentheses r
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.