EN 6059-502:2009

Aerospace series - Electrical cables, installation - Protection sleeves - Test methods - Part 502: Resistance to electrical arcs

This European Standard specifies a method of assessing the behaviour of protection sleeves or conduits subject to an external electric arc, ever at 115 Vac or 230 Vac 400 Hz.
This European Standard shall be used together with EN 6059-100.
The primary aim of this test is to produce, in a controlled fashion, electric arcs at the immediate vicinity of a protection sleeve or conduit and to examine possible consequences on cables inside this protection, which are supposed to be maintained in a safe condition. These electric arcs are representative of those, which may occur in service when a typical cable bundle is severely damaged.
In order to optimize thickness and mass of such protection, it is necessary to associate a current limit In to each sleeves or conduits construction.
Two levels of prospective fault current are specified for all protection sizes.

Luft- und Raumfahrt - Elektrische Leitungen, Installation - Schutzschläuche - Prüfverfahren - Teil 502: Lichtbogenfestigkeit

Diese Norm legt ein Verfahren zur Beurteilung des Verhaltens von Schutzschläuchen oder -rohren gegenüber
einem von außen einwirkenden elektrischen Lichtbogen bei jeweils 115 V oder 230 V Wechselspannung
400 Hz fest.
Diese Norm muss in Verbindung mit EN 6059-100 angewendet werden.
Der Hauptzweck dieser Prüfung besteht darin, in unmittelbarer Nähe eines Schutzschlauches oder -rohres auf
geregelte Weise Lichtbögen zu erzeugen und mögliche Auswirkungen auf die innerhalb dieses Schutzes
befindlichen Leitungen zu untersuchen, die in einem sicheren Zustand beibehalten werden sollen. Diese Lichtbögen
sind repräsentativ für die Lichtbögen, die während des Betriebes auftreten können, wenn ein typisches
Leitungsbündel stark beschädigt ist.
Um die Dicke und Masse eines derartigen Schutzes zu optimieren, ist es erforderlich, jedem Aufbau von
Schutzschläuchen oder -rohren einen Grenzstrom In zuzuordnen.
Zwei Werte für einen unbeeinflussten Fehlerstrom wurden für alle Größen von Schutzschläuchen/-rohren festgelegt.

Série aérospatiale - Câbles électriques, installation - Gaines de protection - Méthodes d'essais - Partie 502: Résistance aux arcs électriques

Aeronavtika - Električni kabli, namestitev - Zaščitne obojke - Preskusne metode - 502. del: Odpornost proti električnim oblokom

General Information

• Status: Withdrawn
• Publication Date: 15-Sep-2009
• Withdrawal Date: 09-Dec-2014
• ICS: 49.060 - Aerospace electric equipment and systems
• Technical Committee: ASD-STAN - Aerospace
• Drafting Committee: ASD-STAN/D 2 - Electrical
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 30-Jun-2017
• Ref Project: SIST EN 6059-502:2009 - Aerospace series - Electrical cables, installation - Protection sleeves - Test methods - Part 502: Resistance to electrical arcs

Relations

• Replaced By: EN 6059-502:2014 - Aerospace series - Electrical cables, installation - Protection sleeves - Test methods - Part 502: Resistance to electrical arcs
• Effective Date: 17-Dec-2014

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 6059-502:2009
01-november-2009
$HURQDYWLND(OHNWULþQLNDEOLQDPHVWLWHY=DãþLWQHRERMNH3UHVNXVQHPHWRGH
GHO2GSRUQRVWSURWLHOHNWULþQLPREORNRP
Aerospace series - Electrical cables, installation - Protection sleeves - Test methods -
Part 502: Resistance to electrical arcs
Luft- und Raumfahrt - Elektrische Leitungen, Installation - Schutzschläuche -
Prüfverfahren - Teil 502: Lichtbogenfestigkeit
Série aérospatiale - Câbles électriques, installation - Gaines de protection - Méthodes
d'essais - Partie 502: Résistance aux arcs électriques
Ta slovenski standard je istoveten z: EN 6059-502:2009
ICS:
49.060 /HWDOVNDLQYHVROMVND Aerospace electric
HOHNWULþQDRSUHPDLQVLVWHPL equipment and systems
SIST EN 6059-502:2009 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 6059-502:2009

---------------------- Page: 2 ----------------------

SIST EN 6059-502:2009


EUROPEAN STANDARD
EN 6059-502

NORME EUROPÉENNE

EUROPÄISCHE NORM
September 2009
ICS 49.060
English Version
Aerospace series - Electrical cables, installation - Protection
sleeves - Test methods - Part 502: Resistance to electrical arcs
Série aérospatiale - Câbles électriques, installation - Luft- und Raumfahrt - Elektrische Leitungen, Installation -
Gaines de protection - Méthodes d'essais - Partie 502: Schutzschläuche - Prüfverfahren - Teil 502:
Résistance aux arcs électriques Lichtbogenfestigkeit
This European Standard was approved by CEN on 30 July 2009.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.






EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 6059-502:2009: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 6059-502:2009
EN 6059-502:2009 (E)
Contents Page
Foreword .3
1 Scope .4
2 Normative references .4
3 Specimen requirements .4
4 Definition and preparation of specimen .5
5 Apparatus .9
6 Method . 12
7 Requirements . 13

2

---------------------- Page: 4 ----------------------

SIST EN 6059-502:2009
EN 6059-502:2009 (E)
Foreword
This document (EN 6059-502:2009) has been prepared by the Aerospace and Defence Industries Association
of Europe - Standardization (ASD-STAN).
After enquiries and votes carried out in accordance with the rules of this Association, this Standard has
received the approval of the National Associations and the Official Services of the member countries of ASD,
prior to its presentation to CEN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by March 2010, an
...