ASTM D5681-17
(Terminology)Standard Terminology for Waste and Waste Management
Standard Terminology for Waste and Waste Management
SIGNIFICANCE AND USE
3.1 This terminology defines terms and specialized meanings of terms in the subject areas of waste and management of waste.
3.2 This terminology is not intended for subjects other than waste and waste management. For terms applicable to other subject areas, the appropriate terminology standard(s) should be consulted. See the current edition of the Compilation of ASTM Standard Definitions4 and the list of terminology standards cited therein.
3.3 Standards relating to subcategories of waste or waste management may use terms defined more narrowly than those included here. The more specialized terminology standards relating to the applicable specific subcategory, or terms defined within individual standards, or both, should be consulted for the exact meaning intended within a given standard.
3.4 The Thesaurus on Resource Recovery Terminology (Special Technical Publication (STP) 832)5 contains many terms and may be useful for those not listed in terminology standards. However, a definition in a standard terminology shall be considered governing when the term is used in the sense or meaning defined therein.
3.5 Statistical terms are not defined in this terminology to the extent that the terms, when used regarding waste and management of waste, have the same meanings as in Practice E177 or Terminology E456.
3.6 Regulatory terms are often developed by regulatory agencies for special regulatory purposes and may have technical content or meaning different from terms defined herein. When a regulatory term exists that differs in meaning from a term given here, the regulatory term should be considered to take precedence for regulatory matters.
SCOPE
1.1 This terminology contains standard definitions of terms used in the general area of waste and waste management. It is intended to promote understanding by providing precise technical definitions of terms used in the standards developed by Committee D34 and its subcommittees.
1.2 Terms used only within an individual standard, and having a meaning unique to that standard, may be defined or explained in the terminology section of that individual standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
General Information
Relations
Buy Standard
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: D5681 − 17
Standard Terminology for
1
Waste and Waste Management
This standard is issued under the fixed designation D5681; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope D4874 Test Method for Leaching Solid Material in a Col-
umn Apparatus
1.1 This terminology contains standard definitions of terms
D5120 Test Method for Inhibition of Respiration in Micro-
used in the general area of waste and waste management. It is
bial Cultures in theActivated Sludge Process (Withdrawn
intended to promote understanding by providing precise tech-
3
2014)
nical definitions of terms used in the standards developed by
D5231 Test Method for Determination of the Composition
Committee D34 and its subcommittees.
of Unprocessed Municipal Solid Waste
1.2 Terms used only within an individual standard, and
D5285 Test Method for 24-Hour Batch-Type Measurement
having a meaning unique to that standard, may be defined or
of Volatile Organic Sorption by Soils and Sediments
3
explained in the terminology section of that individual stan-
(Withdrawn 2008)
dard.
D5368 Test Methods for Gravimetric Determination ofTotal
1.3 This standard does not purport to address all of the Solvent Extractable Content (TSEC) of Solid Waste
3
safety concerns, if any, associated with its use. It is the
Samples (Withdrawn 2014)
responsibility of the user of this standard to establish appro- D5369 Practice for Extraction of Solid Waste Samples for
priate safety, health and environmental practices and deter-
Chemical Analysis Using Soxhlet Extraction (Withdrawn
3
mine the applicability of regulatory limitations prior to use. 2016)
1.4 This international standard was developed in accor-
D5468 Test Method for Gross Calorific and Ash Value of
3
dance with internationally recognized principles on standard- Waste Materials (Withdrawn 2016)
ization established in the Decision on Principles for the
D5660 Test Method forAssessing the Microbial Detoxifica-
Development of International Standards, Guides and Recom- tion of Chemically Contaminated Water and Soil Using a
mendations issued by the World Trade Organization Technical
Toxicity Test with a Luminescent Marine Bacterium
3
Barriers to Trade (TBT) Committee. (Withdrawn 2014)
D5679 Practice for Sampling Consolidated Solids in Drums
2. Referenced Documents
or Similar Containers
2
D5680 Practice for Sampling Unconsolidated Solids in
2.1 ASTM Standards:
Drums or Similar Containers
D1129 Terminology Relating to Water
D5743 Practice for Sampling Single or Multilayered
D4439 Terminology for Geosynthetics
Liquids, With or Without Solids, in Drums or Similar
D4448 Guide for Sampling Ground-Water Monitoring Wells
Containers
D4547 Guide for Sampling Waste and Soils for Volatile
D5744 Test Method for Laboratory Weathering of Solid
Organic Compounds
Materials Using a Humidity Cell
D4646 Test Method for 24-h Batch-Type Measurement of
D5745 Guide for Developing and Implementing Short-Term
Contaminant Sorption by Soils and Sediments
Measures or Early Actions for Site Remediation
D4790 Terminology ofAromatic Hydrocarbons and Related
D5746 Classification of Environmental Condition of Prop-
Chemicals
erty Area Types for Defense Base Closure and Realign-
ment Facilities
D5759 Guide for Characterization of Coal Fly Ash and
1
This terminology is under the jurisdiction of ASTM Committee D34 on Waste
Management and is the direct responsibility of Subcommittee D34.94 on Terminol- Clean Coal Combustion Fly Ash for Potential Uses
ogy.
