SIST EN 60811-100:2012
Electric and optical fibre cables - Test methods for non-metallic materials - Part 100: General
Electric and optical fibre cables - Test methods for non-metallic materials - Part 100: General
This Part 100 of IEC 60811 describes general requirements and considerations that are applicable to all the test methods given in the particular parts, unless otherwise specified.
Kabel, isolierte Leitungen und Glasfaserkabel - Prüfverfahren für nichtmetallene Werkstoffe - Teil 100: Allgemeines
Câbles électriques et câbles à fibres optiques - Méthodes d'essai pour les matériaux non-métalliques - Partie 100: Généralités
La CEI 60811-100:2012 décrit les exigences et les considérations générales applicables à toutes les méthodes d'essai données dans les différentes parties, sauf spécification contraire. Cette première édition de la CEI 60811-100 regroupe les aspects généraux qui s'appliquent à la série CEI 60811 restructurée. Une explication détaillée se trouve dans l'Introduction. L'ensemble des informations relatives à la relation entre la présente et l'ancienne série figure dans l'Annexe A. La présente série révisée de la CEI 60811 est fondée sur le principe 'un essai par partie'. Une modification technique significative est apportée dans toute la série, à savoir l'introduction d'un modèle minimum défini pour la présentation des rapports d'essai.
Električni in optični kabli - Preskuševalne metode za nekovinske materiale - 100. del: Splošno
100. del standarda IEC 60811 opisuje splošne zahteve in dejavnike, ki veljajo za vse preskuševalne metode, navedene v teh delih, razen če je določeno drugače.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 60811-100:2012
01-september-2012
(OHNWULþQLLQRSWLþQLNDEOL3UHVNXãHYDOQHPHWRGH]DQHNRYLQVNHPDWHULDOH
GHO 6SORãQR
Electric and optical fibre cables - Test methods for non-metallic materials - Part 100:
General
Kabel, isolierte Leitungen und Glasfaserkabel - Prüfverfahren für nichtmetallene
Werkstoffe - Teil 100: Allgemeines
Câbles électriques et câbles à fibres optiques - Méthodes d'essai pour les matériaux non
-métalliques - Partie 100: Généralités
Ta slovenski standard je istoveten z: EN 60811-100:2012
ICS:
29.035.01 Izolacijski materiali na Insulating materials in
splošno general
29.060.20 Kabli Cables
SIST EN 60811-100:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 60811-100:2012
---------------------- Page: 2 ----------------------
SIST EN 60811-100:2012
EUROPEAN STANDARD
EN 60811-100
NORME EUROPÉENNE
June 2012
EUROPÄISCHE NORM
ICS 29.035.01; 29.060.20 Supersedes EN 60811-1-1:1995 (partially) + A1:2001 (partially), EN 60811-1-2:1995 (partially)
+ A2:2000 (partially), EN 60811-1-3:1995 (partially) + A1:2001 (partially), EN 60811-1-4:1995
(partially) + A2:2001 (partially), EN 60811-2-1:1998 (partially) + A1:2001 (partially), EN 60811-
3-1:1995 (partially) + A1:1996 (partially) + A2:2001 (partially), EN 60811-3-2:1995 (partially) +
A2:2004 (partially), EN 60811-4-1:2004 (partially), EN 60811-4-2:2004 (partially), EN 60811-5-
1:1999 (partially) + A1:2004 (partially)
English version
Electric and optical fibre cables -
Test methods for non-metallic materials -
Part 100: General
(IEC 60811-100:2012)
Câbles électriques et à fibres optiques - Kabel, isolierte Leitungen und
Méthodes d'essai pour les matériaux non- Glasfaserkabel -
métalliques - Prüfverfahren für nichtmetallene
Partie 100: Généralités Werkstoffe -
(CEI 60811-100:2012) Teil 100: Allgemeines
(IEC 60811-100:2012)
This European Standard was approved by CENELEC on 2012-04-16. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland, Turkey and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2012 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60811-100:2012 E
---------------------- Page: 3 ----------------------
SIST EN 60811-100:2012
EN 60811-100:2012 - 2 -
Foreword
The text of document 20/1279/FDIS, future edition 1 of IEC 60811-100, prepared by IEC/TC 20 "Electric
cables" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as
EN 60811-100:2012.
