ISO 5103:2023
(Main)Tourism and related services — Dry stack boat storage — Minimum requirements for operations and service provision
Tourism and related services — Dry stack boat storage — Minimum requirements for operations and service provision
This document establishes the minimum requirements for the operation of and service provision for dry stack boat storage. The document excludes the land storage of boats that do not use racks. The scope does not cover specifics of boat yards and docking areas. NOTE Dry stacks can be part of a yacht harbour facility or a stand-alone facility.
Titre manque
General Information
Buy Standard
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 5103
First edition
2023-08
Tourism and related services —
Dry stack boat storage — Minimum
requirements for operations and
service provision
Reference number
ISO 5103:2023(E)
© ISO 2023
---------------------- Page: 1 ----------------------
ISO 5103:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
© ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 5103:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 General requirements and recommendations. 2
4.1 Regulations . 2
4.2 Staff . 2
4.3 Administration . 2
4.4 Insurance . 3
5 Environmental requirements .3
5.1 Waste control . 3
5.2 Oil and fuel spill . 3
5.3 Black water, bilge water, grey water and hazardous substances . 3
5.4 Environmental code of conduct . 3
6 Safety requirements. 3
6.1 First aid kit . 3
6.2 Fire fighting . 3
6.3 Lifesaving equipment . 4
6.4 Illumination . 4
6.5 Electricity . 4
6.6 Emergency action plan . 4
7 Signage . 4
7.1 General . 4
7.2 Information point . 5
7.3 Entrances . 5
8 Services . 6
8.1 Fresh water . 6
8.2 Toilets . 6
8.3 Parking . 6
9 Maintenance and cleaning .6
9.1 General . 6
9.2 Maintenance and cleaning programme . 6
Bibliography . 8
iii
© ISO 2023 – All rights reserved
---------------------- Page: 3 ----------------------
ISO 5103:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO document should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use
of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed
patent rights in respect thereof. As of the date of publication of this document, ISO had not received
notice of (a) patent(s) which may be required to implement this document. However, implementers are
cautioned that this may not represent the latest information, which may be obtained from the patent
database available at www.iso.org/patents. ISO shall not be held responsible for identifying any or all
such patent rights.
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 228, Tourism and related services.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
© ISO 2023 – All rights reserved
---------------------- Page: 4 ----------------------
ISO 5103:2023(E)
Introduction
Most dry stacks are a professional operation dedicated to storing power boats on racks. Dry stacks
can be operated on their own or as part of a larger operation (full yacht harbour or marina). Dry stack
operation can be a commercial enterprise or part of a non-profit association (yacht club).
Dry stacks are an efficient way to store boats in areas with a small footprint, needing a minimum of
logistics to operate. These characteristics make them cheap to set up and affordable to the nautical
tourists who would otherwise have to pay for a wet berth and be exposed to the consequences of sea
growth and bad weather.
Dry stack storage is itself an environmental control facility because the stored boats do not need their
hull protected with antifouling paints, which often contain biocides that, dissolved in the water, affect
both water flora and fauna. Other environmental advantages include the following:
— Having the hull permanently clean reduces fuel consumption.
— Automatic and semi-automatic facilities can be run from alternative power sources, in particular
solar panels fitted on the roof of the shed.
— Boat cleaning (desalting) water can be collected, treated and used for WCs and gardening.
— The external aspect of the dry stack can be presented as a building with countless possible styles
and colours, thus reducing the negative visual impact.
This document does not cover dry storage of boats (hard stand) or shipyards and boatyards.
Dry stack types can be:
a) fully enclosed dry stack buildings:
— rectangular sheet metal steel or (lately) concrete structures with a central aisle and racks on either
side;
— semi-enclosed structures or sheds;
— roof and three walls, usually sheet metal steel as with the fully enclosed ones;
b) free-standing:
— columns support the stacking structure and some have a roof.
Dry stacks are operated in
...