D5792 Practice for Generation of Environmental Data Re-
Current edition approved Sept. 1, 2017. Published September 2017. Originally
lated to Waste Management Activities: Development of
approved in 1995. Last previous edition approved in 2016 as D5681 – 16a. DOI:
Data Quality Objectives
10.1520/D5681-17.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or
contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
3
Standards volume information, refer to the standard’s Document Summary page on The last approved version of this historical standard is referenced on
the ASTM website. www.astm.org.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
D5681 − 17
D5956 Guide for Sampling Strategies for Heterogeneous E856 Definitions of Terms and Abbreviations Relating to
Wastes Physical and Chemical Characteristics of Refuse Derived
3
Fuel (Withdrawn 2011)
D6008 PracticeforConductingEnvironmentalBaselineSur-
E868 Test Methods for Conductin
...
This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: D5681 − 16a D5681 − 17
Standard Terminology for
1
Waste and Waste Management
This standard is issued under the fixed designation D5681; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This terminology contains standard definitions of terms used in the general area of waste and waste management. It is
intended to promote understanding by providing precise technical definitions of terms used in the standards developed by
Committee D34 and its subcommittees.
1.2 Terms used only within an individual standard, and having a meaning unique to that standard, may be defined or explained
in the terminology section of that individual standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety safety, health and healthenvironmental practices and determine the
applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization
established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued
by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents
2
2.1 ASTM Standards:
D1129 Terminology Relating to Water
D4439 Terminology for Geosynthetics
D4448 Guide for Sampling Ground-Water Monitoring Wells
D4547 Guide for Sampling Waste and Soils for Volatile Organic Compounds
D4646 Test Method for 24-h Batch-Type Measurement of Contaminant Sorption by Soils and Sediments
D4790 Terminology of Aromatic Hydrocarbons and Related Chemicals
D4874 Test Method for Leaching Solid Material in a Column Apparatus
3
D5120 Test Method for Inhibition of Respiration in Microbial Cultures in the Activated Sludge Process (Withdrawn 2014)
D5231 Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste
D5285 Test Method for 24-Hour Batch-Type Measurement of Volatile Organic Sorption by Soils and Sediments (Withdrawn
3
2008)
D5368 Test Methods for Gravimetric Determination of Total Solvent Extractable Content (TSEC) of Solid Waste Samples
3
(Withdrawn 2014)
3
D5369 Practice for Extraction of Solid Waste Samples for Chemical Analysis Using Soxhlet Extraction (Withdrawn 2016)
3
D5468 Test Method for Gross Calorific and Ash Value of Waste Materials (Withdrawn 2016)
D5660 Test Method for Assessing the Microbial Detoxification of Chemically Contaminated Water and Soil Using a Toxicity
3
Test with a Luminescent Marine Bacterium (Withdrawn 2014)
D5679 Practice for Sampling Consolidated Solids in Drums or Similar Containers
D5680 Practice for Sampling Unconsolidated Solids in Drums or Similar Containers
D5743 Practice for Sampling Single or Multilayered Liquids, With or Without Solids, in Drums or Similar Containers
D5744 Test Method for Laboratory Weathering of Solid Materials Using a Humidity Cell
D5745 Guide for Developing and Implementing Short-Term Measures or Early Actions for Site Remediation
D5746 Classification of Environmental Condition of Property Area Types for Defense Base Closure and Realignment Facilities
1
This terminology is under the jurisdiction of ASTM Committee D34 on Waste Management and is the direct responsibility of Subcommittee D34.94 on Terminology.
Current edition approved Nov. 1, 2016Sept. 1, 2017. Published December 2016September 2017. Originally approved in 1995. Last previous edition approved in 2016 as
D5681 – 16.16a. DOI: 10.1520/D5681-16A.10.1520/D5681-17.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards
volume information, refer to the standard’s Document Summary page on the ASTM website.
3
The last approved version of this historical standard is referenced on www.astm.org.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
D5681 − 17
D5759 Guide for Characterization of Coal Fly Ash and Clean Coal Combustion Fly Ash for Potential Uses
D5792 Practice for Generation of Environmental Data Related to Waste Management Activ
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.