EN 62150-3:2012
(Main)Fibre optic active components and devices - Test and measurement procedures - Part 3: Optical power variation induced by mechanical disturbance in optical receptacles and transceiver interfaces
Fibre optic active components and devices - Test and measurement procedures - Part 3: Optical power variation induced by mechanical disturbance in optical receptacles and transceiver interfaces
IEC 62150-3:2012 specifies the test requirements and procedures for qualifying optical devices for sensitivity to coupled power variations induced by mechanical disturbance at the optical ports of the device. It applies to active devices with optical receptacle interfaces. In this edition, transceivers using small-form-factor connector cables (1,25 mm ferrule) for single mode fibre are specified. Keywords: mechanical disturbances
Aktive Lichtwellenleiter-Bauteile und -Bauelemente - Grundlegende Prüf- und Messverfahren - Teil 3: Optische Leistungsabweichungen bedingt durch mechanische Störungen in optischen Kupplungen und Transceiver-Schnittstellen
Composants et dispositifs actifs à fibres optiques - Procédures d'essais et de mesures - Partie 3: Variation de puissance optique induite par des perturbations mécaniques dans les interfaces d'embases optiques et d'émetteurs-récepteurs
La CEI 62150-3:2012 spécifie les exigences d'essais et les procédures pour qualifier la sensibilité de dispositifs optiques à des variations de la puissance couplée induites par des perturbations mécaniques au niveau des ports optiques du dispositif. Elle s'applique aux dispositifs actifs dotés d'interfaces d'embases optiques. Dans la présente édition, on spécifie des émetteurs-récepteurs utilisant des câbles de connexion à petit facteur de forme (férule de 1,25 mm) pour des fibres unimodales. Mots clé: perturbations mécaniques
Aktivne optične komponente in naprave - Preskuševalni in merilni postopki - 3. del: Spreminjanje optične moči zaradi mehanskih motenj v optičnih sprejemnikih in oddajno-sprejemniških vmesnikih (IEC 62150-3:2012)
Namen tega dela standarda IEC 62150 je določiti preskusne zahteve in postopke za razvrstitev optičnih naprav glede na občutljivost spreminjanja moči, ki jih povzročajo mehanske motnje pri optičnih vhodih naprave. To velja za dejavne naprave z vmesniki optičnega sprejemnika. V tej izdaji so opredeljeni oddajniki-sprejemniki s priključnimi kabli SFF (tulka velikosti 1,25 mm) za enorodovno vlakno. Ugotovljeno je bilo, da so nekateri optični oddajniki-sprejemniki in sprejemniki med uporabo stranskih sil pri sestavu kabla in priključka občutljivi na napetost kabla iz optičnih vlaken zaradi sprememb v oddajani optični moči. Ta del standarda IEC 62150 določa preskuse fizične napetosti za zagotovitev nadaljnjega delovanja takšnih optičnih povezav (kabelskih in z vtičnico) v okviru specifikacij.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 62150-3:2012
01-november-2012
$NWLYQHRSWLþQHNRPSRQHQWHLQQDSUDYH3UHVNXãHYDOQLLQPHULOQLSRVWRSNL
GHO6SUHPLQMDQMHRSWLþQHPRþL]DUDGLPHKDQVNLKPRWHQMYRSWLþQLKVSUHMHPQLNLK
LQRGGDMQRVSUHMHPQLãNLKYPHVQLNLK,(&
Fibre optic active components and devices - Test and measurement procedures - Part 3:
Optical power variation induced by mechanical disturbance in optical receptacles and
transceiver interfaces (IEC 62150-3:2012)
Aktive Lichtwellenleiter-Bauteile und -Bauelemente - Grundlegende Prüf- und
Messverfahren - Teil 3: Optische Leistungsabweichungen bedingt durch mechanische
Störungen an Schnittstellen optischer Steckverbinder und Transceivern (IEC 62150-
3:2012)
Composants et dispositifs actifs à fibres optiques - Procédures d'essais et de mesures -
Partie 3: Variation de puissance optique induite par des perturbations mécaniques dans
les interfaces d'émetteurs-récepteurs et d'embases optiques (CEI 62150-3:2012)
Ta slovenski standard je istoveten z: EN 62150-3:2012
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 62150-3:2012 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 62150-3:2012
---------------------- Page: 2 ----------------------
SIST EN 62150-3:2012
EUROPEAN STANDARD
EN 62150-3
NORME EUROPÉENNE
September 2012
EUROPÄISCHE NORM
ICS 33.180.20
English version
Fibre optic active components and devices -
Test and measurement procedures -
Part 3: Optical power variation induced by mechanical disturbance in
optical receptacles and transceiver interfaces
(IEC 62150-3:2012)
Composants et dispositifs actifs à fibres Aktive Lichtwellenleiter-Bauteile und -
optiques - Bauelemente -
Procédures d'essais et de mesures - Grundlegende Prüf- und Messverfahren -
Partie 3: Variation de puissance optique Teil 3: Optische Leistungsabweichungen
induite par des perturbations mécaniques bedingt durch mechanische Störungen in
dans les interfaces d'embases optiques et optischen Kupplungen und Transceiver-
d'émetteurs-récepteurs Schnittstellen
(CEI 62150-3:2012) (IEC 62150-3:2012)
This European Standard was approved by CENELEC on 2012-08-13. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2012 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 62150-3:2012 E
---------------------- Page: 3 ----------------------
SIST EN 62150-3:2012
EN 62150-3:2012 - 2 -
Foreword
The text of document 86C/1061/FDIS, future edition 1 of IEC 62150-3, prepared by SC 86C, "Fibre optic
systems and active devices", of IEC TC 86, "Fibre optics" was submitted to the IEC-CENELEC parallel
vote and approved by CENELEC as EN 62150-3:2012.
The following dates are fixed:
(dop) 2013-05-13
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2015-08-13
standards conflicting with the
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
Endorsement notice
The text of the International Standard IEC 62150-3:2012 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following note has to be added fo
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.