DRAFT INTERNATIONAL STANDARD
ISO/DIS 5103
ISO/TC 228 Secretariat: UNE
Voting begins on: Voting terminates on:
2022-09-13 2022-12-06
Tourism and related services — Dry stack boat storage
— Minimum requirements for operations and service
provision
ICS: 03.080.30; 03.200.99
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
This document is circulated as received from the committee secretariat.
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 5103:2022(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION. © ISO 2022
---------------------- Page: 1 ----------------------
ISO/DIS 5103:2022(E)
DRAFT INTERNATIONAL STANDARD
ISO/DIS 5103
ISO/TC 228 Secretariat: UNE
Voting begins on: Voting terminates on:
Tourism and related services — Dry stack boat storage
— Minimum requirements for operations and service
provision
ICS: 03.080.30; 03.200.99
COPYRIGHT PROTECTED DOCUMENT
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
© ISO 2022
THEREFORE SUBJECT TO CHANGE AND MAY
This document is circulated as received from the committee secretariat.
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
NOT BE REFERRED TO AS AN INTERNATIONAL
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on STANDARD UNTIL PUBLISHED AS SUCH.
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
IN ADDITION TO THEIR EVALUATION AS
or ISO’s member body in the country of the requester. BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
ISO copyright office
USER PURPOSES, DRAFT INTERNATIONAL
CP 401 • Ch. de Blandonnet 8
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
CH-1214 Vernier, Geneva
POTENTIAL TO BECOME STANDARDS TO
Phone: +41 22 749 01 11
WHICH REFERENCE MAY BE MADE IN
Reference number
Email: copyright@iso.org
NATIONAL REGULATIONS.
Website: www.iso.org ISO/DIS 5103:2022(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
Published in Switzerland
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
ii
© ISO 2022 – All rights reserved
PROVIDE SUPPORTING DOCUMENTATION. © ISO 2022
---------------------- Page: 2 ----------------------
ISO/DIS 5103:2022(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 General requirements . 2
4.1 Legal requirements . 2
4.2 Staff . 2
4.3 Administration . 2
4.4 Insurance . 2
5 Environmental requirements .3
5.1 Waste control . 3
5.2 Oil and fuel spill . 3
5.3 Black water, bilge water, grey water, and hazardous substances . 3
5.4 Environmental code of conduct . 3
6 Safety requirements. 3
6.1 First Aid kit . 3
6.2 Fire fighting . 3
6.3 Lifesaving equipment . 3
6.4 Illumination . 4
6.5 Electricity . 4
6.6 Emergency action plan . 4
7 Signage . 4
7.1 General . 4
7.2 Information point . 5
7.3 Entrances . 5
8 Services . 6
8.1 Fresh water . 6
8.2 Toilets . 6
8.3 Parking . 6
9 Maintenance and cleaning .6
9.1 General . 6
9.2 Maintenance and cleaning programme . 6
Bibliography . 8
iii
© ISO 2022 – All rights reserved
---------------------- Page: 3 ----------------------
ISO/DIS 5103:2022(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to the
World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/
iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 228, Tourism and related services.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
© ISO 2022 – All rights reserved
---------------------- Page: 4 ----------------------
ISO/DIS 5103:2022(E)
Introduction
Most dry stacks are a professional operation dedicated to store power boats on racks. Dry stacks can
be operated on their own or as part of a larger operation (full yacht harbour or marina). Dry stack
operation can be a commercial enterprise or part of a non-profit association (yacht club).
Dry stacks are an efficient way to store boats in small footprint areas, needing a minimum of logistics
to operate. These characteristics make them cheap to set up, and affordable to the nautical tourists that
otherwise will have to pay for a wet berth and be exposed to the consequences of sea growth and bad
weather.
Dry stack storage is itself an environmental control facility because the stored boats do not need to
protect their hull bottom with antifouling paints which often contain diverse biocides that, diluted in
the water, affect both water flora and fauna.
— Another environmental advantage is that having the hull
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.