EN ISO 15085:2003/A2:2018
(Amendment)Small craft - Man-overboard prevention and recovery - Amendment 2 (ISO 15085:2003/Amd 2:2017)
Small craft - Man-overboard prevention and recovery - Amendment 2 (ISO 15085:2003/Amd 2:2017)
Kleine Wasserfahrzeuge - Verhütung von Mann-über-Bord-Unfällen und Bergung - Änderung 2 (ISO 15085:2003/Amd.2:2017)
Petits navires - Prévention des chutes d'homme à la mer et remontée à bord - Amendement 2 (ISO 15085:2003/Amd 2:2017)
Mala plovila - Preprečevanje padca človeka v vodo in reševanje iz nje (zaščita in oprema) - Dopolnilo A2 (ISO 15085:2003/Amd 2:2017)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-julij-2018
0DODSORYLOD3UHSUHþHYDQMHSDGFDþORYHNDYYRGRLQUHãHYDQMHL]QMH ]DãþLWDLQ
RSUHPD 'RSROQLOR$ ,62 $PG
Small craft - Man-overboard prevention and recovery (ISO 15085:2003/Amd 2:2017)
Kleine Wasserfahrzeuge - Verhütung von Mann-über-Bord-Unfällen und Bergung (ISO
15085:2003/Amd 2:2017)
Petits navires - Prévention des chutes d'homme à la mer et remontée à bord (ISO
15085:2003/Amd 2:2017)
Ta slovenski standard je istoveten z: EN ISO 15085:2003/A2:2018
ICS:
13.340.60 =DãþLWDSUHGSDGFLLQ]GUVL Protection against falling and
slipping
47.080 ýROQL Small craft
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN ISO 15085:2003/A2
EUROPEAN STANDARD
NORME EUROPÉENNE
April 2018
EUROPÄISCHE NORM
ICS 47.080
English Version
Small craft - Man-overboard prevention and recovery -
Amendment 2 (ISO 15085:2003/Amd 2:2017)
Petits navires - Prévention des chutes d'homme à la Kleine Wasserfahrzeuge - Verhütung von Mann-über-
mer et remontée à bord - Amendement 2 (ISO Bord-Unfällen und Bergung - Änderung 2 (ISO
15085:2003/Amd 2:2017) 15085:2003/Amd 2:2017)
This amendment A2 modifies the European Standard EN ISO 15085:2003; it was approved by CEN on 15 December 2017.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 15085:2003/A2:2018 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of Directive 2013/53/EU aimed to be covered . 4
European foreword
This document (EN ISO 15085:2003/A2:2018) has been prepared by Technical Committee ISO/TC 188
"Small craft".
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by October 2018, and conflicting national standards shall
be withdrawn at the latest by October 2018.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
Endorsement notice
The text of ISO 15085:2003/Amd 2:2017 has been approved by CEN as EN ISO 15085:2003/A2:2018
without any modification.
Annex ZA
(informative)
Relationship between this European Standard and the Essential
Requirements of Directive 2013/53/EU aimed to be covered
This European standard has been prepared under a Commission’s standardization request
M/542/ C(2015) 8736 final to provide one voluntary means of conforming to Essential Requirements of
Directive 2013/53/EU.
Once this standard is cited in the Official Journal of the European Union under that Directive,
compliance with the normative clauses of this standard given in Table ZA.1 confers, within the limits of
the scope of this standard, a presumption of conformity with the corresponding Essential Requirements
of that Directive and associated EFTA regulations.
Table ZA.1 — Correspondence between this European Standard and Annex I of
Directive 2013/53/EU
Essential Requirements of Clause(s)/subclause(s) of Remarks/Notes
Directive 2013/53/EU this EN
Annex I, Part A, 2.5 – Owner's Clause 17
manual
Annex I, Part A, 2.3 – Protection Clauses 1 to 16
from falling overboard and means
of reboarding
WARNING 1 — Presumption of conformity stays valid only as long as a reference to this European
Standard is maintained in the list published in the Official Journal of the European Union. Users of this
standard should consult frequently the latest list published in the Official Journal of the European
Union.
WARNING 2 — Other Union legislation may be applicable to the product(s) falling within the scope of
this standard.
INTERNATIONAL ISO
STANDARD 15085
First edition
2003-04-01
AMENDMENT 2
2017-12
Small craft — Man-overboard
prevention and recovery
AMENDMENT 2
Petits navires — Prévention des chutes d'homme à la mer et
remontée à bord
AMENDEMENT 2
Reference number
ISO 15085:2003/Amd.2:2017(E)
©
ISO 2017
ISO 15085:2003/Amd.2:2017(E)
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2017 – All rights reserved
ISO 15085:2003/Amd.2:2017(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Par
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.