prEN ISO 28300
(Main)Venting atmospheric and low-pressure storage tanks (ISO/DIS 28300:2025)
Venting atmospheric and low-pressure storage tanks (ISO/DIS 28300:2025)
ISO 28300:2008 covers the normal and emergency vapour venting requirements for aboveground liquid petroleum or petroleum products storage tanks and aboveground and underground refrigerated storage tanks designed as atmospheric storage tanks or low-pressure storage tanks. Discussed in ISO 28300:2008 are the causes of overpressure and vacuum; determination of venting requirements; means of venting; selection, and installation of venting devices; and testing and marking of relief devices.
ISO 28300:2008 is intended for tanks containing petroleum and petroleum products but it can also be applied to tanks containing other liquids; however, it is necessary to use sound engineering analysis and judgment whenever ISO 28300:2008 is applied to other liquids.
ISO 28300:2008 does not apply to external floating-roof tanks.
Be- und Entlüftung von Lagertanks mit atmosphärischem Druck und niedrigem Überdruck (ISO/DIS 28300:2025)
Ventilation des réservoirs de stockage à pression atmosphérique et à basse pression (ISO/DIS 28300:2025)
L'ISO 28300:2008 couvre les exigences de ventilation de vapeur (gaz), normale et en situation d'urgence, des réservoirs de surface de stockage de pétrole liquide et de produits pétroliers et des réservoirs de surface et enterrés de stockage réfrigérés (frigorifiques), conçus comme réservoirs de stockage à pression atmosphérique et à basse pression. Elle aborde les causes de surpression et de dépression, la détermination des exigences de ventilation, les moyens de ventilation, le choix et l'installation des dispositifs de ventilation ainsi que les essais et le marquage des limiteurs de pression.
L'ISO 28300:2008 concerne les réservoirs contenant du pétrole et des produits pétroliers, mais peut également s'appliquer aux réservoirs contenant d'autres liquides. Il est cependant nécessaire d'utiliser une analyse et un raisonnement techniques solides lorsqu'elle est appliquée à d'autres liquides.
L'ISO 28300:2008 ne s'applique pas aux réservoirs extérieurs à toit flottant.
Prezračevanje atmosferskih in nizkotlačnih rezervoarjev za shranjevanje (ISO/DIS 28300:2025)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-december-2025
Prezračevanje atmosferskih in nizkotlačnih rezervoarjev za shranjevanje (ISO/DIS
28300:2025)
Venting atmospheric and low-pressure storage tanks (ISO/DIS 28300:2025)
Be- und Entlüftung von Lagertanks mit atmosphärischem Druck und niedrigem
Überdruck (ISO/DIS 28300:2025)
Ventilation des réservoirs de stockage à pression atmosphérique et à basse pression
(ISO/DIS 28300:2025)
Ta slovenski standard je istoveten z: prEN ISO 28300
ICS:
75.180.20 Predelovalna oprema Processing equipment
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT
International
Standard
ISO/DIS 28300
ISO/TC 67/SC 6
Venting atmospheric and low-
Secretariat: AFNOR
pressure storage tanks
Voting begins on:
ICS: 75.180.20
2025-09-02
Voting terminates on:
2025-11-25
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENTS AND APPROVAL. IT
IS THEREFORE SUBJECT TO CHANGE
AND MAY NOT BE REFERRED TO AS AN
INTERNATIONAL STANDARD UNTIL
PUBLISHED AS SUCH.
This document has not been edited by the ISO Central Secretariat.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
ISO/CEN PARALLEL PROCESSING
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS.
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION.
Reference number
ISO/DIS 28300:2025(en)
DRAFT
ISO/DIS 28300:2025(en)
International
Standard
ISO/DIS 28300
ISO/TC 67/SC 6
Venting atmospheric and low-
Secretariat: AFNOR
pressure storage tanks
Voting begins on:
ICS: 75.180.20
Voting terminates on:
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENTS AND APPROVAL. IT
IS THEREFORE SUBJECT TO CHANGE
AND MAY NOT BE REFERRED TO AS AN
INTERNATIONAL STANDARD UNTIL
PUBLISHED AS SUCH.
This document has not been edited by the ISO Central Secretariat.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
© ISO 2025
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
STANDARDS MAY ON OCCASION HAVE TO
ISO/CEN PARALLEL PROCESSING
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
BE CONSIDERED IN THE LIGHT OF THEIR
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
or ISO’s member body in the country of the requester.
NATIONAL REGULATIONS.
ISO copyright office
RECIPIENTS OF THIS DRAFT ARE INVITED
CP 401 • Ch. de Blandonnet 8
TO SUBMIT, WITH THEIR COMMENTS,
CH-1214 Vernier, Geneva
NOTIFICATION OF ANY RELEVANT PATENT
Phone: +41 22 749 01 11
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION.
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland Reference number
ISO/DIS 28300:2025(en)
ii
ISO/DIS 28300:2025(en)
Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative References . 1
3 Terms, Definitions, and Abbreviated Terms . 1
4 Nonrefrigerated Aboveground Tanks . 4
4.1 General .4
4.2 Causes of Overpressure or Vacuum .4
4.2.1 General .4
4.2.2 Liquid Movement into or out of a Tank .4
4.2.3 Weather Changes .5
4.2.4 Fire Exposure .5
4.2.5 Other Circumstances .5
4.3 Determination of Venting Requirements .7
4.3.1 General .7
4.3.2 Calculation of Required Flow Capacity for Normal Out-breathing and Inbreathing .8
4.3.3 Required Flow Capacity for External Fire Exposure (Emergency Venting) . 12
4.4 Means of Venting .18
4.4.1 Normal Venting .18
4.4.2 Emergency Venting.19
4.5 Considerations for Tanks with Potentially Flammable Atmospheres.19
4.5.1 General .19
4.5.2 Design Options for Explosion Prevention . 20
4.5.3 Inert-gas-blanketed Tanks. 20
4.5.4 Flame Propagation Through Pressure/Vacuum Valves . 20
4.6 Relief-device Specification .21
4.6.1 Sizing Basis .21
4.6.2 Pressure and Vacuum Setting .21
4.6.3 Design . 22
4.6.4 Materials of Construction . 22
4.7 Installation of Venting Devices and Open Vents . 22
4.7.1 General . 22
4.7.2 Discharge Piping . 23
4.7.3 Set Pressure Verification . 23
4.7.4 Installation . 23
4.7.5 Inspection and Maintenance.24
5 Refrigerated Aboveground and Belowground Tanks.24
5.1 General .24
5.2 Causes of Overpressure or Vacuum .24
5.2.1 Modified Guidelines .24
5.2.2 Additional Guidelines for Overpressure . 26
5.2.3 Additional Guidelines for Vacuum .27
5.3 Relief-device Specification . 28
5.4 Installation of Venting Devices . 28
5.4.1 General . 28
5.4.2 Installation of Pressure- and Vacuum-relief Devices . 28
5.4.3 Discharge Piping . 28
6 Testing of Venting Devices .28
6.1 General . 28
6.2 Flow-test Apparatus . 29
6.2.1 General . 29
6.2.2 Test Medium Supply. 29
6.2.3 Flow-measuring Device . 29
iii
ISO/DIS 28300:2025(en)
6.2.4 Test Tank. 29
6.2.5 Pressure/Vacuum-measuring Device . 30
6.2.6 Temperature-measuring Device . 30
6.2.7 Barometer . . 30
6.3 Method for Determining Capacities .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.