SIST EN 15743:2010/kFprA1:2014
(Amendment)Supersulfated cement - Composition, specifications and conformity criteria
Supersulfated cement - Composition, specifications and conformity criteria
See edition of 2011. The amendment concerns the adequation to the CPR.
Sulfathüttenzement - Zusammensetzung, Anforderungen und Konformitätskriterien
Ciment sursulfaté - Composition, spécifications et critères de conformité
Supersulfatni cement - Sestava, zahteve in merila skladnosti
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 15743:2010/kFprA1:2014
01-oktober-2014
6XSHUVXOIDWQLFHPHQW6HVWDYD]DKWHYHLQPHULODVNODGQRVWL]DRELþDMQHFHPHQWH
Supersulfated cement - Composition, specifications and conformity criteria
Sulfathüttenzement - Zusammensetzung, Anforderungen und Konformitätskriterien
Ciment sursulfaté - Composition, spécifications et critères de conformité
Ta slovenski standard je istoveten z: EN 15743:2010/FprA1
ICS:
91.100.10 Cement. Mavec. Apno. Malta Cement. Gypsum. Lime.
Mortar
SIST EN 15743:2010/kFprA1:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 15743:2010/kFprA1:2014
---------------------- Page: 2 ----------------------
SIST EN 15743:2010/kFprA1:2014
EUROPEAN STANDARD
FINAL DRAFT
EN 15743:2010
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
July 2014
ICS 91.100.10
English Version
Supersulfated cement - Composition, specifications and
conformity criteria
Ciment sursulfaté - Composition, spécifications et critères Sulfathüttenzement - Zusammensetzung, Anforderungen
de conformité und Konformitätskriterien
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 51.
This draft amendment A1, if approved, will modify the European Standard EN 15743:2010. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 15743:2010/FprA1:2014 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 15743:2010/kFprA1:2014
EN 15743:2010/FprA1:2014 (E)
Contents
Page
Foreword .3
1 Modification to Clause 2 .4
2 Modification to Clause 7 .4
3 Modification to 9.1 .4
4 Modification to Annex ZA .4
2
---------------------- Page: 4 ----------------------
SIST EN 15743:2010/kFprA1:2014
EN 15743:2010/FprA1:2014 (E)
Foreword
This document (EN 15743:2010/FprA1:2014) has been prepared by Technical Committee CEN/TC 51
“Cement and building limes”, the secretariat of which is held by NBN.
This document is currently submitted to the Unique Acceptance Procedure.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Regulation(s).
For relationship with EU Regulation(s), see informative Annex ZA, which is an integral part of this document.
This European Standard sets out requirements for the composition and specifications of supersulfated
cement. The scheme for the evaluation of conformity of supersulfated cement is that specified in EN 197-2.
Compared to the version EN 15743:2010 the following major changes have been included in this document:
Clause “Dangerous substances”;
Use of the terminology given by the Construction Products Regulation (Regulation (EU) No 305/2011) in
9.1;
Adaption of Annex ZA to the new CEN template.
The requirements in this European Standard are based on the results of tests on cement in accordance with
parts 1, 2, 3, 7, 8 and 9 of EN 196, Methods of testing cement.
Note: Due to fact that the Framework Partnership Agreement between the Commission and CEN & CENELEC
is not signed yet, there are currently no New Approach Consultants in place for 2014. Therefore the provisions
of CEN-CENELEC Guide 15 cannot be met.
This shall not prevent the processing of draft standards nor the offering of harmonized standards to the
Commission. In particular, draft standards can be sent to vote without Consultant assessment.
This note will be removed from the Foreword of the finalized publication.
3
---------------------- Page: 5 ----------------------
SIST EN 15743:2010/kFprA1:2014
EN 15743:2010/FprA1:2014 (E)
1 Modification to Clause 2
Replace "EN 197-2:2000" with EN 197-2:2014".
2 Modification to Clause 7
Add the following new sub-clause 7.5:
"7.5 Dangerous substances
National regulations on dangerous substances may require verification and declaration on release, and
sometimes content, when construction products covered by this standard are placed on those markets.
