SIST-TS CEN/TS 1317-7:2024
(Main)Road restraint systems -Part 7: Performance characterisation and test methods for terminals of safety barriers
Road restraint systems -Part 7: Performance characterisation and test methods for terminals of safety barriers
This document specifies requirements, test/assessment methods and acceptance criteria for safety barrier terminals to be used in a
permanent or temporary manner on roads and in vehicle circulation areas.
The present document should be read in conjunction with EN 1317-1:2010 and EN 1317-2 2:2010 and EN 1317-5:2007+A2:2012.
Rückhaltesysteme an Straßen - Leistungsklassen, Abnahmekriterien für Anprallprüfungen und Prüfverfahren für Anfangs-und Endkonstruktionen von Schutzeinrichtungen
Dieses Dokument legt Anforderungen, Prüf /Bewertungsverfahren und Abnahmekriterien für Anfangs- und Endkonstruktionen von Schutzeinrichtungen fest, die dauerhaft oder vorübergehend auf Straßen und in Verkehrsbereichen für Fahrzeuge eingesetzt werden.
Dispositifs de retenue routiers Caractérisation des performances et méthodes dessai pour les extrémités de file de barrières de sécurité
Ce document spécifie les exigences, les méthodes d’essai/d’évaluation et les critères d’acceptation pour les extrémités de file de barrières de sécurité à usage permanent ou temporaire sur les routes et dans les zones de circulation des véhicules.
Le présent document doit être lu conjointement avec l'EN 1317-1:2010 et l'EN 1317-2 2:2010 et l'EN 1317-5:2007+A2:2012.
Oprema cest - 7. del: Ugotavljanje lastnosti in preskusne metode za zaključnice varnostnih ograj
Ta dokument določa zahteve, preskusne metode in metode ocenjevanja ter kriterije sprejemljivosti za zaključnice in prehodne elemente varnostnih ograj, ki se stalno ali začasno uporabljajo na cestah in v prometnih območjih.
Dokument je priporočljivo brati skupaj s standardi EN 1317-1:2010, EN 1317-2-2:2010 in EN 1317-5:2007+A2:2012.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS CEN/TS 1317-7:2024
01-januar-2024
Nadomešča:
SIST ENV 1317-4:2002
Oprema cest - 7. del: Ugotavljanje lastnosti in preskusne metode za zaključnice
varnostnih ograj
Road restraint systems -Part 7: Performance characterisation and test methods for
terminals of safety barriers
Rückhaltesysteme an Straßen - Leistungsklassen, Abnahmekriterien für
Anprallprüfungen und Prüfverfahren für Anfangs-und Endkonstruktionen von
Schutzeinrichtungen
Dispositifs de retenue routiers Caractérisation des performances et méthodes dessai
pour les extrémités de file de barrières de sécurité
Ta slovenski standard je istoveten z: CEN/TS 1317-7:2023
ICS:
13.200 Preprečevanje nesreč in Accident and disaster control
katastrof
93.080.30 Cestna oprema in pomožne Road equipment and
naprave installations
SIST-TS CEN/TS 1317-7:2024 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 1317-7:2024
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 1317-7:2024
CEN/TS 1317-7
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
November 2023
TECHNISCHE SPEZIFIKATION
ICS 93.080.30 Supersedes ENV 1317-4:2001
English Version
Road restraint systems -Part 7: Performance
characterisation and test methods for terminals of safety
barriers
Dispositifs de retenue routiers - Caractérisation des Rückhaltesysteme an Straßen - Leistungsklassen,
performances et méthodes d'essai pour les extrémités Abnahmekriterien für Anprallprüfungen und
de file de barrières de sécurité Prüfverfahren für Anfangs-und Endkonstruktionen von
Schutzeinrichtungen
This Technical Specification (CEN/TS) was approved by CEN on 4 September 2023 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 1317-7:2023 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 1317-7:2024
CEN/TS 1317-7 :2023 (E)
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Abbreviations . 11
5 Terminal performance . 11
5.1 General . 11
5.2 Determination of the Datum Point and Structural Length . 11
5.3 Restraint and direction categories . 12
5.3.1 General .
...
SLOVENSKI STANDARD
SIST-TS CEN/TS 1317-7:2024
01-januar-2024
Nadomešča:
SIST ENV 1317-4:2002
Oprema cest - 7. del: Ugotavljanje zmogljivosti in preskusne metode za zaključnice
in prehodne elemente varnostnih ograj
Road restraint systems -Part 7: Performance characterisation and test methods for
terminals of safety barriers
Rückhaltesysteme an Straßen - Leistungsklassen, Abnahmekriterien für
Anprallprüfungen und Prüfverfahren für Anfangs-und Endkonstruktionen von
Schutzeinrichtungen
Dispositifs de retenue routiers Caractérisation des performances et méthodes dessai
pour les extrémités de file de barrières de sécurité
Ta slovenski standard je istoveten z: CEN/TS 1317-7:2023
ICS:
13.200 Preprečevanje nesreč in Accident and disaster control
katastrof
93.080.30 Cestna oprema in pomožne Road equipment and
naprave installations
SIST-TS CEN/TS 1317-7:2024 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 1317-7:2024
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 1317-7:2024
CEN/TS 1317-7
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
November 2023
TECHNISCHE SPEZIFIKATION
ICS 93.080.30 Supersedes ENV 1317-4:2001
English Version
Road restraint systems -Part 7: Performance
characterisation and test methods for terminals of safety
barriers
Dispositifs de retenue routiers - Caractérisation des Rückhaltesysteme an Straßen - Leistungsklassen,
performances et méthodes d'essai pour les extrémités Abnahmekriterien für Anprallprüfungen und
de file de barrières de sécurité Prüfverfahren für Anfangs-und Endkonstruktionen von
Schutzeinrichtungen
This Technical Specification (CEN/TS) was approved by CEN on 4 September 2023 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 1317-7:2023 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 1317-7:2024
CEN/TS 1317-7 :2023 (E)
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Abbreviations . 11
5 Terminal performance . 11
5.1 General . 11
5.2 Determination of the Datum Point and Structural Length . 11
5.3 Restraint and direction categories . 12
5.3.1 General .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.