EN ISO 11591:2000

Small craft, engine-driven - Field of vision from helm position (ISO 11591:2000)

Migrated from Progress Sheet (TC Comment) (2000-07-10): Launching of second FV (see BT C92/1996). ++ SPP update 1998-07-16

Motorgetriebene kleine Wasserfahrzeuge - Sichtfeld vom Steuerstand (ISO 11591:2000)

Diese Internationale Norm legt Forderungen an das Sichtfeld vom Steuerstand aus nach vorn und hinten in motorgetriebenen kleinen Wasserfahrzeugen mit einer Rumpflänge bis 24 m fest.

Petits navires à moteur - Champ de visibilité au niveau du poste de pilotage (ISO 11591:2000)

La présente Norme internationale fixe les prescriptions relatives au champ de visibilité vers l'avant et vers l'arrière à partir du poste de pilotage des navires de plaisance à moteur dont la coque ne dépasse pas 24 m de longueur.  Elle n'est pas applicable aux voiliers, ni aux navires à barre franche dont la vitesse maximale est inférieure à 10 km (10 noeuds).  
NOTE Selon la façon dont les navires de plaisance à moteur sont pilotés et selon leur vitesse, ils peuvent être soumis à des angles d'assiette tels que la visibilité vers l'avant est temporairement occultée. La présente Norme internationale ne peut pas garantir qu'un navire peut être manceuvré sans risque de perte de visibilité temporaire au niveau du poste de pilotage, lorsque le navire prend des angles d'assiette importants en passant du mode déplacement au mode planant.

Mala plovila na motorni pogon - Vidno polje izza krmilne mize (ISO 11591:2000)

General Information

• Status: Withdrawn
• Publication Date: 14-Dec-2000
• Withdrawal Date: 14-Sep-2011
• ICS: 47.080 - Small craft
• Technical Committee: CEN/SS T01 - Shipbuilding and maritime structures
• Drafting Committee: CEN/SS T01 - Shipbuilding and maritime structures
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 15-Sep-2011
• Completion Date: 15-Sep-2011
• Directive: 2003/44/EC - Approximation of the laws, regulations and administrative provisions of the Member States relating to recreational craft
• Directive: 94/25/EC - Directive 94/25/EC of the European Parliament and of the Council of 16 June 1994 on the approximation of the laws, regulations and administrative provisions of the Member States relating to recreational craft
• Mandate: M/075 - Revised mandate to CEN for standardization in the field of recreational craft
• Ref Project: SIST EN ISO 11591:2001 - Small craft, engine-driven - Field of vision from helm position (ISO 11591:2000)

Relations

• Replaced By: EN ISO 11591:2011 - Small craft, engine-driven - Field of vision from helm position (ISO 11591:2011)
• Effective Date: 24-Sep-2011

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 11591:2001
01-junij-2001
Mala plovila na motorni pogon - Vidno polje izza krmilne mize (ISO 11591:2000)
Small craft, engine-driven - Field of vision from helm position (ISO 11591:2000)
Motorgetriebene kleine Wasserfahrzeuge - Sichtfeld vom Steuerstand (ISO 11591:2000)
Petits navires a moteur - Champ de visibilité au niveau du poste de pilotage (ISO
11591:2000)
Ta slovenski standard je istoveten z: EN ISO 11591:2000
ICS:
47.080 ýROQL Small craft
SIST EN ISO 11591:2001 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 11591:2001

---------------------- Page: 2 ----------------------

SIST EN ISO 11591:2001

---------------------- Page: 3 ----------------------

SIST EN ISO 11591:2001

---------------------- Page: 4 ----------------------

SIST EN ISO 11591:2001
INTERNATIONAL ISO
STANDARD 11591
First edition
2000-12-15
Smallcraft,engine-driven— Field of vision
from helm position
Petits navires à moteur — Champ de visibilité au niveau du poste de
pilotage
Reference number
ISO 11591:2000(E)
©
ISO 2000

---------------------- Page: 5 ----------------------

SIST EN ISO 11591:2001
ISO 11591:2000(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2000
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.ch
Printed in Switzerland
ii © ISO 2000 – All rights reserved

---------------------- Page: 6 ----------------------

SIST EN ISO 11591:2001
ISO 11591:2000(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 11591 was prepared by Technical Committee ISO/TC 188, Small craft.
© ISO 2000 – All rights reserved iii

---------------------- Page: 7 ----------------------

SIST EN ISO 11591:2001

---------------------- Page: 8 ----------------------

SIST EN ISO 11591:2001
INTERNATIONAL STANDARD ISO 11591:2000(E)
Smallcraft,engine-driven — Fieldofvisionfromhelm position
1 Scope
This International Standard specifies requirements for the field of vision from the helm position, forward and astern,
in small engine-driven craft of hull length up to 24 m.
The following craft are exempt from the application of this International Standard:
� sailboats;
� tiller-steered craft (2.9) with maximum speed less than 10 kn (10 knots).
NOTE Small engine-driven craft can be operated in a manner and at certain speeds causing trim angles such that vision
forward is temporarily obscured. This International Standard cannot assure that a craft can be operated without some temporary
...