SIST EN ISO 16180:2013
(Main)Small craft - Navigation lights - Installation, placement and visibility (ISO 16180:2013)
Small craft - Navigation lights - Installation, placement and visibility (ISO 16180:2013)
This International Standard specifies requirements and gives guidelines for the placement, installation and visibility of navigation lights as described in COLREG for recreational craft of less than 24 m in length of hull, as described in ISO 8666.
Kleine Wasserfahrzeuge - Positionslaternen - Einbau, Anordnung und Tragweite (ISO 16180:2013)
Diese Internationale Norm legt Anforderungen und Richtlinien für Anordnung und Einbau von Positionslaternen
für kleine Wasserfahrzeuge mit einer Rumpflänge bis 24 m fest, auf welche die COLREGs 72
anzuwenden sind.
ANMERKUNG Andere nationale Vorschriften können zutreffen für Wasserfahrzeuge auf bestimmten Gewässern bzw.
Wasserstraßen.
Petits navires - Feux de navigation - Installation, positionnement et visibilité (ISO 16180:2013)
L'ISO 16180:2013 spécifie des exigences et fournit des lignes directrices relatives au positionnement, à l'installation et à la visibilité des feux de navigation, tels que décrits dans le RIPAM, sur les bateaux de plaisance d'une longueur de coque, tel que décrite dans l'ISO 8666, inférieure ou égale à 24 m. L'annexe A fournit les instructions supplémentaires à inclure dans le manuel du propriétaire.
Mala plovila - Navigacijske luči - Vgradnja, razporeditev in domet (ISO 16180:2013)
V tem mednarodnem standardu so določene zahteve in podane smernice za razporeditev, vgradnjo in domet navigacijskih luči, kot je navedeno v predpisih COLREG za plovila za rekreacijo z dolžino ladijskega trupa manj kot 24 m, kot je opredeljeno v standardu ISO 8666.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 16180:2013
01-junij-2013
0DODSORYLOD1DYLJDFLMVNHOXþL9JUDGQMDUD]SRUHGLWHYLQGRPHW ,62
Small craft - Navigation lights - Installation, placement and visibility (ISO 16180:2013)
Kleine Wasserfahrzeuge - Positionslaternen - Einbau, Anordnung und Tragweite (ISO
16180:2013)
Petits navires - Feux de navigation - Installation, positionnement et visibilité (ISO
16180:2013)
Ta slovenski standard je istoveten z: EN ISO 16180:2013
ICS:
47.020.60 (OHNWULþQDRSUHPDODGLMLQ Electrical equipment of ships
NRQVWUXNFLMQDPRUMX and of marine structures
47.080 ýROQL Small craft
SIST EN ISO 16180:2013 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 16180:2013
---------------------- Page: 2 ----------------------
SIST EN ISO 16180:2013
EUROPEAN STANDARD
EN ISO 16180
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2013
ICS 47.080
English Version
Small craft - Navigation lights - Installation, placement and
visibility (ISO 16180:2013)
Petits navires - Feux de navigation - Installation, Kleine Wasserfahrzeuge - Positionslaternen - Einbau,
positionnement et visibilité (ISO 16180:2013) Anordnung und Tragweite (ISO 16180:2013)
This European Standard was approved by CEN on 12 February 2013.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 16180:2013: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 16180:2013
EN ISO 16180:2013 (E)
Contents Page
Foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 94/25/EC as amended by 2003/44/EC . 4
2
---------------------- Page: 4 ----------------------
SIST EN ISO 16180:2013
EN ISO 16180:2013 (E)
Foreword
This document (EN ISO 16180:2013) has been prepared by Technical Committee ISO/TC 188 "Small craft".
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by September 2013, and conflicting national standards shall be
withdrawn at the latest by September 2013.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive.
For relationship with EU Directive, see informative Annex ZA, which is an integral part of this document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 16180:2013 has been approved by CEN as EN ISO 16180:2013 without any modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 16180:2013
EN ISO 16180:2013 (E)
Annex ZA
(informative)
Relationship between this European Standard and the Essential
Requirements of EU Directive 94/25/EC as amended by 2003/44/EC
This European Standard has been prepared under a mandate given to CEN by the European Commission to
provide one means of conforming to Essential Requirements of the New Approach Directive 94/25/EC as
amended by 2003/44/EC.
