EN ISO 8835-3:2007

Inhalational anaesthesia systems - Part 3: Transfer and receiving systems of active anaesthetic gas scavenging systems (ISO 8835-3:2007)

ISO 8835-3:2007 specifies requirements for transfer and receiving systems of active anaesthetic gas scavenging systems (active AGSSs) intended to reduce exposure of healthcare personnel to anaesthetic gases and vapours while providing patient protection (e.g. against excessive flow and pressure). ISO 8835-3:2007 also specifies requirements for transfer and receiving systems of active anaesthetic gas scavenging systems in which the power device is integral with the transfer and receiving system.

Systeme für die Inhalationsanästhesie - Teil 3: Weiterleitungs- und Aufnahmesysteme von aktiven Anästhesiegas-Fortleitungssystemen (ISO 8835-3:2007)

Dieser Teil von ISO 8835 legt Anforderungen für Weiterleitungs  und Aufnahmesysteme von aktiven Anästhesiegas-Fortleitungssystemen (aktive AGFS) fest, deren Ziel es ist, die Exposition des medizinischen Personals gegenüber Anästhesiegasen und  dämpfen zu verringern und gleichzeitig den Patienten zu schützen (z. B. gegen übermäßigen Gasdurchfluss und Druck). Dieser Teil von ISO 8835 legt auch Anforderungen für Weiterleitungs- und Aufnahmesysteme von aktiven Anästhesiegas-Fortleitungssystemen fest, in denen die Antriebseinrichtung in das Weiterleitungs  und Aufnahmesystem integriert ist.
Dieser Teil von ISO 8835 legt keine Anforderungen fest für
   Entsorgungssysteme, die in ISO 7396-2 behandelt werden,
   nichtaktive AGFS (passive AGFS),
   in der Nähe untergebrachte Gasfortleitungssysteme (d. h. Systeme, die nicht direkt an das Atemsystem angeschlossen sind, oder zugehörige Geräte),
   Weiterleitungs  und Aufnahmesysteme, die für die Verwendung mit brennbaren Anästhesiemitteln nach IEC 60601-2-13:2003, Anhang DD, bestimmt sind.

Systèmes d'anesthésie par inhalation - Partie 3: Systèmes de transfert et de réception des systèmes d'évacuation des gaz d'anesthésie (ISO 8835-3:2007)

L'ISO 8835-3:2007 spécifie les exigences relatives aux systèmes de transfert et aux systèmes de réception des systèmes d'évacuation des gaz d'anesthésie actifs (SEGA actifs), conçus pour réduire l'exposition du personnel de santé aux gaz et aux vapeurs d'anesthésie, tout en protégeant le patient (par exemple contre une pression ou un débit de gaz excessifs). L'ISO 8835-3:2007 spécifie également les exigences applicables aux systèmes de transfert et de réception des systèmes d'évacuation des gaz d'anesthésie actifs dans lesquels la source d'alimentation fait partie intégrante du système de transfert et de réception.

Inhalacijski anestezijski sistemi - 3. del: Sistemi za prenos in sprejem sistemov za odstranjevanje anestezijskih plinov (ISO 8835-3:2007)

General Information

• Status: Withdrawn
• Publication Date: 14-Aug-2007
• Withdrawal Date: 17-Mar-2009
• ICS: 11.040.10 - Anaesthetic, respiratory and reanimation equipment
• Technical Committee: CEN/TC 215 - Respiratory and anaesthetic equipment
• Drafting Committee: CEN/TC 215 - Respiratory and anaesthetic equipment
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 18-Mar-2009
• Completion Date: 18-Mar-2009
• Directive: 93/42/EEC - Council Directive 93/42/EEC of 14 June 1993 concerning medical devices
• Mandate: M/023 - Standardization mandate to CEN/CENELEC concerning the development of European standards relating to medical devices
• Ref Project: SIST EN ISO 8835-3:2008 - Inhalational anaesthesia systems - Part 3: Transfer and receiving systems of active anaesthetic gas scavenging systems (ISO 8835-3:2007)

