EN 739:1998/A1:2002
(Amendment)Low-pressure hose assemblies for use with medical gases
Low-pressure hose assemblies for use with medical gases
To amend EN 739 so as to include requirements for use with nitric oxide/nitrogen mixtures
Niederdruck-Schlauchleitungssysteme zur Verwendung mit medizinischen Gasen
Flexibles de raccordement à basse pression pour utilisation avec les gaz médicaux
Ajouter à la liste des gaz médicaux :
"mélanges NO/N2 (NO £ 1 000 µl/l)".
Nizkotlačne povezovalne cevi za delo z medicinskimi plini
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 739:2000/A1:2002
01-november-2002
1L]NRWODþQHSRYH]RYDOQHFHYL]DGHOR]PHGLFLQVNLPLSOLQL
Low-pressure hose assemblies for use with medical gases
Niederdruck-Schlauchleitungssysteme zur Verwendung mit medizinischen Gasen
Flexibles de raccordement a basse pression pour utilisation avec les gaz médicaux
Ta slovenski standard je istoveten z: EN 739:1998/A1:2002
ICS:
11.040.10 Anestezijska, respiratorna in Anaesthetic, respiratory and
reanimacijska oprema reanimation equipment
83.140.40 Gumene cevi Hoses
SIST EN 739:2000/A1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 739:2000/A1:2002
---------------------- Page: 2 ----------------------
SIST EN 739:2000/A1:2002
EUROPEAN STANDARD
EN 739:1998/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2002
ICS 11.040.10; 23.040.70
English version
Low-pressure hose assemblies for use with medical gases
Flexibles de raccordement à basse pression pour utilisation Niederdruck-Schlauchleitungssysteme zur Verwendung mit
avec les gaz médicaux medizinischen Gasen
This amendment A1 modifies the European Standard EN 739:1998; it was approved by CEN on 4 March 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 739:1998/A1:2002 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 739:2000/A1:2002
EN 739:1998/A1:2002 (E)
Foreword
This document (EN 739:1998/A1:2002) has been prepared by Technical Committee CEN/TC 215 "Respiratory and
anaesthetic equipment", the secretariat of which is held by BSI. It has been prepared so as to accommodate the
use of nitric oxide admixed with nitrogen as a medical gas.
This European Standard shall be given the status of a national standard, either by publication of an identical text or
by endorsement, at the latest by October 2002, and conflicting national standards shall be withdrawn at the latest
by October 2002.
This document has been prepared under a mandate given to CEN by the European Commission and the European
Free Trade Association, and supports essential requirements of EU Directive(s).
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard : Austria, Belgium, C
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.