SIST EN ISO 15584:2002
(Main)Small craft - Inboard petrol engines - Engine-mounted fuel and electrical components (ISO 15584:2001)
Small craft - Inboard petrol engines - Engine-mounted fuel and electrical components (ISO 15584:2001)
Kleine Wasserfahrzeuge - Kraftstoff- und elektrische Systeme für fest montierte Ottomotoren (ISO 15584:2001)
Diese Norm legt Regeln für Konstruktion und Montage für motorseitige Teile des Kraftstoff und elektrischen Systems fest um die Leckage in Kraftsfoffleitungen zu minimieren und zur Vermeidung der Entzündung von explosiven Gasgemischen auf kleinen Wasserfahrzeugen mit einer Rumpflänge bis 24 m. Die folgenden Motortypen fallen nicht unter den Anwendungsbereich dieser Norm: - Motoren in Wasserskootern wie in ISO 13590 definiert (siehe Literaturhinweise); - Außenbordmotoren.
Petits navires - Moteurs intérieurs a essence - Eléments des circuits d'alimentation et des systemes électriques (ISO 15584:2001)
La présente Norme internationale spécifie les exigences relatives à la conception et à l'installation des éléments des circuits d'alimentation en combustible et des systèmes électriques pour moteurs intérieurs à essence, permettant de réduire les fuites de combustible et d'assurer une protection contre l'inflammation des gaz explosifs environnants sur les petits navires dont la coque n'excède pas 24 m de longueur. Les modèles de moteurs suivants ne sont pas couverts par la présente Norme internationale : - les moteurs définis dans l'ISO 13590 équipant les motos aquatiques (voir la bibliographie) ; - les moteurs hors-bord.
Mala plovila - Vgrajeni bencinski motorji - Nameščene komponente za gorivo in elektriko (ISO 15584:2001)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 15584:2002
01-januar-2002
0DODSORYLOD9JUDMHQLEHQFLQVNLPRWRUML1DPHãþHQHNRPSRQHQWH]DJRULYRLQ
HOHNWULNR ,62
Small craft - Inboard petrol engines - Engine-mounted fuel and electrical components
(ISO 15584:2001)
Kleine Wasserfahrzeuge - Kraftstoff- und elektrische Systeme für fest montierte
Ottomotoren (ISO 15584:2001)
Petits navires - Moteurs intérieurs a essence - Eléments des circuits d'alimentation et
des systemes électriques (ISO 15584:2001)
Ta slovenski standard je istoveten z: EN ISO 15584:2001
ICS:
47.020.20 Ladijski motorji Marine engines and
propulsion systems
47.080 ýROQL Small craft
SIST EN ISO 15584:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 15584:2002
---------------------- Page: 2 ----------------------
SIST EN ISO 15584:2002
EUROPEAN STANDARD
EN ISO 15584
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2001
ICS 47.080
English version
Small craft - Inboard petrol engines - Engine-mounted fuel and
electrical components (ISO 15584:2001)
Petits navires - Moteurs intérieurs à essence - Eléments Kleine Wasserfahrzeuge - Einbau-Benzinmotoren - Fest
des circuits d'alimentation et des systèmes électriques am Motor montierte Bauteile für die Kraftstoff- und
(ISO 15584:2001) Stromversorgung (ISO 15584:2001)
This European Standard was approved by CEN on 15 March 2001.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2001 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 15584:2001 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 15584:2002
Page 2
EN ISO 15584:2001
Foreword
Corrected 2001-05-09
The text of the International Standard ISO 15584:2001 has been prepared by Technical
Committee ISO/TC 188 "Small craft" in collaboration with CMC.
This European Standard shall be given the status of a national standard, either by publication
of an identical text or by endorsement, at the latest by September 2001, and conflicting
national standards shall be withdrawn at the latest by September 2001.
This European Standard has been prepared under a mandate given to CEN by the European
Commission and the European Free Trade Association, and supports essential requirements
of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZB, which is an integral part of
this standard.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the following countries are bound to implement this European Standard: Austria, Belgium,
Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy,
Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United
Kingdom.
Endorsement notice
The text of the International Standard ISO 15584:2001 was approved by CEN as a European
Standard without any modification.
NOTE: Normative references to International Standards are listed in annex ZA (normative).
