SIST ISO 12646:2010/Dod 1:2014
(Amendment)Graphic technology - Displays for colour proofing - Characteristics and viewing conditions AMENDMENT 1
Graphic technology - Displays for colour proofing - Characteristics and viewing conditions AMENDMENT 1
This International Standard specifies the minimum requirements for the characteristics of displays to be used for soft proofing of colour images. Included are requirements for uniformity, convergence, refresh rate, display diagonal size, spatial resolution and glare of the screen surface. The dependence of colorimetric properties on the electrical drive signals and viewing direction, especially for flat panel displays, is also specified.
Technologie graphique - Affichages pour la réalisation d'épreuves en couleur - Caractéristiques et conditions d'examen visuel AMENDEMENT 1
Grafična tehnologija - Zasloni za barvno preskušanje - Značilnosti in pogoji za vizualno opazovanje - Dodatek 1
Ta mednarodni standard določa minimalne zahteve za značilnosti zaslonov, ki se uporabljajo za neagresivno preskušanje barvnih slik. Vključuje zahteve za enotnost, konvergenco, hitrost osveževanja, velikost diagonale zaslona, prostorsko ločljivost in blesk površine zaslona. Določa tudi odvisnost kolorimetričnih lastnosti od električnih pogonskih signalov in smeri gledanja, predvsem za ploščate zaslone.
General Information
Relations
Buy Standard
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 12646
First edition
2008-06-01
AMENDMENT 1
2010-09-01
Graphic technology — Displays for
colour proofing — Characteristics and
viewing conditions
AMENDMENT 1
Technologie graphique — Affichages pour la réalisation d'épreuves en
couleur — Caractéristiques et conditions d'examen visuel
AMENDEMENT 1
Reference number
ISO 12646:2008/Amd.1:2010(E)
©
ISO 2010
---------------------- Page: 1 ----------------------
ISO 12646:2008/Amd.1:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2010 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 12646:2008/Amd.1:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to ISO 12646:2008 was prepared by Technical Committee ISO/TC 130, Graphic technology.
© ISO 2010 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 12646:2008/Amd.1:2010(E)
Graphic technology — Disp
...
SLOVENSKI STANDARD
SIST ISO 12646:2010/Dod 1:2014
01-junij-2014
*UDILþQDWHKQRORJLMD=DVORQL]DEDUYQRSUHVNXãDQMH=QDþLOQRVWLLQSRJRML]D
YL]XDOQRRSD]RYDQMH'RGDWHN
Graphic technology - Displays for colour proofing - Characteristics and viewing
conditions AMENDMENT 1
Technologie graphique - Affichages pour la réalisation d'épreuves en couleur -
Caractéristiques et conditions d'examen visuel AMENDEMENT 1
Ta slovenski standard je istoveten z: ISO 12646:2008/Amd 1:2010
ICS:
17.180.20 Barve in merjenje svetlobe Colours and measurement of
light
37.100.10 Reprodukcijska oprema Reproduction equipment
SIST ISO 12646:2010/Dod 1:2014 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 12646:2010/Dod 1:2014
---------------------- Page: 2 ----------------------
SIST ISO 12646:2010/Dod 1:2014
INTERNATIONAL ISO
STANDARD 12646
First edition
2008-06-01
AMENDMENT 1
2010-09-01
Graphic technology — Displays for
colour proofing — Characteristics and
viewing conditions
AMENDMENT 1
Technologie graphique — Affichages pour la réalisation d'épreuves en
couleur — Caractéristiques et conditions d'examen visuel
AMENDEMENT 1
Reference number
ISO 12646:2008/Amd.1:2010(E)
©
ISO 2010
---------------------- Page: 3 ----------------------
SIST ISO 12646:2010/Dod 1:2014
ISO 12646:2008/Amd.1:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2010 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 12646:2010/Dod 1:2014
ISO 12646:2008/Amd.1:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by a
...
SLOVENSKI STANDARD
SIST ISO 12646:2010/oDod 1:2010
01-maj-2010
*UDILþQDWHKQRORJLMD=DVORQL]DEDUYQRSUHVNXãDQMH=QDþLOQRVWLLQSRJRML]D
YL]XDOQRRSD]RYDQMH'RGDWHN
Graphic technology - Displays for colour proofing - Characteristics and viewing
conditions AMENDMENT 1
Technologie graphique - Affichages pour la réalisation d'épreuves en couleur -
Caractéristiques et conditions d'examen visuel AMENDEMENT 1
Ta slovenski standard je istoveten z: ISO 12646:2008/DAmd 1
ICS:
37.100.01 *UDILþQDWHKQRORJLMDQD Graphic technology in
VSORãQR general
SIST ISO 12646:2010/oDod 1:2010 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 12646:2010/oDod 1:2010
---------------------- Page: 2 ----------------------
SIST ISO 12646:2010/oDod 1:2010
DRAFT AMENDMENT ISO 12646:2008/DAmd 1
ISO/TC 130 Secretariat: DIN
Voting begins on: Voting terminates on:
2009-08-21 2010-01-21
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Graphic technology — Displays for colour proofing —
Characteristics and viewing conditions
AMENDMENT 1
Technologie graphique — Affichages pour la réalisation d'épreuves en couleur — Caractéristiques et
conditions d'examen visuel
AMENDEMENT 1
ICS 37.100.01
In accordance with the provisions of Council Resolution 15/1993 this document is circulated in
the English language only.
Conformément aux dispositions de la Résolution du Conseil 15/1993, ce document est distribué
en version anglaise seulement.
To expedite distribution, this document is circulated as received from the committee secretariat.
ISO Central Secretariat work of editing and text composition will be undertaken at publication
stage.
Pour accélérer la distribution, le présent document est distribué tel qu'il est parvenu du
secrétariat du comité. Le travail de rédaction et de composition de texte sera effectué au
Secrétariat central de l'ISO au stade de publication.
THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE
REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT
INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS.
RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION.
©
International Organization for Standardization, 2009
---------------------- Page: 3 ----------------------
SIST ISO 12646:2010/oDod 1:2010
ISO 12646:2008/DAmd 1
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall
not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the
unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
Copyright notice
This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted
under the applicable laws of the user's country, neither this ISO draft nor any extract from it may be
reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying,
recording or otherwise, without prior written permission being secured.
Requests for permission to reproduce should be addressed to either ISO at the address below or ISO's
member body in the country of the requester.
ISO copyright office
Case postale 56 CH-1211 Geneva 20
Tel. + 4
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.