Specification for Materials for Cement Grout Filler for Brick and Stone Block Pavements (Withdrawn 1962)

General Information

Status
Withdrawn
Current Stage
Ref Project

Buy Standard

Technical specification
ASTM D57-20 - Specification for Materials for Cement Grout Filler for Brick and Stone Block Pavements (Withdrawn 1962)
English language
2 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

AMERICAN SOCIETY FOR TESTING MATERIALS
1916 RACE ST., PHILADELPHIA 3, PA.
Reprinted from Copyrighted Book of A';TM Standards, Part 4.
APPROVED AS
AMERICAN STANDARD
BY THE AMERICAN STANDARDS ASSOCIATION
ASA NO.: A37.74-1951
UDC 625.82:691.5
Standard S pecijications for
MATERIALS FOR CEMENT GROUT FILLER FOR BRICK
1
AND STONE BLOCK PAVEMENT
ASTM Designation: D 57 - 20
ADOPTED, 1920.2
This Standard of the American Society for Testing Materials is issued under
the fixed designation D 57; the final number indicates the year of original
adoption as standard or, in the case of revision, the year of last revision.
NoTE-These specifications were editorially revised and
rearranged in 1939.
Scope means of laboratory sieves shall conform
to the following requirements:
1. These specifications cover the ma­
terials (sand, portland cement, and Sieve Percentage
Passing
water) for use in cement grout filler
No. 10 (2000-micron) .• 100
for brick and stone block pavements.
No. 20 (840-micron) not less than .••. 80
No. 200 (74-micron) not more than . 5
SAND
(b) The sieve analysis of the sand
General Characteristics
shall be made in accordance with the
2. The sand shall consist of clean,
Method of Test for Sieve Analysis of
hard, durable stone particles, preferably
Fine and Coarse Aggregates (ASTM
3
siliceous, free from lumps of clay and
Designation: C 136).
objectionable foreign matter.
Mortar Strength
Grading
4. (a) The sand shall be mixed with
3. (a) The sand shall be well graded
portland cement conforming to the re­
from coarse to fine and when tested by
quirements for type I of the Specifica­
tions for Portland Cement (ASTM
I Under the standardization procedure of the
3
Designation: C 150), in the proportion
Society, these specifications are under the juris­
diction of the ASTM Committee D-4 on Road
of 1 part of cement to 3 parts of sand,
and Paving Materials.
3
2 Prior to adop
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.