Once this standard is cited in the Official Journal of the European Union under that Directive and has been
implemented as a national standard in at least one member state, compliance with the normative clauses of
this standard confers, within the limits of the scope of this standard, a presumption of conformity with the
relevant Essential Requirements of that Directive and associated EFTA regulations.
Table ZA.1 — Correspondence between this European Standard and Directive 94/25/EC
as amended by 2003/44/EC
Clauses/subclauses of this Corresponding annexes/ Comments
European Standard Paragraphs of Directive 94/25/EC
as amended by 2003/44/EC
All clauses. Annex 1A5, Clause 5.7, Navigation This standard corresponds to the
lights. requirements of 1972 COLREGs for
the placement and installation of
navigation lights. The navigation light
units must comply with 72 COLREGs
performance standards. Where
CEVNI regulations are required to be
used other requirements will apply.
Annex A Annex 1A2, Clause 2.5, Owner's
manual.
WARNING — Other requirements and other EU Directives may be applicable to the product(s) falling within
the scope of this standard.
4
---------------------- Page: 6 ----------------------
SIST EN ISO 16180:2013
INTERNATIONAL ISO
STANDARD 16180
First edition
2013-03-01
Small craft — Navigation lights —
Installation, placement and visibility
Petits navires — Feux de navigation — Installation, positionnement
et visibilité
Reference number
ISO 16180:2013(E)
©
ISO 2013
---------------------- Page: 7 ----------------------
SIST EN ISO 16180:2013
ISO 16180:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 16180:2013
ISO 16180:2013(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Placement, installation and visibility of navigation lights. 2
4.1 General . 2
4.2 Placement . 2
4.3 Installation . 3
4.4 Configuration — Minimum visibility and positioning requirements . 3
Annex A (normative) Information and instructions to be included with owner’s manual .9
© ISO 2013 – All rights reserved iii
---------------------- Page: 9 ----------------------
SIST EN ISO 16180:2013
ISO 16180:2013(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International
Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies
casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 16180 was prepared by Technical Committee ISO/TC 188, Small craft.
iv © ISO 2013 – All rights reserved
---------------------- Page: 10 ----------------------
SIST EN ISO 16180:2013
INTERNATIONAL STANDARD ISO 16180:2013(E)
Small craft — Navigation lights — Installation, placement
and visibility
1 Scope
This International Standard specifies requirements and gives guidelines for the placement, installation
and visibility of navigation lights as described in COLREG for recreational craft of less than 24 m in
length of hull, as described in ISO 8666. Annex A lists additional information to be included in the
owner’s manual.
NOTE Other national regulations may apply for craft on certain waters.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 8666, Small craft — Principal data
ISO 10133, Small craft — Electrical systems — Extra-low-voltage d.c. installations
ISO 10240, Small craft — Owner’s manual
ISO 13297, Small craft — Electrical systems — Alternating current installations
The Convention on the International Regulations for Preventing Collisions at Sea, 1972, as amended (COLREG)
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 8666 and the following apply.
3.1
navigation light
coloured source of illumination on recreational craft used to signal a craft’s position, heading, and status
Note 1 to entry: The International Maritime Organization (IMO) has clarified the use of “lantern,” as in “combined
lantern,” and “light,” as in “sidelight,” as being the same. “Light” and “lantern,” in this context, are the same and
interchangeable with the term “navigation light”, and refers to the whole assembly and all of its parts.
3.2
all-round light
unbroken light over an arc of the horizon of 360°
3.3
combination sidelight
single navigation light where sidelights are combined into one lantern showing green to starboard and
red to port from straight ahead to 22,5° abaft the beam (90° + 22, 5° = 112,5°) on their respective sides
carried on the fore and aft centre line
3.4
masthead light
white light placed over the fore and aft centreline showing an unbroken light over an arc of the horizon
of 225°, fixed to show the light from straight ahead to 22,5° abaft the beam (90° + 22,5° = 112,5°) on
either side of the craft
© ISO 2013 – All rights reserved 1
---------------------- Page: 11 ----------------------
SIST EN ISO 16180:2013
ISO 16180:2013(E)
3.5
sidelight
starboard sidelight showing green, and the port sidelight showing red, from straight ahead to 22,5°
abaft the beam (90° + 22,5° = 112,5°) on their respective sides
3.6
stern light
white light placed as close as possible to the st
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.