SIST EN 62148-1:2004
(Main)Fibre optic active components and devices - Package and interface standards -- Part 1: General and guidance
Fibre optic active components and devices - Package and interface standards -- Part 1: General and guidance
Aims to assure interchangeability in physical interfaces between fibre optic active components and devices supplied by different manufacturers. It defines physical interfaces only, and not performance standards.
Aktive Lichtwellenleiterbauelemente und -geräte - Gehäuse- und Schnittstellennormen -- Teil 1: Allgemeines und Leitfaden
Composants et dispositifs actifs en fibres optiques - Normes de boîtier et d'interface -- Partie 1: Généralités et lignes directrices
Vise à assurer l'interchangeabilité des interfaces physiques entre les composants et dispositifs actifs fournis par différents fabricants. Cette norme définit uniquement les interfaces physiques, et non pas les normes de perfomance.
Aktivne komponente in naprave optičnih vlaken – Standardi oblike in vmesnika– 2. del : SFF MT-RJ 10 kontaktnih oddajnikov in sprejemnikov (IEC 62148-2:2003)*
General Information
Relations
Standards Content (Sample)
SLOVENSKI SIST EN 62148-1:2004
STANDARD
september 2004
Aktivne komponente in naprave optičnih vlaken – Standardi oblike in
vmesnika– 2. del : SFF MT-RJ 10 kontaktnih oddajnikov in sprejemnikov (IEC
62148-2:2003)*
Fibre optic active components and devices - Package and interface standards - Part
2: SFF MT-RJ 10-pin transceivers (IEC 62148-2:2003)
ICS 33.180.20 Referenčna številka
SIST EN 62148-1:2004(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD EN 62148-1
NORME EUROPÉENNE
EUROPÄISCHE NORM April 2002
ICS 33.180.01
English version
Fibre optic active components and devices -
Package and interface standards
Part 1: General and guidance
(IEC 62148-1:2002)
Composants et dispositifs actifs Aktive Lichtwellenleiter-Bauelemente
en fibres optiques - und -Geräte -
Normes de boîtier et d'interface Gehäuse und Schnittstellennorm
Partie 1: Généralités et lignes directrices Teil 1: Allgemeines und Leitfaden
(CEI 62148-1:2002) (IEC 62148-1:2002)
This European Standard was approved by CENELEC on 2002-04-01. CENELEC members are bound to
comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and
notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands,
Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2002 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 62148-1:2002 E
---------------------- Page: 2 ----------------------
EN 62148-1:2002 - 2 -
Foreword
The text of document 86C/384/FDIS, future edition 1 of IEC 62148-1, prepared by SC 86C, Fibre optic
systems and active devices, of IEC TC 86, Fibre optics, was submitted to the IEC-CENELEC parallel
vote and was approved by CENELEC as EN 62148-1 on 2002-04-01.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2003-01-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2005-04-01
This standard forms one of a series under the general title: Fibre optic active coponents and devices -
Package and interface standards. This part 1 of EN 62148 covers general information and includes
references, definitions and rules for creating an interface standard.
Subsequent parts are sequentially numbered and contain standard interfaces for specific active
components and devices. Each part will be added as the interfaces become standardized for
international use.
__________
Endorsement notice
The text of the International Standard IEC 62148-1:2002 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards
indicated:
IEC 60130 (Series) NOTE Harmonized as EN 60130 (Series) (not modified).
IEC 60191 (Series) NOTE Harmonized as EN 60191 (Series) (not modified).
IEC 60603 (Series) NOTE Harmonized as EN 60603 (Series) (not modified).
IEC 60793 (Series) NOTE Harmonized as EN 60793 (Series) (not modified).
IEC 61076 (Series) NOTE Harmonized as EN 61076 (Series) (not modified).
IEC 61300 (Series) NOTE Harmonized as EN 61300 (Series) (not modified).
_________
---------------------- Page: 3 ----------------------
- 3 - EN 62148-1:2002
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of any
of these publications apply to this European Standard only when incorporated in it by amendment or
revision. For undated references the latest edition of the publication referred to applies (including
amendments).
NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant
EN/HD applies.
Publication Year Title EN/HD Year
1)
IEC 60191-1 - Mechanical standardization of --
semiconductor devices
Part 1: Preparation of drawings of
semiconductor devices
IEC 60794 Series Optical fibre cables EN 60794 Series
IEC 61754 Series Fibre optic connector interfaces EN 61754 Series
ISO 1101 1983 Technical drawings - Geometrical--
tolerancing - Tolerancing of form,
orientation, location and run-out -
Generalities, definitions, symbols,
indications on drawings
1)
Undated reference.
---------------------- Page: 4 ----------------------
NORME
CEI
INTERNATIONALE IEC
62148-1
INTERNATIONAL
Première édition
STANDARD
First edition
2002-03
Composants et dispositifs actifs
en fibres optiques –
Normes de boîtier et d'interface –
Partie 1:
Généralités et lignes directrices
Fibre optic active components and devices –
Package and interface standards –
Part 1:
General and guidance
© IEC 2002 Droits de reproduction réservés ⎯ Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
J
Commission Electrotechnique Internationale PRICE CODE
International Electrotechnical Commission
ɆɟɠɞɭɧɚɪɨɞɧɚɹɗɥɟɤɬɪɨɬɟɯɧɢɱɟɫɤɚɹɄɨɦɢɫɫɢɹ
Pour prix, voir catalogue en vigueur
For price, see current catalogue
---------------------- Page: 5 ----------------------
62148-1 © IEC:2002 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC ACTIVE COMPONENTS AND DEVICES –
PACKAGE AND INTERFACE STANDARDS –
Part 1: General and guidance
FOREWORD
1) The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, the IEC publishes International Standards. Their preparation is
entrusted to technical committees; any IEC National Committee interested in the subject dealt with may
participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. The IEC collaborates closely with the International
Organization for Standardization (ISO) in accordance with conditions determined by agreement between the
two organizations.
2) The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an
international consensus of opinion on the relevant subjects since each technical committee has representation
from all interested National Committees.
3) The documents produced have the form of recommendations for international use and are published in the form
of standards, technical specifications, technical reports or guides and they are accepted by the National
Committees in that sense.
4) In order to promote international unification, IEC National Committees undertake to apply IEC International
Standards transparently to the maximum extent possible in their national and regional standards. Any
divergence between the IEC Standard and the corresponding national or regional standard shall be clearly
indicated in the latter.
5) The IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with one of its standards.
6) Attention is drawn to the possibility that some of the elements of this International Standard may be the subject
of patent rights. The IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 62148-1 has been prepared by subcommittee 86C: Fibre optic
systems and active devices, of IEC technical committee 86: Fibre optics.
The text of this standard is based on the following documents:
FDIS Report on voting
86C/384/FDIS 86C/397
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.