IEC 62512:2012
(Main)Electric clothes washer-dryers for household use - Methods for measuring the performance
Electric clothes washer-dryers for household use - Methods for measuring the performance
IEC 62512:2012 provides a globally applicable and agreed method to test the washing and drying function of washer-dryers. Although this standard is based on IEC 61121:2012 on tumble dryers and IEC 60456:2010 on clothes washers, it specifies the conditions needed to test the combined function of washing and drying. The main elements of this standard are:
- the definition of the loads to be tested in continuous and interrupted operation cycles;
- the method for testing automatic and not automatic operation of the drying cycles;
- the way to handle the load for interrupted operation cycles;
- the correction to be applied to test results for continuous and interrupted operation cycles.
Lavantes-séchantes électriques à usage domestique - Méthodes de mesure de l'aptitude à la fonction
La CEI 62512:2012 fournit une méthode d'application générale et convenue permettant de soumettre à essai la fonction de lavage et de séchage des lavantes-séchantes. Bien que fondée sur la CEI 61121:2012 relative aux sèche-linge à tambour et sur la CEI 60456:2010 relative aux machines à laver le linge, la présente norme spécifie les conditions qu'il est nécessaire d'appliquer pour soumettre à essai la fonction combinée de lavage et de séchage. La présente norme spécifie les principaux éléments suivants:
- la définition des charges à soumettre à essai au cours de cycles d'opération continus et interrompus;
- la méthode d'essai des opérations automatiques et non automatiques des cycles de séchage;
- le mode de traitement de la charge pour les cycles d'opération interrompus;
- la correction à appliquer aux résultats d'essai des cycles d'opération continus et interrompus.
General Information
Standards Content (Sample)
IEC 62512 ®
Edition 1.0 2012-09
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Electric clothes washer-dryers for household use – Methods for measuring the
performance
Lavantes-séchantes électriques à usage domestique – Méthodes de mesure de
l’aptitude à la fonction
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,
please contact the address below or your local IEC member National Committee for further information.
Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni
utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et les
microfilms, sans l'accord écrit de la CEI ou du Comité national de la CEI du pays du demandeur.
Si vous avez des questions sur le copyright de la CEI ou si vous désirez obtenir des droits supplémentaires sur cette
publication, utilisez les coordonnées ci-après ou contactez le Comité national de la CEI de votre pays de résidence.
IEC Central Office Tel.: +41 22 919 02 11
3, rue de Varembé Fax: +41 22 919 03 00
CH-1211 Geneva 20 info@iec.ch
Switzerland www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.
About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.
Useful links:
IEC publications search - www.iec.ch/searchpub Electropedia - www.electropedia.org
The advanced search enables you to find IEC publications The world's leading online dictionary of electronic and
by a variety of criteria (reference number, text, technical electrical terms containing more than 30 000 terms and
committee,…). definitions in English and French, with equivalent terms in
It also gives information on projects, replaced and additional languages. Also known as the International
withdrawn publications. Electrotechnical Vocabulary (IEV) on-line.
IEC Just Published - webstore.iec.ch/justpublished Customer Service Centre - webstore.iec.ch/csc
Stay up to date on all new IEC publications. Just Published If you wish to give us your feedback on this publication
details all new publications released. Available on-line and or need further assistance, please contact the
also once a month by email. Customer Service Centre: csc@iec.ch.
A propos de la CEI
La Commission Electrotechnique Internationale (CEI) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.
A propos des publications CEI
Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possédez
l’édition la plus récente, un corrigendum ou amendement peut avoir été publié.
Liens utiles:
Recherche de publications CEI - www.iec.ch/searchpub Electropedia - www.electropedia.org
La recherche avancée vous permet de trouver des Le premier dictionnaire en ligne au monde de termes
publications CEI en utilisant différents critères (numéro de électroniques et électriques. Il contient plus de 30 000
référence, texte, comité d’études,…). termes et définitions en anglais et en français, ainsi que
Elle donne aussi des informations sur les projets et les les termes équivalents dans les langues additionnelles.
publications remplacées ou retirées. Egalement appelé Vocabulaire Electrotechnique
International (VEI) en ligne.
