CECC - CLC CECC TC

This sectional specification applies to F&HICs manufactured as catalogue products or as custom built products using thick film techniques and whose quality is assessed on the basis of qualification approval. It presents preferred values for ratings and characteristics. It selects from CECC 63 000 the appropriate methods of test and gives generam performance requirements, to be used in detail specifications for F&HICs derived from this specification. Passive networks can be qualified to this specification or to alternative specifications, when introduced. For resistor networks, see specification CECC 64 100.

Supersedes CECC 63 101 Issue 1:1984 (with A1).
Superseded by EN 165000 series.
This document remains valid only for existing approvals until further notice * CECC/SC 47AX disbanded

Incorporates work on PR 13726 & 13737 * EN following parallel vote * D115/098: SC 210A disbanded * Superseded by EN 55024:2010

EN following parallel vote * D115/098: SC 210A disbanded * Corrigendum to EN/A1 issued September 2006 (new dow)

The intention of this standard is to establish uniform requirements for the radio disturbance level of the equipment contained in the scope, to fix limits of disturbance, to describe methods of measurement and to standardize operating conditions and interpretation of results.

Defines the immunity test requirements for information technology equipment (ITE, as defined in CISPR 22) in relation to continuous and transient, conducted and radiated disturbances, including electrostatic discharges (ESD). Procedures are defined for the measurement of ITE and limits are specified which are developed for ITE and within the frequency range from 0 Hz to 400GHz.This publication establishes requirements which will provide an adequate level of intrinsic immunity so that the equipment will operate as intended in its environment. The test requirements are specified for each port considered.

New dow * Published under SC 210A disbanded by D115/098 * Superseded by EN 55022:1998

EN following parallel vote * Corrigendum to EN/A1 issued August 1997 (new dow) * Superseded by EN 55022:1998 * Published under SC 210A disbanded by D115/098

This standard applies to ITE as defined in 3.1. Procedures are given for the measurement of the levels of spurious signals generated by the lTE and limits are specified for the frequency range 9 kHz to 400 GHz for both Class A and Class B equipment. No measurements need be performed at frequencies where no limits are specified. The intention of this standard is to establish uniform requirements for the radio disturbance level of the equipment contained in the scope, to fix limits of disturbance, to describe methods of measurement and to standardize operating conditions and interpretation of results.