EN 17678-2:2023
(Main)Installation of post-tensioning kits for prestressing of structures - Part 2: Assessment of personnel
Installation of post-tensioning kits for prestressing of structures - Part 2: Assessment of personnel
This document specifies the scheme for assessment and verification of competence of personnel installing post-tensioning kits.
The document provides provisions for the training providers, assessment bodies and possible certification bodies.
Requirements to the minimum competence and experience for personnel installing post-tensioning kits are given in EN 17678-1.
This document can be amended with a national annex where indicated in the text.
Anwendung von Spannverfahren für das Vorspannen von Tragwerken - Teil 2: Bewertung der Personalkompetenz
Dieses Dokument legt das Schema für Bewertung und Verifizierung der Kompetenz von Personal, das PT-Bausätze einbaut, fest.
Das Dokument enthält Bestimmungen für die Ausbildungsanbieter, Bewertungsstellen und möglichen Zertifizierungsstellen.
Anforderungen an die Mindestkompetenz und -erfahrung des Personals, das PT-Bausätze einbaut, sind in EN 17678-1 enthalten.
Dieses Dokument kann durch einen nationalen Anhang ergänzt werden, wenn dies im Text angegeben ist.
Mise en œuvre de kits de post-tension pour la précontrainte des structures - Partie 2 : Évaluation du personnel
Le présent document spécifie le plan pour l’évaluation et la vérification des compétences du personnel chargé de la mise en œuvre des kits de précontrainte par post-tension.
Il fournit des dispositions pour les organismes de formation, les organismes d’évaluation et les éventuels organismes de certification.
Les compétences et l’expérience minimales que doit avoir le personnel chargé de la mise en œuvre des kits de précontrainte par post-tension sont indiquées dans l'EN 17678-1.
Le présent document peut être modifié par une annexe nationale lorsque cela est indiqué dans le texte.
Vgradnja sistemov za naknadno prednapenjanje konstrukcij - 2. del: Ocenjevanje usposobljenosti osebja
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN 17678-2:2022
01-junij-2022
Vgradnja sistemov za naknadno prednapenjanje konstrukcij - 2. del: Ocenjevanje
usposobljenosti osebja
Installation of post-tensioned kits for prestressing of structures – Part 2: Assessment of
personnel
Ausführung von Arbeiten von Spannverfahren mit nachträglichem Verbund in
Tragwerken - Teil 2: Bewertung der Personalkompetenz
Ta slovenski standard je istoveten z: prEN 17678-2
ICS:
03.100.30 Vodenje ljudi Management of human
resources
91.080.40 Betonske konstrukcije Concrete structures
oSIST prEN 17678-2:2022 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 17678-2:2022
---------------------- Page: 2 ----------------------
oSIST prEN 17678-2:2022
DRAFT
EUROPEAN STANDARD
prEN 17678-2
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2022
ICS 03.100.30; 91.080.40
English Version
Installation of post-tensioned kits for prestressing of
structures - Part 2: Assessment of personnel
Mise en œuvre de kits de post-tension pour la Ausführung von Arbeiten von Spannverfahren mit
précontrainte des structures - Partie 2 : Évaluation du nachträglichem Verbund in Tragwerken - Teil 2:
personnel Bewertung der Personalkompetenz
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 104.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 17678-2:2022 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 17678-2:2022
prEN 17678-2:2022 (E)
Contents
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Competence assessment for certification . 7
4.1 Training provider . 7
4.2 Assessment body . 8
4.3 Assessment of PT personnel following completion of training to agreed level . 8
4.4 Re-assessment of PT personnel . 8
5 Certificates . 9
2
---------------------- Page: 4 ----------------------
oSIST prEN 17678-2:2022
prEN 17678-2:2022 (E)
European foreword
This document (prEN 17678-2:2022) has been prepared by Technical Committee CEN/TC 104 “Concrete
and related products”, the secretariat of which is held by SN.
This document is currently submitted to the CEN Enquiry.
3
---------------------- Page: 5 ----------------------
oSIST prEN 17678-2:2022
prEN 17678-2:2022 (E)
Introduction
EN 17678-2 supersedes CEN Workshop Agreement CWA 14646:2003 “Requirements for the installation
of post-tensioning kits for prestressing of structures and qualification of specialist company and its
personnel” as concerns the parts related to assessment of personnel installing PT kits.
CWA 14646 recommended that the training provider should issue certificates attesting the acquired skill
of the PT personnel.
To ensure a general acceptance of such certificates, EN 17678-2 describes a procedure in accordance with
EN ISO/IEC 17024.
The main motivating factors for creating a European standard on competence of personnel and
assessment/ certification of their skills are:
— safety and quality considerations during the installation of the kits;
— safeguarding the integrity of structures during their service life;
— to facilitate free movement of PT personnel, both between PT specialist companies and member
states.
EN 17678 consists of two parts:
— Part 1 deals with the minimum requirements to competence personnel dealing with PT installations,
and on the tasks the personnel are qualified to undertake;
— Part 2 gives the framework for how to assess the competence of PT personnel and issue certificates
to candidates fulfilling the requirements.
4
---------------------- Page: 6 ----------------------
oSIST prEN 17678-2:2022
prEN 17678-2:2022 (E)
1 Scope
This document specifies the scheme for assessment and verification of competence of personnel
installing post-tensioning kits.
The document provides provisions for the training providers, assessment bodies and possible
certification bodies.
Requirements to the minimum competence and experience for personnel installing post-tensioning kits
are given in prEN 17678-1:2021.
This document may be amended with a national annex where indicated in the text.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
EN ISO/IEC 17024, Conformity assessment – General requirements for bodies operating certification of
persons
1
prEN 17678-1:2021, Installation of post-tensioned kits for prestressing of structures – Part 1: Competence
of personnel
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standar
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.