SIST EN 673:1999/A2:2004
(Amendment)Glass in building - Determination of thermal transmittance (U value) - Calculation method
Glass in building - Determination of thermal transmittance (U value) - Calculation method
Changed from ENQ+FV to UAP (CC/011211)
Glas im Bauwesen - Bestimmung des Wärmedurchgangskoeffizenten (U-Wert) - Berechnungsverfahren
Verre dans la construction - Détermination du coefficient de transmission thermique (valeur U) - Méthode de calcul
Steklo v stavbah - Ugotavljanje toplotne prehodnosti (vrednost U) - Računska metoda
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 673:1999/A2:2004
01-september-2004
6WHNORYVWDYEDK8JRWDYOMDQMHWRSORWQHSUHKRGQRVWLYUHGQRVW85DþXQVND
PHWRGD
Glass in building - Determination of thermal transmittance (U value) - Calculation method
Glas im Bauwesen - Bestimmung des Wärmedurchgangskoeffizenten (U-Wert) -
Berechnungsverfahren
Verre dans la construction - Détermination du coefficient de transmission thermique
(valeur U) - Méthode de calcul
Ta slovenski standard je istoveten z: EN 673:1997/A2:2002
ICS:
81.040.20 Steklo v gradbeništvu Glass in building
SIST EN 673:1999/A2:2004 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 673:1999/A2:2004
---------------------- Page: 2 ----------------------
SIST EN 673:1999/A2:2004
EUROPEAN STANDARD
EN 673:1997/A2
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2002
ICS 81.040.20; 91.100.99
English version
Glass in building - Determination of thermal transmittance (U
value) - Calculation method
Verre dans la construction - Détermination du coefficient de Glas im Bauwesen - Bestimmung des
transmission thermique (valeur U) - Méthode de calcul Wärmedurchgangskoeffizenten (U-Wert) -
Berechnungsverfahren
This amendment A2 modifies the European Standard EN 673:1997; it was approved by CEN on 1 November 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cze
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.