SIST EN ISO 17892-12:2018/A1:2021
(Amendment)Geotechnical investigation and testing - Laboratory testing of soil - Part 12: Determination of liquid and plastic limits - Amendment 1 (ISO 17892-12:2018/Amd 1:2021)
Geotechnical investigation and testing - Laboratory testing of soil - Part 12: Determination of liquid and plastic limits - Amendment 1 (ISO 17892-12:2018/Amd 1:2021)
This document specifies methods for the determination of the liquid and plastic limits of a soil. These comprise two of the Atterberg limits for soils.
The liquid limit is the water content at which a soil changes from the liquid to the plastic state.
This document describes the determination of the liquid limit of a specimen of natural soil, or of a specimen of soil from which material larger than about 0,4 mm has been removed. This document describes two methods: the fall cone method and the Casagrande method.
NOTE The fall cone method in this document should not be confused with that of ISO 17892‑6.
The plastic limit of a soil is the water content at which a soil ceases to be plastic when dried further.
The determination of the plastic limit is normally made in conjunction with the determination of the liquid limit. It is recognized that the results of the test are subject to the judgement of the operator, and that some variability in results will occur.
Geotechnische Erkundung und Untersuchung - Laborversuche an Bodenproben - Teil 12: Bestimmung der Fließ- und Ausrollgrenzen (ISO 17892-12:2018/Amd 1:2021)
Diese Internationale Norm legt Verfahren zur Bestimmung der Fließ- und Ausrollgrenze von durchmischten Böden fest. Dies umfasst zwei der Zustandsgrenzen für Böden nach Atterberg.
Die Fließgrenze ist der Wassergehalt, bei dem der Boden vom flüssigen in den plastischen Zustand übergeht.
Dieses Dokument beschreibt die Bestimmung der Fließgrenze an einer Probe von natürlichem Boden oder einer Bodenprobe, bei denen die Körner mit einem Korndurchmesser größer als 0,4 mm entfernt wurden. Dieses Dokument beschreibt zwei Methoden: Die Fallkegelmethode und die Methode von Casagrande.
ANMERKUNG Die Fallkegelmethode in dieser Norm sollte nicht mit der in ISO 19892 6 verwendeten verwechselt werden.
Die Ausrollgrenze ist der Wassergehalt, bei dem der Boden bei weiterer Trocknung aufhört, plastisch zu sein.
Die Bestimmung der Ausrollgrenze erfolgt normalerweise in Verbindung mit der Bestimmung der Fließgrenze. Es wird anerkannt, dass die Ergebnisse der Prüfung dem Urteil des Prüfers unterliegen und dass in den Ergebnissen eine gewisse Variabilität auftreten wird.
Reconnaissance et essais géotechniques - Essais de laboratoire sur les sols - Partie 12: Détermination des limites de liquidité et de plasticité - Amendement 1 (ISO 17892-12:2018/Amd 1:2021)
Le présent document spécifie les méthodes de détermination des limites de liquidité et de plasticité d'un sol. Celles-ci constituent deux des limites d'Atterberg applicables aux sols.
La limite de liquidité est la teneur en eau à laquelle un sol passe de l'état liquide à l'état plastique.
Le présent document décrit la détermination de la limite de liquidité d'un échantillon de sol naturel, ou d'un échantillon de sol duquel les matériaux de dimension supérieure à 0,4 mm ont été retirés. Ce document décrit deux méthodes: la méthode du cône tombant et la méthode de Casagrande.
NOTE La méthode du cône tombant dans ce document ne devrait pas être confondue avec celle de la norme ISO 17892‑6.
La limite de plasticité d'un sol est la teneur en eau à laquelle ce sol cesse d'être plastique lorsque l'on continue à le sécher.
La détermination de la limite de plasticité est normalement faite en parallèle avec celle de la limite de liquidité. Il est reconnu que les résultats de l'essai sont sujets à l'appréciation de l'opérateur, et qu'une certaine dispersion des résultats pourra se produire.
Geotehnično preiskovanje in preskušanje - Laboratorijsko preskušanje zemljin - 12. del: Ugotavljanje meje židkosti in plastičnosti - Dopolnilo A1 (ISO 17892-12:2018/Amd 1:2021)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 17892-12:2018/A1:2021
01-december-2021
Geotehnično preiskovanje in preskušanje - Laboratorijsko preskušanje zemljin -
12. del: Ugotavljanje meje židkosti in plastičnosti - Dopolnilo A1 (ISO 17892-
12:2018/Amd 1:2021)
Geotechnical investigation and testing - Laboratory testing of soil - Part 12:
Determination of liquid and plastic limits - Amendment 1 (ISO 17892-12:2018/Amd
1:2021)
Geotechnische Erkundung und Untersuchung - Laborversuche an Bodenproben - Teil
12: Bestimmung der Fließ- und Ausrollgrenzen (ISO 17892-12:2018/Amd 1:2021)
Reconnaissance et essais géotechniques - Essais de laboratoire sur les sols - Partie 12:
Détermination des limites de liquidité et de plasticité - Amendement 1 (ISO 17892-
12:2018/Amd 1:2021)
Ta slovenski standard je istoveten z: EN ISO 17892-12:2018/A1:2021
ICS:
13.080.20 Fizikalne lastnosti tal Physical properties of soils
93.020 Zemeljska dela. Izkopavanja. Earthworks. Excavations.
Gradnja temeljev. Dela pod Foundation construction.
