Diesel fuel — Assessment of lubricity using the high-frequency reciprocating rig (HFRR) — Part 2: Limit

ISO 12156-2:2006 specifies the performance requirement (limit) necessary to ensure reliable operation of diesel fuel injection equipment with respect to lubrication by fuel of such equipment. It applies to fuels used in diesel engines.

Carburant diesel — Évaluation du pouvoir lubrifiant au banc alternatif à haute fréquence (HFRR) — Partie 2: Limite

General Information

Status
Withdrawn
Publication Date
09-Jan-2007
Withdrawal Date
09-Jan-2007
Current Stage
9599 - Withdrawal of International Standard
Completion Date
13-Jul-2017
Ref Project

Relations

Buy Standard

Standard
ISO 12156-2:2007 - Diesel fuel -- Assessment of lubricity using the high-frequency reciprocating rig (HFRR)
English language
1 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 12156-2
Second edition
2007-02-01

Diesel fuel — Assessment of lubricity
using the high-frequency reciprocating
rig (HFRR) —
Part 2:
Limit
Carburant diesel — Évaluation du pouvoir lubrifiant au banc alternatif
à haute fréquence (HFRR) —
Partie 2: Limite




Reference number
ISO 12156-2:2007(E)
©
ISO 2007

---------------------- Page: 1 ----------------------
ISO 12156-2:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


©  ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2007 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 12156-2:2007(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to pre
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.