The following dates are fixed:
(dop) 2013-01-16
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
(dow) 2015-04-16
• latest date by which the national
standards conflicting with the
document have to be withdrawn
This document supersedes EN 60811-1-1:1995 (partially) + A1:2001 (partially), EN 60811-1-2:1995
(partially) + A2:2000 (partially), EN 60811-1-3:1995 (partially) + A1:2001 (partially), EN 60811-1-4:1995
(partially) + A2:2001 (partially), EN 60811-2-1:1998 (partially) + A1:2001 (partially), EN 60811-3-1:1995
(partially) + A1:1996 (partially) + A2:2001 (partially), EN 60811-3-2:1995 (partially) + A2:2004 (partially),
EN 60811-4-1:2004 (partially), EN 60811-4-2:2004 (partially), EN 60811-5-1:1999 (partially) + A1:2004
(partially).
EN 60811-100:2012 collects together general matters that apply to the restructured EN 60811 series. A
detailed explanation is provided in the Introduction. Annex A provides full information on the relation
between the current and the previous series.
This revised series of EN 60811 is based upon the principle of “one test – one part”. One significant
technical change that now applies throughout the series is a defined minimum scheme for the
presentation of test reports.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
This standard covers the Principle Elements of the Safety Objectives for Electrical Equipment Designed
for Use within Certain Voltage Limits (LVD - 2006/95/EC)
Endorsement notice
The text of the International Standard IEC 60811-100:2012 was approved by CENELEC as a European
Standard without any modification.
---------------------- Page: 4 ----------------------
SIST EN 60811-100:2012
- 3 - EN 60811-100:2012
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.
NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year
IEC 60050-461 - International Electrotechnical Vocabulary - - -
Part 461: Electric cables
IEC 60502-1 - Power cables with extruded insulation and - -
their accessories for rated voltages from 1 kV
(U = 1,2 kV) up to 30 kV (U = 36 kV) -
m m
Part 1: Cables for rated voltages of 1 kV (U =
m
1,2 kV) and 3 kV (U = 3,6 kV)
m
---------------------- Page: 5 ----------------------
SIST EN 60811-100:2012
---------------------- Page: 6 ----------------------
SIST EN 60811-100:2012
IEC 60811-100
®
Edition 1.0 2012-03
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Electric and optical fibre cables – Test methods for non-metallic materials –
Part 100: General
Câbles électriques et à fibres optiques – Méthodes d’essai pour les matériaux
non-métalliques –
Partie 100: Généralités
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX L
ICS 29.035.01; 29.060.20 ISBN 978-2-88912-955-3
Warning! Make sure that you obtained this publication from an authorized distributor.
Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agréé.
® Registered trademark of the International Electrotechnical Commission
Marque déposée de la Commission Electrotechnique Internationale
---------------------- Page: 7 ----------------------
SIST EN 60811-100:2012
– 2 – 60811-100 IEC:2012
CONTENTS
FOREWORD . 3
INTRODUCTION . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Test values . 6
5 Applicability . 6
6 Type tests and other tests . 7
7 Test report. 7
Annex A (informative) Structure and content of IEC 60811 . 8
Table A.1 – Parts and their previous reference . 8
Table A.2 – Cross-reference for original parts and clauses . 10
---------------------- Page: 8 ----------------------
SIST EN 60811-100:2012
60811-100 IEC:2012 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
ELECTRIC AND OPTICAL FIBRE CABLES –
TEST METHODS FOR NON-METALLIC MATERIALS –
Part 100: General
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that s
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.