In the absence of European harmonized test methods, verification and declaration on release/content should
be done taking into account national provisions in the place of use.
NOTE An informative database covering European and national provisions on dangerous substances is available at
the Construction web site on EUROPA accessed through: http://ec.europa.eu/enterprise/construction/cpd-ds/"
3 Modification to 9.1
nd
Replace the 2 paragraph and the note with the following:
"Alternative test methods could be used provided that they have been validated in accordance with the
appropriate provisions in the cited standards of the reference test methods. In the event of a dispute, only the
reference methods are used.
NOTE 1 This standard does not deal with acceptance inspection at delivery.
NOTE 2 For certification of constancy of performance by a notified body, conformity of cement with this standard is
evaluated in accordance with EN 197-2.
The compliance of the supersulfated cements with the requirements of this European Standard and with the
stated values (including classes) shall be demonstrated by:
determination of the product type,
factory production control by the manufacturer, including product assessment."
4 Modification to Annex ZA
Replace the entire Annex ZA with the following text:
"
4
---------------------- Page: 6 ----------------------
SIST EN 15743:2010/kFprA1:2014
EN 15743:2010/FprA1:2014 (E)
Annex ZA
(informative)
Clauses of this European Standard addressing the provisions of the
EU Construction Products Regulation
ZA.1 Scope and relevant characteristics
This European Standard has been prepared under Mandate M/114 “Cement, building limes and other
hydraulic binders” given to CEN by the European Commission and the European Free Trade Association.
If this European Standard is cited in the Official Journal of the European Union (OJEU), the clauses of this
standard, shown in this annex, are considered to meet the provisions of the relevant mandate, under the
Regulation (EU) No. 305/2011.
This annex deals with the CE marking of the common cements intended for the uses indicated in Table ZA.1
and shows the relevant clauses applicable.
This annex has the same scope as in Clause 1 of this standard related to the aspects covered by the mandate
and is defined by Table ZA.1.
Table ZA.1 — Relevant clauses
Product: Supersulfated cement
Intended use: Preparation of concrete, mortar, grout etc. (see notes in this table)
Clauses in this and
other European
Regulatory
Essential Characteristics Standard(s) related Notes
classes
to essential
characteristics
Constitutions of the supersulfated cement,
3
defined on the basis of constituent materials and
4
Supersulfated cements composition; selection of supersulfated cement
5
(Subfamilies) constituents None by the Member States in technical regulations for
6
particular intended uses shall be possible, based
and composition
8
on the different cement products and on strength
9
classes
7.1.1
Compressive strength Compressive strength requirements expressed
8
None
in terms of strength classes and limits
(early and standard)
9
7.2.1
Requirements expressed in terms of lower limits
Setting time None
9
7.3
Insoluble residue None Requirements expressed in terms of upper limits
9
7.3
Loss on ignition None Requirements expressed in terms of upper limits
9
7.2.2
Requirements expressed in terms of upper limit
Soundness None
9
7.3 Requirements expressed in terms of lower and
SO content
None
3
9 upper limits
7.3
Requirements expressed in terms of upper limits
Chloride content None
9
7.2.3
Requirements expressed in terms of upper limit
Heat of hydration None
9
4 Durability relates to the concrete, mortar, grout
Durability, sulfate
5 None and other mixes made from cement according to
resistance
7.4 the application rules valid in the place of use
Content and/or release of
7.5 None See 7.5
dangerous substances
5
---------------------- Page: 7 ----------------------
SIST EN 15743:2010/kFprA1:2014
EN 15743:2010/FprA1:2014 (E)
The declaration of the product performance related to certain essential characteristics is not required in those
Member States (MS) where there are no regulatory requirements on these essential characteristics for the
intended use of the product. In this case, manufacturers placing their products on the market of these MS are
not obliged to determine nor declare the performance of their products with regard to these essential
characteristics and the option “No performance determined” (NPD) in the information accompanying the CE
marking and in the declaration of performance (see ZA.3) may be used for those essential characteristics.
ZA.2 Procedure for AVCP of supersulfated cements
ZA.2.1 System of AVCP
The AVCP system
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.