zemljo Underground works
SIST EN ISO 17892-12:2018/A1:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 17892-12:2018/A1:2021
---------------------- Page: 2 ----------------------
SIST EN ISO 17892-12:2018/A1:2021
EN ISO 17892-
EUROPEAN STANDARD
12:2018/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
September 2021
ICS 13.080.20; 93.020
English Version
Geotechnical investigation and testing - Laboratory testing
of soil - Part 12: Determination of liquid and plastic limits -
Amendment 1 (ISO 17892-12:2018/Amd 1:2021)
Reconnaissance et essais géotechniques - Essais de Geotechnische Erkundung und Untersuchung -
laboratoire sur les sols - Partie 12: Détermination des Laborversuche an Bodenproben - Teil 12: Bestimmung
limites de liquidité et de plasticité - Amendement 1 der Fließ- und Ausrollgrenzen (ISO 17892-
(ISO 17892-12:2018/Amd 1:2021) 12:2018/Amd 1:2021)
This amendment A1 modifies the European Standard EN ISO 17892-12:2018; it was approved by CEN on 21 July 2021.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 17892-12:2018/A1:2021 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 17892-12:2018/A1:2021
EN ISO 17892-12:2018/A1:2021 (E)
Contents Page
European foreword . 3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 17892-12:2018/A1:2021
EN ISO 17892-12:2018/A1:2021 (E)
European foreword
This document (EN ISO 17892-12:2018/A1:2021) has been prepared by Technical Committee ISO/TC
182 "Geotechnics" in collaboration with Technical Committee CEN/TC 341 “Geotechnical Investigation
and Testing” the secretariat of which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by March 2022, and conflicting national standards shall
be withdrawn at the latest by March 2022.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national standards
body/national committee. A complete listing of these bodies can be found on the CEN websites.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this E
...
SLOVENSKI STANDARD
SIST EN ISO 17892-12:2018/oprA1:2021
01-marec-2021
Geotehnično preiskovanje in preskušanje - Laboratorijsko preskušanje zemljin -
12. del: Ugotavljanje meje tekočine in plastičnosti - Dopolnilo A1 (ISO 17892-
12:2018/Damd 1:2021)
Geotechnical investigation and testing - Laboratory testing of soil - Part 12:
Determination of liquid and plastic limits - Amendment 1 (ISO 17892-12:2018/Damd
1:2021)
Geotechnische Erkundung und Untersuchung - Laborversuche an Bodenproben - Teil
12: Bestimmung der Fließ- und Ausrollgrenzen (ISO 17892-12:2018/Damd 1:2021)
Reconnaissance et essais géotechniques - Essais de laboratoire sur les sols - Partie 12:
Détermination des limites de liquidité et de plasticité - Amendement 1 (ISO 17892-
12:2018/Damd 1:2021)
Ta slovenski standard je istoveten z: EN ISO 17892-12:2018/prA1
ICS:
13.080.20 Fizikalne lastnosti tal Physical properties of soils
93.020 Zemeljska dela. Izkopavanja. Earthworks. Excavations.
Gradnja temeljev. Dela pod Foundation construction.
zemljo Underground works
SIST EN ISO 17892-12:2018/oprA1:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 17892-12:2018/oprA1:2021
---------------------- Page: 2 ----------------------
SIST EN ISO 17892-12:2018/oprA1:2021
DRAFT AMENDMENT
ISO 17892-12:2018/DAM 1
ISO/TC 182 Secretariat: BSI
Voting begins on: Voting terminates on:
2021-01-11 2021-04-05
Geotechnical investigation and testing — Laboratory
testing of soil —
Part 12:
Determination of liquid and plastic limits
AMENDMENT 1
Reconnaissance et essais géotechniques — Essais de laboratoire sur les sols —
Partie 12: Détermination des limites de liquidité et de plasticité
AMENDEMENT 1
ICS: 13.080.20; 93.020
THIS DOCUMENT IS A DRAFT CIRCULATED
This document is circulated as received from the committee secretariat.
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
ISO/CEN PARALLEL PROCESSING
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO 17892-12:2018/DAM 1:2021(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
©
PROVIDE SUPPORTING DOCUMENTATION. ISO 2021
---------------------- Page: 3 ----------------------
SIST EN ISO 17892-12:2018/oprA1
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.