SIST EN 50209:1999
(Main)Test of insulation of bars and coils of high-voltage machines
Test of insulation of bars and coils of high-voltage machines
This specification applies to rotating electrical machines with rated voltages (Un) from 5 kV to 24 kV inclusive and with rated output from 5 MVA upwards and from 5 MW upwards for motors Requirements for machines with rated voltage above 24 kV should remain the subject of individual agreement This specification is also applicable to machines with rated outputs between 1MVA( 1MW) and 5 MVA(5MW) and with rated voltages of 5 kV and above, provided its use has been agreed beforehand In the case of machines whose windings are cured in the stator, tests on the separate winding elements are not possible; for these machines the requirements in Part B apply. The test of the conductor lamination insulation must however be carried out in accordance with 23 of Part A of this standard
Prüfung der Isolierung von Stäben und Spulen von Hochspannungsmaschinen
Essai de l'isolation des barres et des bobines des machines à haute tension
Test of insulation of bars and coils of high-voltage machines
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 50209:1999
01-april-1999
Test of insulation of bars and coils of high-voltage machines
Test of insulation of bars and coils of high-voltage machines
Prüfung der Isolierung von Stäben und Spulen von Hochspannungsmaschinen
Essai de l'isolation des barres et des bobines des machines à haute tension
Ta slovenski standard je istoveten z: EN 50209:1998
ICS:
29.080.01 (OHNWULþQDL]RODFLMDQD Electrical insulation in
VSORãQR general
SIST EN 50209:1999 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 -----------------
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.