Relations

• Replaces: EN 740:1998 - Anaesthetic workstations and their modules - Particular requirements
• Effective Date: 22-Dec-2008
• Replaces: EN 740:1998/A1:2004 - Anaesthetic workstations and their modules - Particular requirements
• Effective Date: 22-Dec-2008
• Replaces: EN 740:1998/AC:1998 - Anaesthetic workstations and their modules - Particular requirements
• Effective Date: 22-Dec-2008
• Replaced By: EN ISO 8835-3:2009 - Inhalational anaesthesia systems - Part 3: Transfer and receiving systems of active anaesthetic gas scavenging systems (ISO 8835-3:2007)
• Effective Date: 23-Mar-2009

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 8835-3:2008
01-april-2008
1DGRPHãþD
SIST EN 740:2000
SIST EN 740:2000/A1:2005
SIST EN 740:2000/AC:2000
Inhalacijski anestezijski sistemi - 3. del: Sistemi za prenos in sprejem sistemov za
odstranjevanje anestezijskih plinov (ISO 8835-3:2007)
Inhalational anaesthesia systems - Part 3: Transfer and receiving systems of active
anaesthetic gas scavenging systems (ISO 8835-3:2007)
Systeme für die Inhalationsanästhesie - Anästhesiegas-Fortleitungssysteme - Teil 3:
Weiterleitungs- und Aufnahmesysteme von aktiven Anästhesiegas-Fortleitungssystemen
(ISO 8835-3:2007)
Systemes d'anesthésie par inhalation - Partie 3: Systemes de transfert et de réception
des systemes d'évacuation des gaz d'anesthésie (ISO 8835-3:2007)
Ta slovenski standard je istoveten z: EN ISO 8835-3:2007
ICS:
11.040.10
SIST EN ISO 8835-3:2008 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

EUROPEAN STANDARD
EN ISO 8835-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
August 2007
ICS 11.040.10 Supersedes EN 740:1998
English Version
Inhalational anaesthesia systems - Part 3: Transfer and
receiving systems of active anaesthetic gas scavenging systems
(ISO 8835-3:2007)
Systèmes d'anesthésie par inhalation - Partie 3: Systèmes Systeme für die Inhalationsanästhesie - Teil 3:
de transfert et de réception des systèmes d'évacuation des Weiterleitungs- und Aufnahmesysteme von aktiven
gaz d'anesthésie (ISO 8835-3:2007) Anästhesiegas-Fortleitungssystemen (ISO 8835-3:2007)
This European Standard was approved by CEN on 9 June 2007.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2007 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 8835-3:2007: E
worldwide for CEN national Members.

---------------------- Page: 2 ----------------------

EN ISO 8835-3:2007 (E)

Foreword

This document (EN ISO 8835-3:2007) has been prepared by Technical Committee ISO/TC
121 "Anaesthetic and respiratory equipment" in collaboration with Technical Committee
CEN/TC 215 "Respiratory and anaesthetic equipment", the secretariat of which is held by
BSI.

This European Standard shall be given the status of a national standard, either by publication
of an identical text or by endorsement, at the latest by February 2008, and conflicting national
standards shall be withdrawn at the latest by May 2009.
This document has been prepared under a mandate given to CEN by the European
Commission and the European Free Trade Association, and supports essential requirements
of EU Directive(s).

For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of
this document.

Other European Standards relating to anaesthetic workstations and their components
prepared by CEN/TC 215 which, together with EN 60601-2-13:2006, replace EN 740:1998 in
total, are:
– EN ISO 8835-2:2007, Inhalational anaesthesia systems – Part 2: Anaesthetic breathing
systems (ISO 8835-2:2007)
– EN ISO 8835-3:2007, Inhalational anaesthesia systems – Part 3: Transfer and receiving
systems of active anaesthetic gas scavenging systems (ISO 8835-3:2007)
– EN ISO 8835-4:2004, Inhalational anaesthesia systems – Part 4: Anaesthetic vapour
delivery devices (ISO 8835-4:2004)
– EN ISO 8835-5:2004, Inhalational anaesthesia systems – Part 5: Anaesthetic ventilators
(ISO 8835-5:2004)
Attention is also drawn to ISO/TS 18835:2004, Inhalational anaesthesia systems — Draw-
over vaporizers and associated equipment.

Attention is drawn to the possibility that some of the elements of this document may be the
subject of patent rights. CEN shall not be held responsible for identifying any or all such
patent rights.

According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the follow
...