---------------------- Page: 4 ----------------------
SIST EN ISO 15584:2002
Page 3
EN ISO 15584:2001
Annex ZA (normative)
Normative references to international publications
with their relevant European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions
of any of these publications apply to this European Standard only when incorporated in it by
amendment or revision. For undated references the latest edition of the publication referred to
applies (including amendments).
NOTE Where an International Publication has been modified by common modifications,
indicated by (mod.), the relevant EN/HD applies.
Publication Year Title EN Year
ISO 7840 1994 Small craft - Fire resistant fuel hoses EN ISO 7840 1995
ISO 8846 1990 Small craft - Electrical devices - EN 28846 1993
Protection against ignition of
surrounding flammable gases
---------------------- Page: 5 ----------------------
SIST EN ISO 15584:2002
Page 4
EN ISO 15584:2001
Annex ZB (informative)
Clauses of this European Standard addressing essential requirements or
other provisions of EU Directives
This European Standard has been prepared under a mandate given to CEN by the European
Commission and the European Free Trade Association and supports essential requirements
of EU Directive 94/25/EC.
WARNING: Other requirements and other EU Directive may be applicable to the product(s)
falling within the scope of this standard.
The following clauses of this standard, as detailed in Table ZB.1, are likely to support
requirements of Directive 94/25/EC.
Compliance with the clauses of this standard provides one means of conforming with the
specific essential requirements of the Directive concerned and associated EFTA regulations.
Table ZB.1 - Correspondence between this European Standard and EU Directives
Clauses/sub-clauses of this Corresponding annexes/ Comments
European Standard paragraphs of Directive 94/25/EC
All Clauses 5.1.1 of annex I, Inboard Engine
4.2.5 5.2.1 of annex I, Fuel system,
General
6 5.3 of Annex I
Electrical system
4.1, 6 Annex II, Components, 1
---------------------- Page: 6 ----------------------
SIST EN ISO 15584:2002
INTERNATIONAL ISO
STANDARD 15584
First edition
2001-03-15
Small craft — Inboard petrol engines —
Engine-mounted fuel and electrical
components
Petits navires — Moteurs intérieurs à essence — Éléments des circuits
d'alimentation et des systèmes électriques
Reference number
ISO 15584:2001(E)
©
ISO 2001
---------------------- Page: 7 ----------------------
SIST EN ISO 15584:2002
ISO 15584:2001(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2001
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 2001 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 15584:2002
ISO 15584:2001(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
International Standard ISO 15584 was prepared by Technical Committee ISO/TC 188, Small craft.
© ISO 2001 – All rights reserved iii
---------------------- Page: 9 ----------------------
SIST EN ISO 15584:2002
---------------------- Page: 10 ----------------------
SIST EN ISO 15584:2002
INTERNATIONAL STANDARD ISO 15584:2001(E)
Small craft — Inboard petrol engines — Engine-mounted fuel and
electrical components
1 Scope
This International Standard specifies requirements for the design and installation of engine-mounted fuel and
electrical system components on inboard petrol engines for minimizing fuel leakage and protecting against ignition
of surrounding flammable gases on small craft of hull length up to 24 m.
The following types of engines are exempt from the application of this International Standard:
� engines in personal watercraft as defined by ISO 13590 (see the bibliography);
� outboard engines.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of
this International Standard. For dated references, subsequent amendments to, or revisions of, any of these
publications do not apply. However, parties to agreements based on this International Standard are encouraged to
investigate the possibility of applying the most recent editions of the normative documents indicated below. For
undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC
maintain registers of currently valid International Standards.
ISO 1817:1999, Rubber, vulcanized — Determination of the effect of liquids.
ISO 7840:1994, Small craft — Fire-resistant fuel hoses.
ISO 8846:1990, Small craft — Electrical devices — Protection against ignition of surrounding flammable gases.
ISO 9227:1990, Corrosion tests in artificial atmospheres — Salt spray tests.
1)
ISO 10088:— , Small craft — Permanently installed fuel systems and fixed fuel tanks.
ISO 13592:1998, Small craft — Backfire flame control for petrol engines.
3 Terms and definitions
For the purposes of this International Standard, the following terms and definitions apply.
3.1
engine-mounted
component securely fixed by the engine manufacturer to the marine inboard engine and w
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.