SIST-TP CR 13841:2006
(Main)Workplace atmospheres - Scientific basis to describe the influence of the reference period on the presentation of exposure data
Workplace atmospheres - Scientific basis to describe the influence of the reference period on the presentation of exposure data
The aim of this document is to draw the attention on the issue of the reference period of anyone who generates, uses or interprets exposure data.
Zrak na delovnem mestu – Znanstvene podlage za opis vpliva referenčnega obdobja na predstavitev podatkov o izpostavljenosti
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TP CR 13841:2006
01-maj-2006
=UDNQDGHORYQHPPHVWX±=QDQVWYHQHSRGODJH]DRSLVYSOLYDUHIHUHQþQHJD
REGREMDQDSUHGVWDYLWHYSRGDWNRYRL]SRVWDYOMHQRVWL
Workplace atmospheres - Scientific basis to describe the influence of the reference
period on the presentation of exposure data
Ta slovenski standard je istoveten z: CR 13841:2000
ICS:
13.040.30 Kakovost zraka na delovnem Workplace atmospheres
mestu
SIST-TP CR 13841:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TP CR 13841
...
This May Also Interest You
This document specifies flame and electrothermal atomic absorption spectrometric methods for the determination of the time-weighted average mass concentration of particulate lead and lead compounds in workplace air.
These methods are typically applicable to personal sampling of the inhalable fraction of airborne particles, as defined in ISO 7708, and to static (area) sampling. It can be applied to other health-related fractions as required.
The sample dissolution procedure specifies hot plate or microwave assisted digestion, or ultrasonic extraction (see 11.2). The use of an alternative, more vigorous dissolution procedure is necessary when it is desired to extract lead from compounds present in the test atmosphere that are insoluble using the dissolution procedures described herein (see Clause 5).
The flame atomic absorption method is applicable to the determination of masses of approximately 1 µg to 200 µg of lead per sample, without dilution[1]. The electrothermal atomic absorption method is applicable to the determination of masses of approximately 0,01 µg to 0,5 µg of lead per sample, without dilution[1].
The ultrasonic extraction procedure has been validated for the determination of masses of approximately 20 µg to 100 µg of lead per sample, for laboratory-generated lead fume air filter samples[2].
The concentration range for lead in air for which this procedure is applicable is determined in part by the sampling procedure selected by the user (see 10.1).
- Standard37 pagesEnglish languagesale 10% offe-Library read for×1 day
- Standard31 pagesEnglish languagesale 15% off
- Draft37 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies performance requirements and test methods under prescribed laboratory conditions for the evaluation of pumped samplers used in conjunction with an air sampling pump and of procedures using these samplers for the determination of semi-volatile chemical agent in workplace atmospheres. The procedures given in this document provide results only for the sum of airborne particles and vapour. The concentration is calculated in terms of mass per unit volume. This document is applicable to pumped samplers and measuring procedures using these samplers in which sampling and analysis are carried out in separate stages.
- Standard31 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft27 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies performance requirements for battery powered pumps used for personal
sampling of chemical and biological agents in workplace air. It also specifies test methods in order to
determine the performance characteristics of such pumps under prescribed laboratory conditions.
This document is applicable to battery powered pumps having a nominal volumetric flow rate above
10 ml ⋅ min−1, as used with combinations of sampler and collection substrate for sampling of gases,
vapours, dusts, fumes, mists and fibres.
This document is primarily intended for flow-controlled pumps.
- Standard38 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft35 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies performance requirements and test methods under prescribed laboratory conditions for the evaluation of diffusive samplers and of procedures using these samplers for the determination of gases and vapours in workplace atmospheres.
This document is applicable to diffusive samplers and measuring procedures using these samplers in which sampling and analysis are carried out in separate stages.
This document is not applicable to
— diffusive samplers which are used for the direct determination of concentrations,
— diffusive samplers which rely on sorption into a liquid.
This document addresses requirements for method developers and/or manufacturers.
NOTE For the purposes of this document a manufacturer can be any commercial or non-commercial entity.
- Standard48 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft45 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies terms and definitions that are related to the assessment of workplace exposure to chemical and biological agents. These are either general terms or are specific to physical and chemical processes of air sampling, the analytical method or method performance.
The terms included are those that have been identified as being fundamental because their definition is necessary to avoid ambiguity and ensure consistency of use.
- Standard36 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft36 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies general requirements for the use and evaluation of physical and biological performance of volumetric sampling devices applied for assessing bioaerosols in the workplace.
This document lists the criteria for the selection of microbial strains that can be used for the evaluation of biological performance of samplers.
This document also describes a bioaerosol test chamber suited for assessing the biological performance of bioaerosol sampling devices.
This document is not applicable for clean room measurements.
- Standard23 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft23 pagesEnglish languagesale 10% offe-Library read for×1 day
This document specifies methods for the quantitative measurement of airborne endotoxins and gives general requirements for sampling on filters, transportation, storage as well as the analysis of samples.
This document provides also guidelines for the assessment of workplace exposure to airborne endotoxins.
- Standard20 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft19 pagesEnglish languagesale 10% offe-Library read for×1 day
This European Standard specifies general requirements for the performance of procedures for the determination of the concentration of chemical agents in workplace atmospheres as required by the Chemical Agents Directive 98/24/EC. The requirements given apply to all measuring procedures, irrespective of the physical form of the chemical agent (gas, vapour, airborne particles), the sampling method and the analytical method used. This European Standard is applicable to all steps of a measuring procedure,
measuring procedures with separate sampling and analysis steps, and direct-reading devices.
- Standard22 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft23 pagesEnglish languagesale 10% offe-Library read for×1 day
The purpose of this document is to allow users to determine the fine fraction with the calculation
method. It also describes the assumptions and preconditions to be met in order for this method
to be valid. This calculation method is applicable only after experiments have shown that the
results are accurate and consistently equal or higher than the results from sedimentation, as
described in Part 2, for that particular bulk material.
For preparation of the sample and determination of crystalline silica by XRD and FTIR
the users
can refer to Part 1.
An informative annex describes a specific method for the evaluation of the FF recommended for
diatomaceous earth bulk materials. Due to the internal porosity of diatomaceous earth, the
general instructions given in this part of the standard are adapted in order to take into account
the material’s effective density.
This document is applicable for bulk materials that contain particles in the size range from 0,1
μm to 125 μm satisfying with the criteria given in this part and Part 2. The current industrial
minerals within the scope of this method are: quartz, clay, kaolin, talc, feldspar, mica,
cristobalite, vermiculite, diatomaceous earth, barite and andalusite. The method may be
applicable to other bulk materials, following full investigation and validation.
- Standard40 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft37 pagesEnglish languagesale 10% offe-Library read for×1 day
The purpose of this document is to allow users to determine a sizeweighted fine fraction by the
sedimentation method. The method in this part uses a liquid sedimentation technique to
separate the fine fraction, which is then analysed for its substance of interest, e.g. crystalline
silica.
Informative annexes within this document describe specific methods for the evaluation of FF for
specific bulk materials.
This document is applicable for bulk materials that contain particles in the size range from 0,1
μm to 125 μm satisfying with the criteria given in this part and Part 3 of the document series. The
current industrial minerals within the scope of this method are: quartz, clay, kaolin, talc, feldspar,
mica, cristobalite, vermiculite, diatomaceous earth, barite and andalusite. The method may be
applicable to other bulk materials, following full investigation and validation.
- Standard14 pagesEnglish languagesale 10% offe-Library read for×1 day
- Draft13 pagesEnglish languagesale 10% offe-Library read for×1 day
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.