EN 60869-1:2013

Fibre optic interconnecting devices and passive components - Fibre optic passive power control devices - Part 1: Generic specification

IEC 60869-1:2012 applies to fibre optic power control devices. These have all of the following general features: - they are passive in that they contain no opto-electronic or other transducing elements; - they have two ports for the transmission of optical power and control the transmitted power in a fixed or variable fashion; - the ports are unconnectorized optical fibre tails or optical fibre pigtails with connectors. This standard establishes generic requirements for the following passive optical devices: - optical attenuator; - optical fuse; - optical power limiter. This fourth edition cancels and replaces the third edition, published in 1999, and constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: - the terms and definitions were reconsidered; - the requirement concerning the IEC Quality Assessment System was reconsidered; - the clause concerning quality assessment procedures was deleted. Keywords: fibre optic power control devices

Lichtwellenleiter - Verbindungselemente und passive Bauteile - Passive Bauteile zur Leistungsbegrenzung - Teil 1: Fachgrundspezifikation

Dispositifs d’interconnexion et composants passifs à fibres optiques - Dispositifs à fibres optiques passifs de contrôle de la puissance -- Partie 1: Spécification générique

La CEI 60869-1:2012 s'applique aux dispositifs de contrôle de la puissance à fibres optiques. Ceux-ci présentent toutes les caractéristiques générales suivantes: - ils sont passifs dans le sens où ils ne contiennent aucun élément optoélectronique ou autre élément transducteur; - ils disposent de deux ports pour la transmission de la puissance optique et ils contrôlent l'énergie transmise de manière fixe ou variable; - les ports sont des fibres amorces non-connectorisées ou des fibres amorces à fibres optiques avec connecteurs. La présente norme établit les exigences génériques pour les dispositifs optiques passifs suivants: - affaiblisseur optique; - fusible optique limiteur de puissance optique. Cette quatrième édition annule et remplace la troisième édition, parue en 1999, et constitue une révision technique. Cette édition inclut les modifications techniques majeures suivantes par rapport à l'édition précédente: - les termes et définitions ont été revus; - l'exigence concernant le système CEI d'assurance de la qualité a été revue; - l'article concernant les procédures d'assurance de la qualité a été supprimé. Mots clés: dispositifs de contrôle de la puissance à fibres optiques

Optični spojni elementi in pasivne komponente - Pasivne optične naprave za krmiljenje moči - 1. del: Rodovna specifikacija

Ta del standarda IEC 60869 velja za optične naprave za krmiljenje moči. Te imajo vse naslednje splošne značilnosti: – so pasivne in ne vsebujejo nobenih optoelektronskih ali drugih prevodnih elementov; – imajo dvoja vrata za prenos optične moči in nadzirajo preneseno moč na enoten ali spremenljiv način; – vrata so zaključni kabli iz optičnih vlaken brez konektorjev ali z njimi. Ta standard uvaja splošne zahteve za naslednje pasivne optične naprave: – optični atenuator; – optična varovalka; – omejevalnik optične moči. Preskusni in merilni postopki za zgornje izdelke so opisani v standardih IEC 61300-1, IEC skupine 61300-2 in skupine 61300-3.

General Information

• Status: Withdrawn
• Publication Date: 27-Jun-2013
• Withdrawal Date: 15-Jan-2014
• ICS: 33.180.20 - Fibre optic interconnecting devices
• Technical Committee: CLC/TC 86BXA - Fibre optic interconnect, passive and connectorised components
• Drafting Committee: IEC/SC 86B - IEC_SC_86B
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 21-Dec-2019
• Completion Date: 21-Dec-2019
• Ref Project: SIST EN 60869-1:2013 - Fibre optic interconnecting devices and passive components - Fibre optic passive power control devices - Part 1: Generic specification

Relations

• Replaces: EN 60869-1:2000 - Fibre optic attenuators - Part 1: Generic specification
• Effective Date: 29-Jan-2023
• Replaced By: EN IEC 60869-1:2018 - Fibre optic interconnecting devices and passive components - Fibre optic passive power control devices - Part 1: Generic specification
• Effective Date: 25-Dec-2018

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60869-1:2013
01-oktober-2013
2SWLþQLVSRMQLHOHPHQWLLQSDVLYQHNRPSRQHQWH3DVLYQHRSWLþQHQDSUDYH]D
NUPLOMHQMHPRþLGHO5RGRYQDVSHFLILNDFLMD
Fibre optic interconnecting devices and passive components - Fibre optic passive power
control devices - Part 1: Generic specification
Lichtwellenleiter - Verbindungselemente und passive Bauteile - Passive Geräte zur
Leistungsbegrenzung - Teil 1: Fachgrundspezifikation
Ta slovenski standard je istoveten z: EN 60869-1:2013
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 60869-1:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 60869-1:2013

---------------------- Page: 2 ----------------------

SIST EN 60869-1:2013

EUROPEAN STANDARD
EN 60869-1

NORME EUROPÉENNE
June 2013
EUROPÄISCHE NORM

ICS 33.180.20 Supersedes EN 60869-1:2000


English version


Fibre optic interconnecting devices and passive components -
Fibre optic passive power control devices -
Part 1: Generic specification
(IEC 60869-1:2012)


Dispositifs d’interconnexion et Lichtwellenleiter -
composants passifs à fibres optiques - Verbindungselemente und passive
Dispositifs à fibres optiques passifs de Bauteile -
contrôle de la puissance - Passive Geräte
Partie 1: Spécification générique zur Leistungsbegrenzung -
(CEI 60869-1:2012) Teil 1: Fachgrundspezifikation
(IEC 60869-1:2012)





This European Standard was approved by CENELEC on 2013-01-16. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60869-1:2013 E

---------------------- Page: 3 ----------------------

SIST EN 60869-1:2013
EN 60869-1:2013 - 2 -

Foreword
The text of document 86B/3505/FDIS, future edition 4 of IEC 60869-1, prepared by SC 86B, "Fibre optic
interconnecting devices and passive components", of IEC TC 86, "Fibre optics" was submitted to the
IEC-CENELEC parallel vote and approved by CENELEC as EN 60869-1:2013.

The following dates are fixed:
• latest date by which the document has (dop) 2013-12-28
to be implemented at national level by
publication of an identical national
standard or by endorsement
(dow) 2014-01-16
• latest date by which the national
standards conflicting with the

document have to be withdrawn

This document supersedes EN 60869-1:2000.
EN 60869-1:2013 includes the following significant technical changes with respect to EN 60869-1:2000:
– the terms and definitions were reconsidered;
– the requirement concerning the IEC Quality Assessment System was reconsidered;
– the clause concerning quality assessment procedures was deleted.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
Endorsement notice
The text of the International Standard IEC 60869-1:2012 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 61300-1 NOTE  Harmonised as EN 61300-1.
IEC 61754-4 NOTE  Harmonised as EN 61754-4.
IEC 61754-2 NOTE  Harmonised as EN 61754-2.
IEC 61754-13 NOTE  Harmonised as EN 61754-13.
IEC 61300-2 series NOTE  Harmonised in EN 61300-2 series.
IEC 61300-3 series NOTE  Harmonised in EN 61300-3 series.
IEC 61753-051-3 NOTE  H
...