Just Published CEI - webstore.iec.ch/justpublished
Service Clients - webstore.iec.ch/csc
Restez informé sur les nouvelles publications de la CEI.
Just Published détaille les nouvelles publications parues. Si vous désirez nous donner des commentaires sur
Disponible en ligne et aussi une fois par mois par email. cette publication ou si vous avez des questions
contactez-nous: csc@iec.ch.
IEC 62512 ®
Edition 1.0 2012-09
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Electric clothes washer-dryers for household use – Methods for measuring the
performance
Lavantes-séchantes électriques à usage domestique – Méthodes de mesure de
l’aptitude à la fonction
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
N
CODE PRIX
ICS 97.060 ISBN 978-2-83220-387-3
– 2 – 62512 © IEC:2012
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 6
3 Terms, definitions and symbols . 6
3.1 Terms and definitions . 6
3.2 Symbols . 8
4 Requirements . 8
5 Test conditions, materials, equipment and instrumentation . 8
5.1 General . 8
5.2 Ambient temperature and humidity . 8
6 Preparation for testing . 8
7 Performance measurements – General requirements . 9
8 Tests for performance . 9
8.1 Determination of the washing performance . 9
8.2 Determination of the water extraction performance and rinsing performance . 9
8.3 Determination of the water and energy consumption and programme time . 9
8.3.1 General . 9
8.3.2 Washing cycle . 9
8.3.3 Drying cycle . 9
8.3.4 Determination of energy consumption in "off" mode and "left on"
mode . 11
9 Assessment of performance . 11
9.1 General . 11
9.2 Determination of the airborne acoustical noise . 12
10 Data to be reported . 12
Annex A (normative) Splitting of the base load . 13
Annex B (informative) Suggested forms in which the data are reported . 14
Table 1 – List of symbols . 8
Table A.1 – Composition of loads for rated capacities of 8 and 9 kg . 13
Table A.2 – Corrected composition of load for a rated drying capacity of 8 kg . 13
62512 © IEC:2012 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
ELECTRIC CLOTHES WASHER-DRYERS FOR HOUSEHOLD USE –
METHODS FOR MEASURING THE PERFORMANCE
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International standard IEC 62512 has been prepared by subcommittee 59D: Home laundry
appliances, of IEC Technical Committee 59: Performance of household and similar electrical
appliances.
The text of this standard is based on the following documents:
FDIS Report on voting
59D/403/FDIS 59D/407/RVD
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.
Words in bold in the text are specifically defined in Clause 3.
– 4 – 62512 © IEC:2012
The committee has decided that the contents of this publication will remain unchanged until
the stability date indicated on the IEC web site under "http://webstore.iec.ch" in the data
related to the specific publication. At this date, the publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
62512 © IEC:2012 – 5 –
INTRODUCTION
This first edition has been developed to provide a globally applicable and agreed method to
test the washing and drying function of washer-dryers.
Although this standard is based on IEC 61121:2012 on tumble dryers and IEC 60456:2010 on
clothes washers, it specifies the conditions needed to test the combined function of washing
and drying.
The main elements of this standard are:
– the definition of the loads to be tested in continuous and interrupted operation cycles;
– the method for testing automatic and not automatic operation of the drying cycles;
– the way to handle the load for interrupted operation cycles;
– the correction to be applied to test results for continuous and interrupted operation cycles.
– 6 – 62512 © IEC:2012
ELECTRIC CLOTHES WASHER-DRYERS FOR HOUSEHOLD USE –
METHODS FOR MEASURING THE PERFORMANCE
1 Scope
This International Standard specifies the test methods for the testing of household combined
washer-dryers in their function to wash and dry
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.