Non-cellulosic papers for electrical purposes - Part 3: Specifications for individual materials - Sheet 4: Aramid fibre paper containing not more than 50 % of mica particles

IEC 60819-3-4:2013 specifies requirements for two types of aramid fibre paper containing mica particles and designated as PAaM: - type 1: calendered aramid paper containing mica particles; - type 2: uncalendered aramid paper containing mica particles. Materials which conform to this specification meet established levels of performance. However, the selection of material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone. SAFETY WARNING: It is the responsibility of the user of the methods contained or referred to in this document to ensure that they are used in a safe manner. This second edition cancels and replaces the first edition published in 2001. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: the document was updated including new thicknesses and relevant values as from Table 1. Keywords: aramid fibre paper containing mica particles, PAaM, calendered, uncalendered

Zellulosefreie Papiere für elektrotechnische Zwecke - Teil 3: Bestimmungen für einzelne Materialien - Blatt 4: Papier aus Aramidfaser mit einem Glimmeranteil von nicht mehr als 50 %

Papiers non cellulosiques pour usages électriques - Partie 3: Spécifications pour matériaux particuliers - Feuille 4: Papier en fibre aramide ne contenant pas plus de 50 % de particules de mica

L'IEC 60819-3-4:2013 spécifie des exigences pour deux types de papier en fibre aramide contenant des particules de mica et désignés PAaM: - type 1: papier aramide calendré contenant des particules de mica; - type 2: papier aramide non calendré contenant des particules de mica. Les matériaux conformes à cette spécification satisfont à des niveaux établis de performance. Cependant, il convient que le choix du matériau par un utilisateur et pour une application particulière soit fondé sur les exigences réelles nécessaires pour obtenir les performances satisfaisantes pour cette application, et non pas fondé uniquement sur la présente spécification. AVERTISSEMENT DE SÉCURITÉ: Il est de la responsabilité de l'utilisateur de s'assurer que les méthodes présentées ou référencées dans le présent document sont utilisées de manière sûre. Cette deuxième édition annule et remplace la première édition parue en 2001. Cette édition constitue une révision technique. Cette édition inclut les modifications techniques majeures suivantes par rapport à l'édition précédente: le document a été mis à jour en incluant de nouvelles épaisseurs et les valeurs correspondantes du Tableau 1. Mots clés: papier en fibre aramide contenant des particules de mica, PAaM, calendré, non calendré

Necelulozni papirji za elektrotehniko - 3. del: Specifikacije za posamezne materiale - 4. list: Papir z aramidnimi vlakni z največ 50 % sljudnih delcev (IEC 60819-3-4:2013)

Standard EN IEC 60819-3-4 določa zahteve za dve vrsti papirja z aramidnimi vlakni, ki vsebujejo sljudne delce in so označeni kot PAaM. – vrsta 1: stisnjeni aramidni papir, ki vsebuje sljudne delce, – vrsta 2: nestisnjeni aramidni papir, ki vsebuje sljudne delce. Materiali, ki so skladni s to specifikacijo, ustrezajo določenim ravnem delovanja. Vendar mora uporabnik material za določeno uporabo izbrati glede na dejanske zahteve za zadostno učinkovitost pri tej uporabi, ne samo na podlagi te specifikacije. VARNOSTNO OPOZORILO: Končni uporabnik je odgovoren za varno uporabo metod, ki so zajete ali omenjene v tem dokumentu.

General Information

Status
Published
Publication Date
10-Apr-2014
Withdrawal Date
15-Jan-2017
Drafting Committee
Current Stage
6060 - Document made available - Publishing
Start Date
11-Apr-2014
Completion Date
11-Apr-2014

Relations

Buy Standard

Standard
EN 60819-3-4:2014
English language
12 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60819-3-4:2014
01-julij-2014
1DGRPHãþD
SIST EN 60819-3-4:2002
1HFHOXOR]QLSDSLUML]DHOHNWURWHKQLNRGHO6SHFLILNDFLMH]DSRVDPH]QHPDWHULDOH
OLVW3DSLU]DUDPLGQLPLYODNQL]QDMYHþVOMXGQLKGHOFHY ,(&

Non-cellulosic papers for electrical purposes - Part 3: Specifications for individual
materials - Sheet 4: Aramid fibre paper containing not more than 50 % of mica particles
Papiers non cellulosiques pour usages électriques - Partie 3: Spécifications pour
matériaux particuliers - Feuille 4: Papiers en fibres aramide ne contenant pas plus de 50
% de particules de mica
Ta slovenski standard je istoveten z: EN 60819-3-4:2014
ICS:
29.035.10 Papirni in kartonski izolacijski Paper and board insulating
materiali materials
SIST EN 60819-3-4:2014 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 60819-3-4:2014

---------------------- Page: 2 ----------------------

SIST EN 60819-3-4:2014

EUROPEAN STANDARD
EN 60819-3-4

NORME EUROPÉENNE
April 2014
EUROPÄISCHE NORM

ICS 29.035.10 Supersedes EN 60819-3-4:2001


English version


Non-cellulosic papers for electrical purposes -
Part 3: Specifications for individual materials -
Sheet 4: Aramid fibre paper containing not more than 50 % of mica
particles
(IEC 60819-3-4:2013)


Papiers non cellulosiques pour usages Zellulosefreie Papiere für
électriques - elektrotechnische Zwecke -
Partie 3: Spécifications pour matériaux Teil 3: Bestimmungen für einzelne
particuliers - Materialien -
Feuille 4: Papiers en fibres aramide ne Blatt 4: Papier aus Aramidfaser mit einem
contenant pas plus de 50 % de particules Glimmeranteil von nicht mehr als 50 %
de mica (IEC 60819-3-4:2013)
(CEI 60819-3-4:2013)



This European Standard was approved by CENELEC on 2014-01-16. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

CEN-CENELEC Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2014 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60819-3-4:2014 E

---------------------- Page: 3 ----------------------

SIST EN 60819-3-4:2014
EN 60819-3-4:2014 - 2 -
Foreword
The text of document 15/689/CDV, future edition 2 of IEC 60819-3-4, prepared by IEC/TC 15 "Solid
electrical insulating materials" was submitted to the IEC-CENELEC parallel vote and approved by
CENELEC as EN 60819-3-4:2014.

The following dates are fixed:
(dop) 2014-10-16
• latest date by which the document has to be
implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2017-01-16
standards conflicting with the
document have to be withdrawn

This document supersedes EN 60819-3-4:2001.

EN 60819-3-4:2014 includes the following significant technical changes with respect to
EN 60819-3-4:2001:

The document was updated including new thicknesses and relevant values as from Table 1.

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.

Endorsement notice
The text of the International Standard IEC 60819-3-4:2013 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following note has to be added for the standard indicated:

IEC 60819-3 (all sheets) NOTE Harmonized as EN 60819-3 (all sheets) (not modified).

---------------------- Page: 4 ----------------------
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.